Question about 2001 KTM Supermoto 125

1 Answer

1995 kawa. ninja zx-6

I can not find front fairings for my bike anywhere...i would like to buy them pretty cheap if possible. When i say front i mean every fairing on the front end, left, right, top bottom. Where can i find parts like this? is any other year compatable with the 95

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 22 Answers

Check e-bay. call willie cycles 800-334-4045

Posted on Feb 25, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

1995 Kawasaki Ninja 250 will only run with the choke on

you have blocked jets in the carbs,,the carbs need to be removed and cleaned.

Mar 20, 2011 | 1995 kawasaki ZX-9R Ninja

2 Answers

My 2009 Kawa Vulan 500 LTD fires on one cylinder

with the bike being new you wouldn't think it's the spark plugs, but you must remember that those are the first plugs that motor has had in it. the plugs are always supposed to be changed at the first service. try changing them and see what happens.

May 10, 2010 | 1995 kawasaki ZX-6R Ninja

1 Answer

My 2009 Kawa Vulan 500 LTD fires on one cylinder

take a look at you plug wires and cap if they are worn it could cause the spark to short, and yes a sync never hurts.

Mar 18, 2010 | 1995 kawasaki ZX-6R Ninja

1 Answer

Gearshifter shaft is broken how hard to replace on 88 ninja 600

If it is the shaft in the crank case, you will have to pull motor and split the cases. its a pretty big job. Unless you have the tools and shop manual and a lot of patients I would take to a bike shop.
Probably not what you wanted to hear. Sorry

Feb 04, 2010 | 1995 kawasaki ZX-6R Ninja

1 Answer

The best way to remove a carb from a 1994 ninja ZX-6 and the tools required.

Ok you will have to remove the seat and the fuel tank.
You will need metric wrenchs and sockets and a stanard screw driver and a philip head screw driver.
One you have the tank off you will see the carbs. They will be attached to the airbox by some rubber boots that are held on by a clamp. Unscrew then all till loose. You will see more clamps on the front side of the carbs do the samd as the airbox. There will be 2 cables going to the carbs one is the throttle and one is the choke they will need to be disconected. Now what you need to do it pull the carbs out of the rubber intack boots and work them out of the bike.

Nov 24, 2009 | 1995 kawasaki ZX-6R Ninja

1 Answer

Bike wont run

this is very rare. if the engine kill switch is in the same grip, check it , it may be shorting/ loose/ defective. only other possible thing is the starter relay switch

Jun 26, 2009 | 2001 kawasaki ZX-6R Ninja

1 Answer

Is my dented front frame repairable?

No way to tell for sure without someone who straightens frames taking a look at it. I've dealt with Ron at, he will give you an honest opinion.

No, parts are not cheap. Anywhere.

Apr 14, 2009 | 2006 kawasaki ZX-6R

1 Answer

1995 kawa. ninja zx-6 slips in 2nd gear

i think you need to replace the 2nd. gear. most likely you have to rebuilt the trany get a good mechanic because need to take motor out of frame and open the bottom part of the engine.

Feb 23, 2009 | 2001 KTM Supermoto 125

1 Answer

I have a 1995 kawa. ninja zx-6, i bought a new battery and junction box for it. i took the new junction box off because the head light would not turn off, so it is running w the old box and the new...

Hi and welcome to FixYa,

Your description indicates that the battery is not charging when the engine is running. This could be:
  • faulty regulator;
  • loose/corroded connector/terminals at the regulator;
  • loose wire/terminal from the regulator to the battery + terminal;
  • loose battery ground to chassis/harness;
  • loose ground from regulator.
Check and correct based on the above.

Good luck and thank you for using FixYa.

Feb 23, 2009 | 2001 KTM Supermoto 125

Not finding what you are looking for?
2001 KTM Supermoto 125 Logo

Related Topics:

164 people viewed this question

Ask a Question

Usually answered in minutes!

Top KTM Experts


Level 3 Expert

78267 Answers


Level 2 Expert

342 Answers

Steve Banks

Level 2 Expert

232 Answers

Are you a KTM Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides