Question about 2002 Aprilia RSV Mille R

1 Answer

Dash on v mille r resetting back to factory 6000rpm when starting

Dash seems to freeze for an instant and then resets back to kph and 6000 rpm

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

Common problem on RSV's
Usually related to poor battery condition, It needs to be absolutley tip top condition.
Keep on an optimate, also it's worth upgrading to a battery with higher CCA as the V-Twin compression takes a lot of power to start and kill batteries pretty quick.

Posted on Aug 09, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

3 Answers

The rev counter in my 2000 corolla is reading incorrectly

Macsry2k answer makes the the most trouble shooting sense. Problem is definitely electric. Since the alternator is where the RPM reading comes from, this is the best place to start. Good luck!

Jun 08, 2015 | 2000 Toyota Corolla

1 Answer

Pulsar rpm do not go above 6000

Hi, Anonymous and the usual suspects are:
1. Severely drained or faulty battery.
2. Faulty regulator/rectifier or high output coil.
3. Faulty power valve, solenoid or installation.
4. Clogged air filter or exhaust.
5. Cracked or incorrect float level.
6. Float needle is not seating.
7. Faulty reed valve.
For more information about your question please visit the website below. Good luck and have a nice day.

Feb 03, 2014 | Bajaj Pulsar 150 Motorcycles

1 Answer

My cg100 camera always freezes is this common.

Seems to be quite normal. The manual says on page 133:

If your device freezes or hangs, you may need to close programs or reset the device to regain functionality. If your device is frozen and unresponsive, press and hold the Power button for 6-8 seconds. The device reboots automatically.
If this does not solve the problem, perform a factory data reset. On the Applications screen, tap Settings > Backup and reset > Factory data reset > Reset device > Erase everything.

Jan 09, 2014 | Cameras

1 Answer

1979 cx500 wont go over 5500 RPM.....seems like its governed?

the air flow is change,and changes many other things too.
see also airfilters are clean,good oil frech.hows compretion from cilinder
how are the sparkplugs,whits color do they are good not to low.try to restore to the original.always the can never get any car or bike better then factory.there are many books to find.maybe this one has rpm security contact.

Jul 26, 2012 | 1979 Honda CX 500 A

1 Answer

03 aprilia Mille doesn't start. Sometimes it turns

Hi, Aleksandr and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Bank angle sensor tripped and ignition/light key switch not cycled to the "OFF" position and then back to the "ON" position.
5. Security alarm needs a reset.
6. Starter control circuit, relay, or solenoid faulty.
7. Electric starter shaft pinion gear is not engaging or over-running starter clutch slipping.
For more information about your issue, please visit the websites below. Good luck and have nice a day.
DOWNLOAD 2003 Aprilia Rsv Mille

Aug 15, 2011 | 2003 Aprilia RSV Mille

1 Answer

Just bought a 1993 suzuki gsxr 750. has been sitting in a garage for 2 years. we took the carbs off and cleaned them really well, changed the oil, and air filter and we added new gas. bike starts up and...

If is runs better with full choke, then the bike is lean, check for air leaks at the carb manifold, vacumn cracked hoses, non standard exhausts, perhaps the mufflers have rusted out while sitting

Apr 24, 2011 | 1993 Suzuki GSX-R 750 WP

1 Answer

Kawasaki Z1000 engine doesnt rev more than 5000-6000 rpm, why?

sounds like the cpu is corrupted needs to be re-mapped,  Best to take it in , just ask them to reset it back to default values ,

May 17, 2009 | 2003 kawasaki Z 1000

2 Answers

Rev limit light flashes when reved over 6000 rpm!

No, the rev limiter resets to 6000 rpms when the battery goes dead or is changed. You have to reprogram the rev limiter to allow it to rev to 11,500 or more, but i am sorry to say that i can't recall the sequencevof buttons to reset it, which shold be in your owners manual. This is not an upshift light!

Nov 20, 2008 | 1999 Aprilia RS 250

1 Answer

Turbo cut out, audi a3, 2.0 TDI, registered June 03, UK

Could be low oil level indicator tha auto shuts of engine if oil goes low

Nov 08, 2008 | 1999 Audi A4

1 Answer

Dash freezes at any random time

you can reset the phone to factory default settings by Start>Accessories>Clear Storage. All programs and data installed will be lost.

Mar 17, 2008 | T-Mobile Dash Smartphone

Not finding what you are looking for?
2002 Aprilia RSV Mille R Logo

Related Topics:

293 people viewed this question

Ask a Question

Usually answered in minutes!

Top Aprilia Experts


Level 3 Expert

70346 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Are you an Aprilia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides