Question about 1995 kawasaki ZX-9R Ninja

1 Answer

I need a service book for a zx-9 - 1995 kawasaki ZX-9R Ninja

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

I am pretty sure you can get one for this model at haynes.com, or try clymer

Posted on Feb 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1989 kawasaki zx10 sputters at low rpms. Once it gets to higher rpms, the thing takes off like a bat outta hell. Not nice riding like this in traffic. Any suggestions as to what I need to check?


Hi, Morgan and the usual suspects are:
1. Severely discharged or a damaged battery, should have 12.5 volts or better and be able to pass a load test if necessary.
2. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
3. Spark plugs in bad condition or partially fouled.
4. Spark plug cables in bad condition and leaking.
5. Spark plug gap too close or too wide.
6. Faulty ignition coil, module, and or sensor.
7. Loose, dirty, or corroded ignition module connector at crankcase.
8. Faulty CKP or CMP, MAP, ETS, ATS, TPS, O2 sensor.
9. Intake air leak.
10. Water, dirt, or rust in the fuel system, carburetor and/or filter.
11. Fuel tank vent system plugged or carburetor vent line closed off.
12. Vacuum line from intake manifold to fuel valve is broken, cracked, pinched, or missing.
13. Carburetor controls misadjusted.
14. Damaged carburetor.
15. Incorrect valve timing.
16. Weak or broken valve springs.
17. Damaged intake or exhaust valve.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
zx10 sputtering on low rpms
http://kawasakiworld.com/zx-9r/27328-sputtering-problem.html
http://www.zxforums.com/forums/zx-10r-forum/99185-07-zx-10-sputters-certain-rpms.html
https://www.tradebit.com/filedetail.php/279955038-kawasaki-ninja-zx-10-1988-1990-full-service-repair

Jul 04, 2016 | 1989 kawasaki ZX 10

1 Answer

Will a 94 zx9 gas tank fit on a 99 zx9


the 94 tank is different than the 99 model tank it may fit enough to get out of trouble but if you are buying one it is best to get the right year

Oct 14, 2014 | kawasaki Motorcycles

1 Answer

The motor is over heating fast


i have a 1995 zx-9 kawasaki motorcycle that keep running hot i took off the water pump and it was fine, i need to know what else need to be done

Aug 30, 2010 | 1998 kawasaki ZX-9R Ninja

1 Answer

What are the valve clearance specifications for the 2001 ZX-9?


Hi
Inlet valve clearance 0.15 - 0.24
Exhaust valve clearance 0.22 - 0.31
To be measured with engine cold, preferably left overnight

Ride Safe
Bike-Doc

May 13, 2010 | 2001 kawasaki ZX-9 R Ninja

1 Answer

I need clutch plates positions on a kawasaki zx-9r e1?


they juct sit in the clutch basket, no special way. make sure you use a motorcycle oil , car oils make the clutch slip.

Mar 31, 2010 | 2000 kawasaki ZX-9 R Ninja

1 Answer

I have A 01 ZX-9R that bogs down after 2k rpm. starts and idels fine,and it revs fine with no load. any ideas?


sound like you need to remove and clean the carbs. the main jet partly pluged and the slides could be skicking.

Feb 13, 2010 | 2001 kawasaki ZX-9 R Ninja

1 Answer

Rough idiling


21,000 is a lot of miles for a motorcycle spark plug. Your valves might need adjusted - I don't know if Kawasaki has solids or hydraulic in this model. Your carbs might be in need of adjustment. When was your last tune up? If you don't remember, it is time for a little TLC for the bike, my friend. Your motorcycle is 9 years old now ... it is time for service.

Jan 03, 2010 | 2001 kawasaki ZX-12R

1 Answer

30a fuse


is it inline on the red battery lead?

Mar 22, 2009 | 1999 kawasaki ZX-9R Ninja

Not finding what you are looking for?
1995 kawasaki ZX-9R Ninja Logo

Related Topics:

109 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4471 Answers

Angelo Stewart
Angelo Stewart

Level 2 Expert

224 Answers

yadayada
yadayada

Level 3 Expert

60769 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...