Question about 2006 Peugeot Speedfight 2

Open Question

How do I bleed the cooling system defrost - 2006 Peugeot Speedfight 2

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Bleeding the coolant system 2005 chevy uplander


Bleeding the coolant system Leisa, Check the attached links,instruction and guides on bleeding cooling systems. Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
How To Fill Bleed Coolant Chevy 3 4L V6
Bleeding Air In Cooling System
Coolant Flush How to Chevrolet Uplander 2005 2008 2008 Chevrolet Uplander...
How To Bleed Cooling System EricTheCarGuy


May 21, 2016 | Cars & Trucks

2 Answers

I've eplaced the thermostat on my 2014 HD Ultra Limited. Apparently I was supposed to bleed the cooling system after I refilled it, but I can't find any how-to's on accomplishing that. Any tips?


Remove rad cap while cold start and run engine making sure to keep it full also check for air bleeds along the system usually near tstat or on top most cooling system component

Mar 16, 2016 | Cars & Trucks

1 Answer

02 ford explorer 4.0 overheating and suddenly blowing cold air, then hot again while engine runs cool but not long


Most likely you have air trapped in your engine, particularly in the heater loop. You need to properly bleed the air out of your radiator cooling system. The hot and cold blasts of air coming from first hot water followed by air.
Read up on how to bleed air out of your radiator system. Some systems are very difficult to bleed.
If after doing a good bleed of the radiator system the problem returns, you may have a bad head gasket or other leak in your cooling system which is injecting air into the cooling system (radiator/water cooling system).

Aug 12, 2014 | 2002 Ford Explorer

2 Answers

How do I blead air from kia sedona cooling system


Who said you need to bleed air? Which cooling system? A/C cooling is best left to the mechanics. Your radiator is not a closed system and can be opened to top off and checked periodically. Remember to use a 50/50 mix. Antifreeze and distilled water.

Jan 09, 2014 | 2004 Kia Sedona

1 Answer

Dash vents blowing cool air instead of heat


You have problem in 1) Your air flow system have gone down and some plastic valves that opens to cold position or to hot position is broken. Solution: remove panel and check this plastic valves that controls airflow.
2) Your heat salon radiator is very poor and can't blow in all directions. Solution: replace salon heat radiator.
3) Your cooling system don't have good limit of coolant. Solution: fil it to min - max position.
4) Your cooling system isn't bleeding. Solution: make system without air in it.
Hope this will helps.

Oct 04, 2013 | 2001 Audi TT

1 Answer

Have air in cooling system. How do you bleed air out of cooling system on 2008 cobalt?


best info I can give is take the upper radiator hose loose from the radiator turn he defrost on and let idle the go out to the front and continue to fill radiator with coolant till stay team comes out of hose or invest in a bleeder for 200 $ 9_5_2013_4_56_51_am.jpeg

Sep 04, 2013 | Cars & Trucks

1 Answer

How can I bleed a air pocket on a 95 Toyota Camry do they have a bleeder valve if so where is it located


Air pocket in the cooling system i'm assuming?
Remove radiator cap when the engine has cooled down (verify by collapsing the upper radiator hose to make sure there is no pressure remaining) start the vehicle, turn your climate control to high fan, hottest temp. Add coolant to the radiator as needed. You should have good heat coming out of defrost when the cooling system is successfully bled out.

Jul 19, 2013 | Cars & Trucks

1 Answer

Freezer works fine.. no or barely any cool in fridge. no compressor sound


Good day,
If the freezer is working then there is no issue with the compressor. The cooling is all performed in the freezer with a small amount of freezer air bleed into the fresh food compartment to cool it. All machines are designed this way.

First, check to see if you can hear the fan motor running in the freezer compartment by opening the freezer door while it is running and listening. If you can't hear it, remove the rear panel inspect and replace as needed.
If the fan is O.K. then look on the bottom half of the rear panel in the freezer compartment for a frost buildup. If so, your defrost system has failed.
You will need to remove the back panel and defrost the coils.

The defrost system is made up of 3 components. The main defrost heater, mounted to the bottom of the cooling coil, the defrost thermostat (a small round disk about 1" in diameter) clipped to the top of that same coil and lastly, a defrost control mounted in the roof of the fresh food compartment and can be a timer, electronic defrost control, or a electronic module.
The main heater rarely fails, the last 2 are usually the culprits,
and should be replaced as a pair.

Your problem must be one of the 2 I've listed, unless for some reason the light switch failed in the fresh food section, and the lights stay on all the time.

Below is a good tutorial on defrost systems. Best I can do without a model number and style.

http://www.appliance411.com/faq/howdefrostworks.shtml

Mar 02, 2010 | Frigidaire Refrigerators

2 Answers

Just replaced the water pump.Now i dont have any heat from floor or defrosters. any ideas?


DID U BLEED THE COOOLING SYSTEM, U HAVE AIR IN IT. HERE IS HOW TO BLEED THE SYSTEM OF TRAPPED AIR.

The generic method of bleeding air from the cooling system is to use a floor jack and raise the front of the car as high as poss, then fill the coolant recovery tank full and run the engine until it just starts to overheat, high end of normal zone on gauge, then shut the engine down and run cold water over the radiator core, this will self bleed the system and the coolant will be pulled from the recovery tank, repeat as necessary, never let the recovery tank run dry or more air will be pulled into the cooling systeml

Jan 29, 2010 | 1991 Cadillac DeVille

1 Answer

The car overheats with new radiator and when I turn the heater and air on the needle comes back down to50% or normal. The overflow container is also cracked. 1994 Acura Legend


Change the thermostat and bleed the air out of the cooling system,make sure the cooling fans come on,and go off by themselves,with the defrost,and the ac off.

Jan 29, 2010 | 1994 Acura Legend

Not finding what you are looking for?
2006 Peugeot Speedfight 2 Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Joseph Hoffmann

Level 3 Expert

1702 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Vernon Taylor

Level 3 Expert

2929 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...