Question about 2003 Yamaha YZF-R6

1 Answer

03yzf it will crank but after a bit on it turns off

The bike will crank but it just wont stay on afterwards

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

Ignition switch is bad

Posted on Mar 04, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Battery voltage drop


Sounds like the starter motor itself. Does the engine turn at all when you try to crank it?

Feb 14, 2014 | Yamaha YZF-R1 Motorcycles

1 Answer

Customer stopperd to refuel the bike and and it wont crank has error code 12 it is a 2008 yamaha raider 1900 replaced the crank sensor cleared the codes and still has a no crank issue if keep trying to...


not enough power in battery, common issue for most street bikes, to save room and weight, they put a battery on em that s well a wee bit just enough to run the machine, but in most cases simply isnt enuff, try jumper cables,, then chase starter selenoid or run stop swithch

Nov 26, 2013 | Motorcycles

1 Answer

05 suzuki m50 wont stay on


Sounds like a pilot screw is missing or your float level is too high possibly the low speed jet fell out? what else was done besides the fuel pump? whatever it is the bottom line is now its getting to much fuel.

Oct 05, 2012 | Suzuki Boulevard M50 Motorcycles

2 Answers

96 bandit, wont start,will turn over but not fire up, have changed plugs, drained carbies, checked for spark, still not firing up, any ideas?


check fuel filter and shut off in float chamber , if you have spark and gas , still not firing check timing .

Mar 18, 2012 | 1996 Suzuki GSF 600 S Bandit

1 Answer

My bike wont start over night


try turning the choke on,which is on the left handle bar next to the grip,leave on ,twist throttle full then close it,press start button,should start,let run for a few mins then turn choke off,

Jul 13, 2010 | 1999 Yamaha YZF-R1

2 Answers

My 95 f3 will crank but wont start. everything was working fine replace a headlight now it wont start with the starter. battery is charged and i can push start it but the engine just cranks and cranks and...


Sounds like a wire or plug got disconnected while changing the headlight out, the harness that connects to the clutch safety switch, the one that lets the ignition fire when cranking only when the clutch is pulled in. A safety feature so you don't dump the bike if you crank it while in gear.

Sep 12, 2009 | 1997 Honda CBR 600 F(3)V

1 Answer

1998 valkrie wont turn over


Your battery is most likely the cause. The tail light and dash light do not draw much juice from the battery. However the headlight and starter are a different story. Are you absolutely sure you turned everything off before you took your break? If you are and you don't ride your bike a lot you should get a trickle charger for it. Use it when not riding. It will prevent you battery from completely losing it's charge thus protecting the battery.
If you do ride often then you should have the battery tested. You may need a new one. Remember that once a battery has been drained too low, permanent damage can occur.

Aug 09, 2009 | 1997 Honda F6 C Valkyrie

1 Answer

R6 hesitation when starting out


Not often i see good questions like this. I would start with riching the carbs a bit. Another possible simple solution is to get your plugs check to make sure they are firing at full capacity, either one can cause the problems you have described. My first guess though would be the carbs, it sounds like the throttle is set a bit off to what it should be at. The fact that your bike runs fine otherwise also suggests this conclusion.

Jun 16, 2009 | 2000 Yamaha YZF-R6

1 Answer

Bike shuts off after downshifting to 1st or 2nd.


The bike wont start for a little bit ????????????
What do you mean.Either it starts or it doesn't.
First of all check the fuel pump.Place the kill switch to "off" position and turn on the key.Put your left hand on the pump (it is under the seat and close to the fuel tank I think.Looks like a drum with 2 pipes on one side and wire on the other end) and then press the kill switch to "on" position.The pump should start pumping for a few sec and then it will stop.
What exactly is a "spudder" that you heard from the exhaust? Like an explosion with a flame (backfire)?
When you crank the engine does it feel like having combustion or it turns like there are no pistons inside?

May 25, 2009 | 1998 Honda CBR 600 F(3)W

Not finding what you are looking for?
2003 Yamaha YZF-R6 Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

mikeuk

Level 2 Expert

61 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1128 Answers

D. E. Hev

Level 3 Expert

1132 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...