Question about 2002 Honda CR 125 R

2 Answers

Non runner with a new spark plug my cr125 will start but by the time i start to rev the throtle it just dies out .when i remove the plug its covered in fuel .does anyone ha any suggestions plz

Posted by on

  • joe May 11, 2010

    is the choke ON or OFF when you try to rev the throttle?

    is the bike warmed up when you try to rev the throttle?

    if you let it just idle, will it continue to run as long as you don't touch the throttle?

    any fuel leaking out of the overflow tube onto the ground?

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Go to www.2strokeworld.com and look up jetting charts for your bike find the best settings for your environment and riding and try those settings and see if the bike runs better
Note: jetting a 2 stroke is all trial and error and you probably go through quite a few spark plug before you get it locked in but once your jetting is just right it pretty much problem free (but you still have to do basic manteince though it that problem free - sorry) ;) oh one last thing if you DON'T have a service manual for your bike GET ONE!! because your going to need it

Posted on Apr 06, 2013

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

There's a couple things you can try, firstly make sure you've got the fuel to oil mix correct as too much oil in with the fuel is one of the most common reasons for this and also try a standard plug rather than a race plug as these can handle the oily residue a bit better. i would guess at the mix being around 40;1 but check with a honda dealer first. hope this helps

Posted on Mar 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1996 Honda cr125 just got it and the guy I had got it from said it was running one day and it just died on him while riding then never done anything with it. It set for 2 or 3 years now I've got it I...


youve jammed the ratchet.you need to remove the engine casing and reset the mechanism, check the return spring.also you need to set the float level on carb to correct height.to check engine turns over remove spark plug,put in gear and turn back wheel.

Nov 16, 2014 | Motorcycles

2 Answers

Gilera runner 125 st 2008 cuts out by arcing


coil lead plug cap needs replacing , no shield to protect spark plug from getting wet due to weather/water splash. electrical spray lubricant requires from damp start problem

Dec 29, 2012 | 2008 Gilera Runner ST 125

1 Answer

My tomos streetmate r was going full throtle and it started to misfire then the engine died . Wont start and nospark coming out of the sparkplug. whats wrong?


inspect wires for conection n corrosion--coil cud be worn-is it real hot--battery can fail at any time-testit--getta clymer book or other for complete bike work

Aug 20, 2012 | 2008 Tomos Streetmate

2 Answers

Gilera purejet starts revs doesnt really drive


Your carb jets may need a good clean ,also check your air filter it may need changing along with new spark plugs .

Mar 22, 2010 | 2002 Ducati 998 R

3 Answers

I have a gilera runner 50 sp and it wont start


Has it been laid up for months? Did you leave any gas in it untreated? You may need to boil out the gas tank . Try a carb cleaner first that you add to the gas.Check the plugs.Are they black/oily (too rich / worn ring), Tan ( correct ).they tell a lot about the condition of the engine. Good Luck

Sep 15, 2009 | 2005 Gilera Runner VX 125

2 Answers

Gilera runner pure jet starts and ticks over but wont rev


What type of air fillter have u got on if it is an racing filter try putting the orrignal back on and aslo have u tried chaging the sparkk plug

May 27, 2009 | 2002 Ducati 998 R

1 Answer

Cr125 problems with acceleration


Hi,try the stator, may need rewinding.

May 18, 2009 | Honda CR 125 R Motorcycles

2 Answers

1993 blaster wont stay running


try cleaning carb and see if the choke is hung up also make sure it has the right plug ngk b8es

Feb 22, 2009 | 2003 Yamaha YZ 250

1 Answer

Power failure


if the engine is dieing, check that the spark plug has a cap that is sealed eg rubber boot around it.
if the revs are still there but the bike slows the trans belt is getting water in it check the trans gasket for sealing.

Jan 19, 2009 | 2005 Gilera Runner VX 125

Not finding what you are looking for?
2002 Honda CR 125 R Logo

351 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4477 Answers

yadayada
yadayada

Level 3 Expert

61037 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...