Question about 2004 KTM SX 200

1 Answer

Ktm 50 runs good at first then lacks power

Starts idles great after 5 min or so loses power can shut it off for 5 10 min then restart and runs great for same amount of time also noticed oily liquid blowing out of exhaust where it goes into silencer any help would be great thanks rich

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 3 Answers

Weaken the fuel mixture - is it air cooled? sounds like over heating

Posted on Apr 01, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

'87 Yamaha ProV 50: Will cold start and idle well. After a full throttle 1-2 min run will begin & continue running very rough near idle. Will die without addtl throttle imput.


Hi Roderick:
I'm not familiar with your engine configuration, but on some of the older bikes, vibration eventually can cause a wire to break in the coil. When the engine is cold, the wires make contact and it runs, but as soon as it gets hot, the connection is broken or compromised and the spark quits or drives you crazy.
Since your bike runs when cold and quits when hot, I'd be looking for electrical rather than fuel problems.
Hope this helps.

Sep 09, 2015 | Yamaha Motorcycles

1 Answer

Why does my Kohler 7.3 generator start and runs great for about 5 min. then shuts downRestarts fine but shuts down seconds later. Upon removing rad cap, fluid is seen moving upon warm up. How do I...


change the oil to the correct specification first. As the engine runs the heat changes the viscosity and overheats or trips the oil alert switch. If its over 10 years old change the oil alet magnetic switch

Jun 12, 2014 | Kohler Electrical Supplies

2 Answers

My 2005 wide glide dyes out after about 10 minutes of riding


Thanks Armstrom7
Trying that next. ordered new filters it is starting to dye out even in my drive way now after idling for about 3 minutes. Thanks

May 11, 2014 | Harley Davidson FXDWG Dyna Wide Glide...

1 Answer

1987 Dodge Dakota Sport 3.9L V-6 Runs beautiful for about 10 min then starts cutting out , i have to pull over but it doesnt die. When i pull over and stop the problem seems to go away, get back on th


Well the diesel effect is from the idle speed being too high or a buildup of carbon inside the engine acting as replacement spark plugs.
Can you use starting fluid to find out if the cutting out is from lack of fuel ?

Jan 21, 2014 | Dodge Dakota Cars & Trucks

1 Answer

1994 liberty wagon stops restarts strait away then runs well


Engine stalls or RPM fluctuates at idle.

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve but always run a OBD2 fault code as well as the cleaning procedure. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control


Oct 14, 2012 | Cars & Trucks

1 Answer

1994 f150 6 cyl engine shuts down every 10 min restart after 5 min


Sounds like the module inside the distributor. Have to be replaced.

Sep 29, 2012 | Cars & Trucks

1 Answer

I have Mariner 50 Hp out board motor when it is


check compression? i don't know the year but most mariners need min 100 psi and all cylinders match within 5 psi. check it when its hot. if you have low compression piston skirts are worn. they are responsible for intake and exhaust port timing. rebuild. if you have good compression through all temps check timer base. you'll need a multimeter and resistance specs. clymer manuals are great and can be purchased at your local dealer

Sep 23, 2009 | Boating

1 Answer

2001 VW Eurovan Starts, Runs Rough, Loses Power, OK after Restart


have you tried reseting the computer
disconect the batery and wait 5 mins then re conect the baterie

Aug 06, 2009 | 1997 Volkswagen Golf

2 Answers

1998 gmc 4.3 starts up but loses power 3-5 mins later,will restart and run again for another short time,fuel filter has just been replaced.


Install a pressure gauge, start and run 3-5 minutes and watch the pressure. You should see the pressure maintain as it did when first started. If it begins to drop, the fuel pump has gotten weak and is starting to fail.
Let me know what you find.
Regards.

Mar 05, 2009 | 1998 GMC Sierra

Not finding what you are looking for?
2004 KTM SX 200 Logo

Related Topics:

786 people viewed this question

Ask a Question

Usually answered in minutes!

Top KTM Experts

kevmx2003

Level 2 Expert

86 Answers

yadayada
yadayada

Level 3 Expert

70374 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Are you a KTM Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...