Question about 2005 kawasaki KLR 250

1 Answer

Do you have to have a battery on klr250 to get a spark

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 4 Answers

The **** can run without a battery but the lights,horn,signal cooling fan,etc,needs a battery to run properly.

Posted on Apr 25, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 klr250 regulotor test


Does not sound like an H-D bike to me, what is it???

May 24, 2014 | 1979 Harley Davidson XLH 1000 Sportster

1 Answer

Kawasaki klr250 no power


hi there this could be a bad spark plug or the carbie jet blocked or if you have a fuel filter it could be blocked ,if the motor is smoking then may need new rings,at the worst you could have a broken ring which is not letting the piston move properly , hope this helps

Oct 27, 2013 | 2003 Yamaha YZ 250

1 Answer

I replaced the front brake master cylinder and after hours of bleeding I seem to be making no progress, how do I get the front brake to build up pressure and work properly? It's a 1988 KLR250


Two ways of doing this make sure you are using the right brake fluid The bleeder on the calper open up and pull fluid with a fluid pump Get one at auto parts store dont let the master cylinder go dry OR you can fill the calaper through the bleeder and push fluid up to the master cylinder MOPOR KENNY

May 22, 2011 | kawasaki KLR 250 Motorcycles

2 Answers

Wiring diagram for kawasaki klr 250


Hi and welcome to FixYa,
Have you tried here?
Good luck and thank you for asking FixYa.

Aug 14, 2009 | kawasaki KLR 250 Motorcycles

1 Answer

Oil leaking from under the seat of my Kawasaki klr250


not sure if this will help, but the crank case has a breather tube that is around that area. if the bike is on its side or has been doing wheelies, some oil can get thru the breather hose causing that problem.

May 02, 2009 | 2003 kawasaki KLR 250

1 Answer

KLR 250 2003 will not start tried lots please help


Hi, Fatjerry nice novella and the usual suspects are:
1. Fuel tank empty.
2. The fuel tank has old dead gas.
3. Fuel tank bottom contaminated with ethanol sludge, dirt, water, rust, etc.
4. Fuel supply valve/petcock turned off.
5. Fouled spark plugs.
6. Engine flooded as a result of overuse of the enrichner.
7. Vacuum hose to the fuel supply valve/petcock disconnected, broken, cracked, or pinched.
8. Fuel valve/petcock or filter clogged.
9. Fuel line to carburetor or throttle body pinched, kinked or blocked.
10. Carburetor float stuck.
11. Fuel injectors clogged.
12. A severely discharged or damaged battery, you need 12.5 volts or better and be able to pass a load test if necessary.
13. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
14. Loose or corroded wire connection at the coil or plug between ignition sensor and ECM module.
15. Spark plug cables in bad condition and shorting check for spark leakage in the dark, cable connections loose, or connected to the wrong cylinders.
16. Ignition timing incorrect due to a faulty ignition coil, ignition module or MAP, CMP, CKP, O2, TPS, ETP, IAC sensors.
17. Faulty neutral, clutch lever, or kickstand safety switch.
18. Faulty fuel pump or fuse or relay.
19. A stuck bent or burnt valve.
20. Tilt sensor needs a reset.
21. Security system not disarming alarm needs a reset.
22. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
KLR 250 won start
Former KLR250 owners help hard starting Kawasaki Forums
http://mototh.com/files/kawasaki/KLX250/Kawasaki-KLX250-Service-Manual_new.pdf "FREE"
Kawasaki KLR250 service manual repair 1984 2005 KLR 250 Download Manuals... $8
OEM Parts for Kawasaki
klr250ownersmanual pdf

Mar 04, 2017 | 2004 kawasaki KLR 250

3 Answers

Kawasaki klr250


Yeah,it starts. I do the same in mine. Or just use a cloth with fuel on it in the back of the carb,as i did before getting the can of spray starting fluid.Btw,if your bike doesnt want to start cold may be a carb problem(lean mixture) or choke not doing its job.

Mar 06, 2009 | 2003 kawasaki KLR 250

Not finding what you are looking for?
2005 kawasaki KLR 250 Logo

Related Topics:

359 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

70387 Answers

chris

Level 2 Expert

232 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...