SOURCE: replace rear brake pads
Remove right saddlebag, pull the two caliper mounting bolts and remove the caliper. Do not open bleeder or disconnect line. You will need to push a large screwdriver between the old pads before removing them in order to push the pucks back into the caliper or the new pads will not spread enough to reinstall. Then pull the two smaller bolts from the caliper and the pads will fall out. The pads are different for inside and outside, so pay attention, and remember, after reinstalling, before riding, be sure to pump brake pedal, and it may take a few stops before brakes stop as effectively as before.
SOURCE: How do I change the front and rear brakes on a
Not too hard - Undo the two bolts on the caliper and then seperate the caliper and pull the old ones out. Insert the new ones and put the bolts back in to hold the caliper back together and then install them back on the bike with the two retaining bolts. Use a bit of lock tight (Blue) on the threads. Warning do not let anyone apply pressure on the brakes while you have them off the bike or you will have a mess and/or a problem.
SOURCE: 2001 electra glide classic rear shock length
Harley usually uses a 12.5" shock but that could change from model to model and they don't list "shock length" in their specs. The best thing you could do it go to a dealer or find someone that has a stock bike and measure the front end height and rear shock length. Sorry but that's all I got.
Good Luck
Steve
Testimonial: " thank you i have 12.5 long on back now need a front to check thank a lot"
SOURCE: on a 05 electra glide to change the rear brake
They screw out. They should have Torx type heads on them.
Good Luck
Steve
216 views
Usually answered in minutes!
×