Question about 2001 Honda CBR 929 RR Fireblade

1 Answer

2001 929 starter not working, big electric/mecanic noise,

My batterie kept getting empty very fast, and now when I try to start it , I hear a big noise next to the baterie , and the elecgtric system restart itself,

Posted by on

  • omar4cathy Mar 31, 2009

    i have 2000 honda cbr 929rr and yesterday it was rain a lot early in the morning and get on her and start right on but the same day afternoon i try to turn on again and start doing clak clak and the light sppeddometer and etc.. is show so low and i put jumping cable for my car to my motorcycle and start on normaly after 5 minute i take out the jumping cable and still on after 5 second its shot off againg


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that has over 10 points.


    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Check the battery voltage with a multimeter, it should read approx. 12 volts. with the meter connected to the battery turn the key to on, turn on brights, turn signal and press brake lever. if goes below 9 volts, charge the battery and try again. if still goes below 9 volts replace the battery. when you get a good battery, start the bike and check charging voltage. should be around 14.7 volts at 5k RPM. if you have low charging voltage, let me know.

Posted on Mar 12, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 1987 yamaha big bear 350 atv. I'm trying to get the electric start working again. i knew the starter clutch was bad so i repaired that. it has a new battery and solinoid. The system wor

Jake, if your ignition is electronic, you may not have enough system voltage to run the starter and the ignition at the same time.
Try with a jump from another vehicle. Likely it will start.
Try bringing the battery to a full and complete charge, water up first,
then retest starting. Some units just have to have a perfect battery and state of charge.

Nov 02, 2012 | Motorcycles

1 Answer

Electric starter will not switch off, unsure why

Sounds like you had to disconnect the battery to stop the starter from spinning.
I've had that happen quite a few times and heres what i found and did to fix the problems.

1. I had an old american bike in the shop with a low battery. I didn't know the battery was
low when i hit the start button. The starter solenoid stayed engaged, and the starter kept
turning over the motor, I pulled the battery terminal off to stop the power to starter.

I check battery and it was low, i put full charge on trickle charge and then let it sit
a 1/2 hour before i tested it with the load tester.
It failed big time, dropped all the way to bottom of the scale under a load test

Installed a new battery and fixed the problem. The solenoid, start button, kill switch, key switch all works, it was just a low battery.

2. I had a customer call me because he ran out of gas, when he got gas he turned the bike over for a long time trying to fill the carburetors with gas,
Never hold the start button down for long periods of time. He did and the wires got so hot that the positive wire from the battery to the solenoid melted and stayed engaged.

It was an easy fix, replace the melted solenoid, and only hold the start button in 5 second intervals, allowing it to cool in between starts.
Once the bowls were full again and the bike starts, then it only takes about a second for the bike to start so you normally dont hold the start button for that long.

Hope this helps
Big Al

Jul 25, 2011 | Aprilia Ulysses XB12 XT Motorcycles

1 Answer

I flooded my big red 300 1996 yesterday going through a river to fast,I keeped on the electric start untill it stop turning over the motor, I then waited for a wile and kick started it and it went fine....

You can kick start it but your electric starter won't kick it in ?
Have you check your main fuse to the starter, starter relay and all realted wirings?
You have fried the starter motor my friend when you keep trying to turn it over until the motor stops.
Well, from what you've described, you started motor have gone to brink, better get a new starter.

Jan 30, 2011 | Honda Xr 250 Tornado Motorcycles

1 Answer

2004 kawasakii vulcan 880 classic doesn't start. kept in garage for a year.trying to jump start using a cable.lights are coming on.when i try to start it makes noise at the battery.not sure if it is do...

the noise you hear is the celinoid it is more then likely do to low voltage replace the battery clean carbs and it should start and run great I would also put fresh gas in it

Jul 29, 2010 | 1995 kawasaki VN 800 A Vulcan

1 Answer

I have trouble starting my scooter, the indicators and brake lights and all that work, but when i try to turn it on using electric start it just makes a humming noise. is this due to my drivebelt being on...

I can't find the a micro phish on but if i where to guess where to start it would be the start clutch or idler gear
Some bike use a sprag clutch it lets it engageone way and free spin the other works great but can get worn out.
Pull your starter out most bikes two bolts and a + wire that comes from your relay. after you have in your hot light hand take a battery and a set of jumper cables clip the groung (-) the body and the positive (+) the to the post. Now clip the ground to the battery and while holding the starter down touch the positive to the battery if you start is working right it should spin fast and want to jump off the table. if so check your starter clutch, or idler gear.

Jan 31, 2010 | 2005 Derbi GPR 125 Racing

1 Answer

Electric starter on handle bar not working but pull start is ok? i hear its a common problem with the 450grizzly

You will need a meter to figure it out.
With the button pushed, you will get 12 volts (or so) to the big wire at the starter motor.
If not, back up to the starter relay, and to the battery, make sure that it has a good charge.
Keep in mind that some of these have a safety not to start without a brake lever pulled in, which is activated by yet another switch.

Dec 11, 2009 | 2004 Yamaha YZ 450 F

1 Answer

93 Suzuki 800 Intruder just quit starting

If it was the relay, you probably wouldn't hear it clicking. you may be able to hold the starter button, and tap on the starter lightly to see if it works.

Aug 11, 2009 | 1999 Suzuki VS 800 Intruder

2 Answers

Electric start not working

i want a speedometer for kymco hipster 125, 03 and handlebars but i cant fine any, could you tell me please.

Mar 06, 2009 | 2003 Kymco Hipster 125

1 Answer

Kick starter does not turn over the motor

There is a gear mecanism that operates the kick starter.
Atteached to this is a stop lock. This is most likely your nemisis. Chances that the gear has brocken are slim.



Mar 02, 2009 | 2000 KTM EXC 380

1 Answer

Dead battery or bad solenoid?

You could be hearing the solenoid or the relay,but it sounds like you have a loose connection if it is clicking fast.

Feb 19, 2009 | 1997 kawasaki VN 1500 Vulcan Classic

Not finding what you are looking for?
2001 Honda CBR 929 RR Fireblade Logo

212 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4507 Answers


Level 3 Expert

66126 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides