Question about 1991 Honda ST 1100 Pan European

2 Answers

To Honda ST1100 experts. Fuel starvation

To Honda ST1100 experts.
I have recently taken my ST out of storage (2years)and have managed to get it started, however it will only run for a few minutes, before dying of fuel starvation. I have replaced the inline fuel filter, but that has not helped. What else should I look for.
Thanks, Michael.

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 98 Answers

The floats are sticking. use good fresh gas with a bottle of carb cleaner should do the trick.

Posted on Mar 08, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 72 Answers

Your carburetors need top be removed from the bike and supmerged in a big pot of yamaha carburetor cleaner . And then blow thew it with air hose (45-75) psi

Posted on Mar 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

On cranking, fuel pours out of carb overflow pipes, is this the petcock valve? Please,


Hi, Wayne start with # 5 and the usual suspects are:
1. Damaged or restricted fuel tank venting system.
2. Loose float bowl screws.
3. Damaged float bowl o-ring.
4. improper fuel level in the float bowl.
5. Worn or dirty inlet valve or seat.
6. Damaged or leaking float assembly.
7. Particle contamination in inlet fitting cavity.
For more information about your issue and valuable "FREE" downloads that you will need please visit the websites. Good luck and have nice a day.
http://www.st-owners.com/forums/archive/index.php/t-83918.html
Carb Removal and Rebuild ST1100
Carbs leaking Here is how to fix it
Honda Pan European ST1100

Apr 25, 2016 | Honda ST 1100 Pan European (cbs-abs met...

1 Answer

St 1100 loose power occasionally and runs uneven what could be the reason ?


Hi, Marthinus the following applies to carbureted also fuel injected models and the usual suspects are:
1. Severely discharged or damaged battery, 9 volts or lower.
2. Failed alternator/generator and or voltage regulator.
3. Loose or corroded battery terminals and or cables especially the "NEGATIVE" cable, look for loose, corroded, or broken connectors inside the cable harness at "BOTH" ends.
4. Failed main circuit breaker or ignition switch, check for loose connections and continuity.
5. Failed system and or ignition relay, check for continuity.
6. Failed ignition coil, ignition/electronic module.
7. Failed CKP, CPS, CMP, MAP, TPS, or BAS sensor, corroded, loose or broken wire connector pins/sockets.
8. Throttle cables and or idle speed improperly adjusted hot idle speed should be 950 RPM to 1000 RPM.
9. Air/fuel mixture screw improperly adjusted.
10. Water or dirt in the fuel system, carburetor or filter.
11. Restricted, blocked or kinked fuel line.
12. Fuel tank empty.
13. Gas cap is not venting properly or fuel tank venting system blocked.
14. A failed fuel pump, pressure regulator and or fuel injectors.
15. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
16. Needle and seat stuck closed in the float bowl.
For more information about your issue and valuable free downloads that you need please visit the websites below. Good luck and have a nice day.
Stalling Recalls
Pan European ST1100 cutout
Honda Pan European ST1100

Feb 14, 2016 | Honda ST 1100 Pan European Motorcycles

1 Answer

Hi need an answer on torque setting for an engine bolt on head cover honda st1100


Cylinder head bolt - 42ft-lb or 57Nm ( use engine oil on the thread surface)
Cylinder had cover bolt - 9ft-lb or 12 Nm

Jun 25, 2011 | 1991 Honda ST 1100 Pan European

1 Answer

Some times the thermostat doesn't open wide ,so the motor temperature becomes too hot and motor can be destroy honda st 1300 is it real that british police stops using ST1300


I should replace the thermostat and check for air locks before you cook your engine.
The UK Police used a few ST1100 bikes but they were too slow and use R1100 BMW mostly now.

Dec 10, 2010 | Honda STX 1300 Pan European Motorcycles

2 Answers

How to lower the st1100


have your local honda dealer do it so that it can be done properly. only other suggestion is to dial up the rear shock preload and lower the fork tubes in the steering stem.

Oct 03, 2009 | 2001 Honda ST 1100 Pan European (cbs-abs...

1 Answer

Put battery on st1100 not a flicker


A new motorcycle battery will not sit for 18 mos and still work unless it has been on a trickle charger all that time...Do yourself a favor and spring 4 a new batt....the one u have wo'nt charge...believe me....good Luck to you friend....Tim

Apr 26, 2009 | 1999 Honda ST 1100 Pan European (cbs-abs...

1 Answer

Honda ST1100, I have difficulty shifting down gears, espessially at low revs after using engine braking. The lever moves freely as if in firsrt but I'll be stuck in third or forth. Up shifting poses no...


You have a couple of bent shift forks. Major work to replace the forks. Time for the Honda dealer to get involved. Sorry.

Please rate this answer. Thanks!

Apr 02, 2009 | 1990 Honda ST 1100 Pan European

Not finding what you are looking for?
1991 Honda ST 1100 Pan European Logo

800 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4481 Answers

yadayada
yadayada

Level 3 Expert

61292 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...