Question about 2008 kawasaki Ninja 250R

1 Answer

2008 ninja 250 it starts but as u give it gas it stutters and dies i sprayed water on the left exhaust and it not as hot as the right side

Posted by on

  • joe May 11, 2010

    sounds like that bank is not firing. check/replace the spark plug(s) on that side and retry it.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 69 Answers

I would start off by removing the fuel tank, I would then remove the line from the tank to the carbs and lightly and gently blow air from a hose into the carbs, this will free up any dirt or trash that may have gotten into the carbs.

Posted on Mar 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 kawasaki ninja 250 my 2 exhaust pipes get red


That's why sensible people put exhaust pipe shields over their pipes. Buy some soon or burn yourself!

Jan 05, 2013 | 2008 kawasaki Ninja 250R

1 Answer

Why does only 1 exhaust pipe on my ninja 250 get hot


Try unplugging one spark plug at a time and see if the engine will run on just left and just right cylinder. The cylinder thatwont run may have a clogged carburator or the valves may be too tight causing a low/no compression on that cyliner. Also a vacuum leak at an intake boot would cause a lean condition and a hot cylinder. Be certain you have spark at both ( properly gapped) spark plugs before **** these tests.

Oct 28, 2011 | 1989 kawasaki GPX 250 R

1 Answer

2002 ninja 250 idels good runs bad with no power band and sounds like its running on two cylinders but both exhaust pipes get hot,it just doesnt sound like a ninja should,i put new plugs with no change


The power band on a 2002 Ninja 250 does not kick in till you hit about 5000 RPM. The newer 2008 and up 250's kick in about 3000 RPM. There is a website devoted to the Ninja 250 that might give your more background into the motorcycle: ninjette.org You may want to replace your spark plug caps they may be robbing of the spark you need at take off. They simply unscrew off of the end of the wires. They should read 5000 OHM's no higher , no lower. If you purchase new NGK brand plug caps they will only cost about $5 each.

Jun 05, 2011 | 2008 kawasaki Ninja 250R

1 Answer

When i try to start my 03-250 ninja gas pours out of the exhaust


you need a carb clean. your float needle valve assambly is not functioning properly. could be something preventing the float needle from closing all the way.

May 10, 2010 | 2008 kawasaki Ninja 250R

1 Answer

I have a 2010 Kawasaki Ninja 250 and looking at how I can get more power out of it. ( timing - chip - exhaust )


The exhaust is about all you can do and a K&N air filter. Those 250's are tweek pretty much to the limit from the factory.

Jan 31, 2010 | 2008 kawasaki Ninja 250R

1 Answer

Would the fairing parts of a 2006 kawasaki ninja 250 fit a 2005 kawasaki ninja 250?


Yes I do believe they do. Try going to Powersportseast.com Look in the shopping section on the left of the homepage. You will want to use the parts fische and load the info for your bike. It allows you to see what the dealer parts counter can see. See if this helps. I'm pretty sure the 250 ninja really didn't change until 2008 when it got the BIG overhaul

Nov 02, 2009 | 2008 kawasaki Ninja 250R

1 Answer

250 ninja dropped on right side at 0mph. signal broken and scratches around signal. how much to repair?


Go to Powersportseast.com and look up your bike on the Parts Fische. It will give prices and you can order thru them if you want. Signals are the cheap part by a long shot! I have been rebuilding a Salvage 08 250 ninja and have had to replace A LOT on it. The plastics alone are around 250-350. If it is really bad on the plastic try Ebay and wait till you find exactly what you need. The signal is around 40 bucks give or take

Oct 02, 2009 | 2008 kawasaki Ninja 250R

1 Answer

2008 ninja 250 engine oil looks green color


Just replace the oil, its cheap enough to do and costs less than rebuilding the engine.
the white foam on the oil cap is normal its just fine water particals built up, change the oil and take the bike on a run.
so does the bike run fine with the jet kit and exhaust change ? you dont explain your self well.

Jun 21, 2009 | 2008 kawasaki Ninja 250R

Not finding what you are looking for?
2008 kawasaki Ninja 250R Logo

Related Topics:

345 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4471 Answers

Angelo Stewart
Angelo Stewart

Level 2 Expert

224 Answers

yadayada
yadayada

Level 3 Expert

60769 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...