Question about 2003 Yamaha Road Star Silverado

1 Answer

Bike will not start no power

I have a 2003 roadstar yamaha and through the winter i did not start it i tried and the lights would work etc and the bike would try and turn over but would not start , i bought a new battery and put it on the bike now the buke has no power at all ? the lights wont work etc will do nothing when u turn on the key i have checked the fuses in the side pannel but they are all good is their other fuses like a master fuse some where? i dont understand it was fine before i got a new batery 5 tested 5t and 5ts a g66d batery

Posted by on

  • dc-eakin May 11, 2010

    Was the new battery fully charged before you installed it in the bike? If you got it from Walmart or a similar place, it needed charging prior to installation.

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 292 Answers

Maybe a master 20 or 30 amp on the positive wire from battery

Posted on Mar 22, 2009

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I'm having issues starting my 2003 Yamaha roadstar 1600. I push the start button and it only clicks...I replaced the selinoid and it only clicks. What do I do?


Hi Scott if its clicking its working. Try putting power to the starter direct. If that don't work you need a starter motor. Regards Jim...

Jun 02, 2015 | Yamaha Motorcycles

1 Answer

I have a 1999 Yamaha Roadstar 1600. I ride the bike for minutes or hours and the bike stops running. The bike has no electrical power and wont start leaving me stranded. If i wait a few hours the bike...


Check if the charging system works ok.
At idle with lights off, you should see 13.5-14.5V on battery's terminals and 0.5V less with high beams on, at idle speed as well as at 4000rpm.
Use a fresh good verified battery to take the readings.

Oct 15, 2012 | Yamaha Motorcycles

1 Answer

03 Roadstar Silverado manual choke will not stay out


Hi, Thorn2017 it should have a tension adjuster for this scenario you will need your service/owners manual if you can't find the best tool you ever bought for your Yamaha, despair not, for a mere zero $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
found this helpful answer from motorcycle mechanic on JustAnswer com
Re Bike will not idle with out choke Road Star Forum Yamaha Road Star
Yamaha XV16AL Service Manual
OEM parts for Yamaha
YAMAHA XV1600A Owner Manual

Jun 07, 2010 | 2003 Yamaha Road Star Silverado

2 Answers

2003 yamaha roadstar leak fuel sometimes after I shut it off I think the floats are sticking any solutions. Rick


Yes Rick, try a couple of tricks I know.First,open the carburettor drain screw located at the base of the carburettor,this lets fuel flow out of the carburettor drain located next to/under it.(To acces this drain screw look between the engine cylinders from the LEFT of the bike)While the fuel is draining out,tap the fuel bowl.Next re-tighten the carby drain screw and see how that goes.I would suspect your bike has a vacumatic fuel tap that has 3 positions on it.1 marked on, 1 marked res, 1 marked pri.If the fuel leaks occur when in the on or res position this means part of your problem is a leaking diaphram in the fuel tap.Replace this & when engine isn't running,no fuel can flow to the carby when it's in the on or reserve positions.After ensuring the tap is ok, and trying the first trick,if it still leaks,well then you'll have to pull off the carby and give the needle and seat a clean.
Hope this healps Regards Andy Porrelli

Nov 23, 2009 | 2003 Yamaha Road Star Silverado

2 Answers

Want to change belts on roadstar


If you want to see what the service manual says about it
You can download a free one at
http://www.yamaha-motor-europe.com/community/service/manuals.jsp
Good luck!

Nov 01, 2009 | 2004 Yamaha Road Star

1 Answer

I'm tryig to find the paint code for my 2006 yamaha roadstar XV1700A. It is like a candy red color with black pi8n striping.


The color codes should be in your bike manual.
Google "Color Rite" and follow the prompts to Yamaha model etc. or go direct to www.colorrite.com
Hope this helps.

Sep 04, 2009 | 2006 Yamaha Road Star

2 Answers

I bought a repoed 1700 roadstar and i am tring to remove the drivers seat i have tried everthing any tips the key has wheel lock and seat lock ? I have also tried that no luck. help.


Put the key in the ignition. To lock the steering push the key down and turn the key. To unlock the seat, DON'T push the key down. Instead, just turn the key counter clockwise.

FYI > Go to the site below where you can see a parts diagram for your specific bike. You will select the actual brand, year, model, etc., once you go to the site. www.babbittsonline.com/pages/parts/viewbybrandand/parts.aspx

Top rating for this answer? Thanks!

Jun 10, 2009 | 2006 Yamaha Road Star

2 Answers

Yamaha V-Star 1100 Custom stalls when downshifting


sounds more like a fuel problem to me. is it cold there did you use stabilizer in the gas? try some berrymans B12 in the gas it cleans everything up internally. it worked for me

Mar 18, 2009 | 2001 Yamaha V Star 1100 Classic

1 Answer

Bike will not start no power


Touch a 12" piece of wire to one terminal then touch the other end of the wire to the other terminal. Got a really good spark? No spark = bad battery. Okay, so you do get a good spark. Check the wiring harness for an unplugged wire. Also check for loose connections and burned wires. Bad ignition switch? Kill switch turned on?

Mar 13, 2009 | 2005 Honda CBF 500 ABS

Not finding what you are looking for?
2003 Yamaha Road Star Silverado Logo

441 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1147 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...