Question about 2000 kawasaki KMX 125

1 Answer

On my kmx 125 when i pull the throttle back it just seems to be reving high and not goin anywhere the bike is moving but very slowly i kno it is not the clutch tho as that is working fine i was told it may be the powervalve or kickvalve set at the rong setting or around those lines can anybody help me resolve this problem

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,567 Answers

If the engine is running correctly and the bike has a good clutch then the causes for the lack of forward motion are potentialy: 1) brakes are not releasing fully, 2) a shear pin has sheared on the clutch shaft or on the crankshaft output gear, 3) the output sproket shear pin is sheared, 4) the chain is badly rusted and lacking oil. I would check number 1, then number 4, then have a mechanic check #2 and #3 unless you want to tackle it yourself.

Posted on Mar 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Kawazaki kdx 125 wont start


KICK HARDER TRY PULL STARTING IT..IN SECOND GEAR..DOES IT HAVE ENOUGH COMPRESSION TO START?IT SHOULD START PULLING IT...START OFF WITH NO THROTTLE THAN IF NOT STARTING CRACK THE THROTTLE SO LIGHTLY AND SHE SHOULD FIRE OFF WHILE IN GEAR BEING PULLED OF COURSE BE CARE FUL NOT TO RUN INTO. WHO EVERS PULLING YOU..USE A LONG TOW ROPE..IF YOUR NOT A SEASONDED RIDER AND KNOW YOUR BIKE VERY WELL I WOULD NOT ATTEMPT THE PULL START...IF NOT CHECK YOUR COMPRESSION AND TIMING..MAJOR VACUUM LEAK MAYBE AT BASE GASKET..IS ENGINE SUCKING TO MUCH AIR? GOOD LUCK..

Mar 02, 2013 | kawasaki KDX 125 Motorcycles

2 Answers

Kmx 125


take the cover off the kips and clean it probs sticking

Jul 27, 2012 | 2001 kawasaki KMX 125

1 Answer

Kmx 125 starting problems


The oil seems to be the soft spot on a rather well made bike. Unless you have all the right tools you will never get it all out, which is going to leave deposits on the valve seats and block your spark plugs. I went crazy myself but my mechanic gave me a good deal, now it runs like a dream.

Jan 15, 2012 | kawasaki KMX 125 Motorcycles

1 Answer

Do you have any ideas how to adjust supply of 2t oil that cause too much smoke and oil coming out from exhaust pipe?a newly overhaul kmx 125, 2002 model .


You adjust the oil via the oil pump. The throttle cable splits, one section goes to the carb and the other to the pump, you adjust the play/tension of the wire on the pump, while pulling back the throttle to see if it's aligning properly at full throttle and idle. Two strokes tend to be very smokey so unless the smokes an unusual colour it's usually not a problem. I have a Kmx 125 with a 200cc engine, I prefer running slighty rich on oil, better than running slightly lean! :)

Aug 12, 2011 | 2002 kawasaki KMX 125

1 Answer

How can i wire up a twin lamp conversion to my kawasaki kmx 125 as it has 4 wires coming out but i cant find were to plug them in on the bikes wiring loom


It depends whether its a twin lamp that uses one bulb for low and the other for high beam or both bulbs stay on through low beam and high.

Nov 25, 2010 | 2002 kawasaki KMX 125

2 Answers

.i have 1987 kmx 125 it runs fine but im sure it


If the rattle is coming from the barrel / head area then it may well be a worn piston, worn or damaged bore / rings.
The best way to investigate is to remove the exhaust, get under the bike & shine a torch up into the barrel
Both barrel & piston can be inspected by removing the spark plug & slowly actuating the kick-starter

Ride safe
Bike-Doc
Please mark this as very helpful (if it has been!!)

Apr 27, 2010 | 2000 kawasaki KMX 125

1 Answer

Kmx 125


on carb is a screw the idle screw turn this in 1/4 of a turn with the bike running at a time till it runs at 1000 rpm or 1200rpm db9967d.jpg

Sep 27, 2009 | 2002 kawasaki KMX 125

4 Answers

I would like to have complete wiring diagram for kawasaki kmx 125


http://bikeforum.comxa.com/Forum/motorcycle-owners-manuals/kawasaki-kmx-125-service-manual/

appreciate it if you sign up

Sep 24, 2009 | 2001 kawasaki KMX 125

2 Answers

1988 Kmx 125`hits short flatspot /stutter at 8000 revs


You changed the back pressure in the exhaust and that is what causing your problem either put the washer back in or have the carb properly jetted

Aug 27, 2009 | 2001 kawasaki KMX 125

Not finding what you are looking for?
2000 kawasaki KMX 125 Logo

Related Topics:

238 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4471 Answers

Angelo Stewart
Angelo Stewart

Level 2 Expert

224 Answers

yadayada
yadayada

Level 3 Expert

60541 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...