2003 Yamaha YZ 450 F Logo

Related Topics:

A
Anonymous Posted on Apr 04, 2013

My engine oil on my yz 450 is milky - 2003 Yamaha YZ 450 F

5 Related Answers

Anonymous

  • 5 Answers
  • Posted on Mar 05, 2009

SOURCE: I have a yamaha YZ 250 F. The oil has become milky

the most common reason for this to happen is the head gasket has blown resulting in water getting into your oil. not really a big job to fix for a competant mechanic. hope this helps.

Ad

Anonymous

  • 490 Answers
  • Posted on Apr 13, 2009

SOURCE: water leak/mixing with oil

change the seal behind the water pump impeller
the shifter shaft seal will stop leaking
if it continues to mix water and oil you will have to change the head gasket

Anonymous

  • 1167 Answers
  • Posted on Nov 09, 2009

SOURCE: wat kind of coolant is good for a 04 yz 450

1 litre of oil in engine or 1.1 litre of oil if you change oil filter and you drain the oil underneith the engine there will be a plug this just simply comes out and the oil drains but warm the engine first before you do this and i would recccomend using silkolene pro 4 plus 5w-40 and also use silkolene pro cool its ready mix i can get these oils if you reccomend and i can send them to your location

Testimonial: "very good help"

sisadsl

gavin jones

  • 1508 Answers
  • Posted on May 23, 2010

SOURCE: 04 yz 450 backfires and is hard to start when is c...

Runs better with choke means the mixture is lean,
Has the exhaust been changed.?
Did this problem just begin.?
Check for air leaks on intake manifold.
Clean carb.
Check valve clearances
raise the needle jet one notch
one size up in the main jet.

check one item at a time, and write notes about jetting changes.and improvements
I also run Moreys upper cylnder lube, helps starting hot or cold, and helps stop "cough stopping" with heavy rear brake use

Anonymous

  • 185 Answers
  • Posted on Jul 02, 2011

SOURCE: How to check the oil

OK to check oil level you have a little dip stick on the left hand side on the frame of bike just in front of the fuel tank to check this dip stick you need to start the bike and idle only (not rev up or ride) and you idle the motor for 2-3 minutes with the bike in upright position. then turn off motor keep in up right position and remove dip stick - wipe the stick clean then insert dip stick back in its hole (without screwing in) then remove it to see oil levels.
a good quality 20w-40 weight oil (motor bike specific) is a good choice but pretty much any decent oil from your motorcycle shop would be OK just discuss it with them when you purchase it I not sure what country you from but where I live our Yamaha shops sell Yamalube and this is perfect a bit pricey but for our favourate toy, it is worth it!
To fill the oil there is another plug on left hand side again at the front end of the motor you will see it is the only plug there that can be opened with fingers - you will need a funnel to fill cleanly as is pretty difficult to pour into it with out spilling otherwise?
Your bike holds only 1.2 liters (1200ml) of oil in total so if you not changing oil filter and completely emptying then oil lines, only add up to 1 liter for a simple oil dump and refill.
Hint for the day with oil is - On a MX bike the more often you replace the oil the longer it will last before needing repair I would always recommend changing oil either once a month or every 3 hours of riding use which ever comes first !
I am often told I am over cautious with this oil change strategy but I also have YZ450f 05 and a 2003 model and I have never had to rebuild because of break down or fault with motor
Maybe this is coincidental ? but then again - Maybe not ??
good luck hope this helps a little
regards Jamie

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
2answers

2004 YZ 450 F: where is the transmission fill port and leval...

It should be the small plug up near the steering head with the dip stick, you need a small funnel, use only motorcycle oil, car oil can cause clutch slip.They hold about 1.1 litres . you then need to start it for a couple of minutes then check with the dip stick
0helpful
2answers

1999 yz400f leaking milky out of the hose that comes from valve cover what could ot be

All engines have a breather to equalize pressure between the internal crankcase(moving parts, blow by, etc) and the outside air pressure. Heating and cooling of the motor can cause condensation (also stream crossings, rainstorms, mud puddles, etc.)in the motor which will show up in the pollution tube, bottom of the air cleaner, or breather tube as a creamy tan or gray milky liquid. It is normal and nothing to worry about unless you submerged the bike in a stream and filled the engine with water. In this case you need to change the oil immediately and get the moisture out so you don't rust up the motor.
9helpful
4answers

Just need to know where to put oil

Oil filler cap is on the left crankcase cover (engine side cover). This oils both the engine and transmission. Check the oil level on the dipstick located on the upper frame in front of the fuel tank. This should be done after the engine has been run briefly (idle for 1 minute), then kill engine and check.
Online diagram:
http://fiche.worldofpowersports.com/wps/Yamaha_OEM/YamahaDB.asp?Type=13&A=335&B=14

Part # 6 in the diagram.
2helpful
1answer

Wat kind of coolant is good for a 04 yz 450? Engine Ice Collant. acn u also use regular car coolant? How many Qaurts of 4 stroke oil do you put in a yz 450? wat typ is good to use. (example 10-30) where do...

1 litre of oil in engine or 1.1 litre of oil if you change oil filter and you drain the oil underneith the engine there will be a plug this just simply comes out and the oil drains but warm the engine first before you do this and i would recccomend using silkolene pro 4 plus 5w-40 and also use silkolene pro cool its ready mix i can get these oils if you reccomend and i can send them to your location
0helpful
1answer

Getting water in the crank case

if i had to guess at this one the seal behind the impeller on the water pump is bad
Not finding what you are looking for?

1,065 views

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

vince

Level 3 Expert

2530 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1212 Answers

littlewheel

Level 2 Expert

122 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...