Question about 2008 Keeway Matrix 125

1 Answer

The speed never exceeds 45 km/h why is that !?!?! pls tell me something !!!

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

You probably have the factory blockage ( exhaust system )

Posted on Apr 10, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the proper coolant temperature for my 2006 Chevrolet HHR LS 2.2 L? What temperature should the engine cooling fan come on?


The ECM commands the fan on under the following conditions:
• Engine coolant temperature exceeds approximately 106°C (223°F).
• A/C refrigerant pressure exceeds 1302 kPa (189 psi).
• A/C is requested and vehicle speed is below 100 km/h (62 mph) with A/C pressure above 1413 kPa (205 psi).
• AF23-5 Transmission fluid temperature exceeds 130°C (266°F).
• VT25-E Transmission fluid temperature exceeds 140°C (284°F).
• When the engine coolant temperature exceeds 125°C (257°F) at key off, the fan will run for up to 108 seconds.

Nov 21, 2016 | Chevrolet HHR Cars & Trucks

1 Answer

The location of a 2002 chevy cavalier cooling fan sensor


The cooling fan is controlled by the PCM - powertrain control module through a relay ! There is no cooling fan sensor , there is a coolant temperature sensor ! This coolant temperature sensor is an input to the engine computer , if there were a problem wit the sensor the check engine light would be on .
Cooling Fan Control
The engine cooling fan system consists of one cooling fan and one relay. The relay is powered by the battery positive voltage circuit and controlled by a switched ground from the powertrain control module (PCM).
During operation, the PCM supplies the ground path for the cooling fan relay through the cooling fan relay control circuit. This energizes the cooling fan relay coil, closes the relay contacts, and supplies battery positive voltage from the cooling fan fuse through the cooling fan motor supply voltage circuit to the cooling fan. The cooling fan motor is grounded through its own ground circuit.
The PCM commands the fan on under the following conditions:
?€¢
Engine coolant temperature exceeds approximately 106?°C (223?°F).


?€¢
A/C refrigerant pressure exceeds 1310 kPa (190 psi).


?€¢
A/C is requested and vehicle speed is below 100 km/h (62 mph) with A/C pressure above 1413 kPa (205 psi).


?€¢
Vehicle speed is less than 8 km/h (5 mph) for more than 750 seconds. The fan will turn off when vehicle speed is greater than 8 km/h (5 mph) for more than 20 seconds.

Jun 12, 2015 | 2002 Chevrolet Cavalier

1 Answer

How do i set the cruise control on my 1994 mercedes c220 elegance automatic


Cruise Control
Any given speed above approximately 22 mph (35 km/h) can be maintained with the cruise control by operating the lever.
-see photo

  1. Accelerate and set: Lift lever briefly to set speed. Hold lever up to accelerate.
  2. Decelerate and set:
    Depress lever briefly to set speed. Hold lever down to decelerate.
    Normally the vehicle is accelerated to the desired speed with the accelerator. Speed is set by briefly pushing
    the lever to position 1 or 2. The accelerator can be released. The speed can be increased (e.g. for passing)
    by using the accelerator. As soon as the accelerator is released, the previously set speed will be resumed automatically. If a set speed is to be increased or decreased slightly, e.g. to adapt to the traffic flow, hold lever in position 1 or 2 until the desired speed is reached, or briefly tip the control lever in the appropriate direction for increases or decreases in 0.6 mph (1 km/h) increments. When the lever is released, the newly set speed remains.
  3. Canceling
To cancel the cruise control, briefly push lever to position 3.
When you step on the brake or the vehicle speed drops below approx. 22 rnph (35 km/h), for example when driving upgrade, the cruise control will be canceled.
4. Resume
If the lever is briefly pushed to position 4 when driving at a speed exceeding approx. 22 mph (35 km/h), the vehicle resumes the speed which was set prior to the cancellation of the cruise control. The last memorized speed is canceled when the key in the steering lock is turned to position 1 or 0.
Note:
If the engine does not brake the vehicle sufficiently while driving on a downgrade, the speed you set on the cruise control may be exceeded and you may have to step on the brake pedal to slow down.
As soon as the grade eases, the cruise controlled speed will again be maintained as long as the brakes were not previously applied, or the lever may be used to resume the previously set speed if the brakes were applied.

set-cruise-control-1994-mercedes-c220-sufrpujyrsap3pvz3w2boz5j-3-0.jpg
http://www.benzworld.org/forums/attachments/w202-c36-c43/153145d1197313761-pdf-owners-manual-w202-1995-2000-1999-c280_owners_manual.pdf

Feb 14, 2015 | Mercedes-Benz C-Class Cars & Trucks

1 Answer

High oil consummation for subaru 2012


From what you report, the difference from the original 4500Km and the later 14,500KM is 10,000KM. This does match the claim of the new oil. It does seem excessive, but the engine did get more than twice the distance than at the first interval of 4500KM.(2 x 4500KM=9000KM + 1000KM).

You should get a compression test to check for the piston rings and while they do this, they will remove the sparkplugs which could be physically examined. But getting someone to do this will probably require a call to Subaru Corporate Customer Service.

The Corporate people will probably have Data to tell if this oil consumption is higher than normal. The Corporate people would know about all the problems versus 1 Dealer and his experiences.

Somehow I want to say that in the past, new cars had a break-in period for the first 500 Miles, not to exceed 50 MPH. Do not know what that is in Kilometers, but you may have exceeded this in the first 3 days of driving. There are all kinds of theories for break-in periods.

You may benefit from a Browser search for Subaru's like a BLOG for Subaru or Impreza owners.

I hope my solution is helpful.

Jun 17, 2012 | 2012 Subaru Impreza 2.0i 4dr Hatchback...

1 Answer

Still my bike complete 1400 km and first service had done (at the km of 830). I don't know why the engine make noisy sound slightly when i reach out the 40 km speed. i could not able to go ahead of 45 km...


if the sound is commin from engine ... then its a kind of tapped sound.. which can be rectified by mechanic.. or else if the sound is comin from the hind side of vehicle ... then its of chainspocket

Aug 19, 2010 | 2006 Hero Honda Splendor+

2 Answers

Top speed


Officially - 155MPH
With my lardy *** - 139 GPS checked... :)

Nov 20, 2008 | 2005 BMW K 1200 RS

1 Answer

Top speed


Max speed exceeds 250 km/ hr, driven on german autobahn.

Nov 10, 2008 | BMW K 1200 RS Motorcycles

Not finding what you are looking for?
2008 Keeway Matrix 125 Logo

Related Topics:

198 people viewed this question

Ask a Question

Usually answered in minutes!

Top Keeway Experts

yadayada
yadayada

Level 3 Expert

71288 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Ikenye Henry
Ikenye Henry

Level 2 Expert

209 Answers

Are you a Keeway Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...