Question about 2004 Beta Motard 4.0

1 Answer

Cant get off road tyres for beta supermtard 4.0 2004 rim size

Hi i wondered if u know what other wheel will fit the front ie: from what other bike the forks are by paioli the disc is ng.I can get a tyre for the back.Any advice im desperate info on Beta bikes is very scarce.Many thanks in advance .Martin.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An user who is expert in 3 categories / brands.

  • Beta Master
  • 1,190 Answers

Best way to find a wheel would be go to race meetings and ask around ! take bike with you !! or you mite get a small rear tyre off a junior crosser to fit ! ? .. not really set up for offroad !

Posted on Jan 08, 2014

5 Suggested Answers

  • 2712 Answers

SOURCE: where is my spark

it was given to my dad recently after sitting up for a while. The battery spins the bike over fine but shows a little weak at 12.1 volts. I have ohmed the pulse generators at the 4-pin connector under the tank. They ohm'd a little low at around 430 (I think going from memory here). I don't know if this is too much out of range for them to function properly. I know the spark units are supposedly untestable but I have popped them apart and I'm not seeing ANY DC voltage coming into either of them on ANY wire with key on, or while cranking. Shouldn't these have some sort of voltage coming to them at some time? If not, how else can they function. Also, don't have any voltage to the coils, but I assume this is because the CDI's aren't sending any. The coils ohm fine, and I have connected them to my race car and spun it over, and they are fine. They throw a nice blue flame from both terminals. Any ideas where to go from here? I thought the CDI's may be bad, but not sure at this point. They may be just not getting power for some reason. ,starter!,,,

Posted on Nov 10, 2008

  • 1 Answer

SOURCE: runing lean

air filter for beta eikon

Posted on Mar 04, 2009

  • 867 Answers

SOURCE: does a radiator fan on a beta techno trials bike

it just spins and blows whatever air is there

Posted on Jul 22, 2009

  • 311 Answers

SOURCE: do i have to take the rear wheel out to change the

hi,if it is a disc brake model,you should be able to just unbolt the caliper and slide the caliper off the disc..hope this helps ...cheers

Posted on Apr 01, 2010

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Hi I have a Mazda 6 2013 with after market rims 19x8.5 fitted with Pirelli P 1's cinturato size tyre 245x40x19,what is the correct tyre pressure? Same alround or diffa front and back,original rims factory...

The factory tires said 33 psi. So put 33 psi in all four tires. But if you changed the tires with different tires I would put the psi it says on the tire andthe new tire gives you a different psi than the factory tires I would follow what the tire says check the tire and fill it all up with the same pressure but do t go over the maximum psi you need to be 5 psi below the max.

Feb 20, 2014 | Motorcycles

2 Answers

Handling problem

Check first your tyre pressures are correct. Check tyres are fitted facing the right way round, they normally have arrows showing direction of travel. Did you buy the bike like this or what was done prior to this happening?
Also check wheel spindle bolts on front and rear wheels are correctly tightened. Also check tyres for ballooning(bulges) and any other damage. Also check the tyres are seated on the rim correctly.
This is VERY SERIOUS, DO NOT RIDE the bike without resolving this as it may throw you and your passenger off the bike!!!! If you dont find the problem get professional advice ASAP. Good Luck

Jul 22, 2012 | 2008 Yamaha Royal Star Tour Deluxe

1 Answer

Correct procedure to remove rear tire from 2007 suzuki intruder vl1500.

Do you mean tyre or wheel.? Tyre removal requires the use of a tyre bead breaker and levers and rim protectors, once the tyrehas been broken away from the wheel all around on both sides , start tyre removal with the valve at about 1oclock insert a rim protector followed by a tyre lever and rest it against the rim protector and under the first bead of the tyre, then push the tyre into the middle of the wheel rim at about 6oclock on the rim, and keep it down while yuo push down the tyre lever against the rim pulling the tyre over the rim at the valve end, you will then need to insert another lever close to the ready inserted one to continue pulling the tyre over the rim all the way around untill removed completely, wheel removal on this bike is easy, securing the bike is not, because of the rear fender design you will have to lift the bike high enough to remove the wheel from the rear of the bike once it has been removed from the bike, Remove the securing nut from the r,hand side its a little fiddely unless you remove the exhaust silencers which is probably the best bet, remove the rear caliper and carrier from the bike, pull the wheel spindle from the left side out, it may need a slight. Knock to start from the r,hand side, then the caliper. Carrier can be removed , note order of spacers, and place in a safe place for replacment, from the right grab the wheel with both hands and pull gently untill it is removed from the diff, carefully remove from the frame takeing care not to mark the wheel or other paintwork, and not to dismount the vehicle fro its stand,

Apr 24, 2011 | Suzuki VL 1500 Intruder LC Motorcycles

1 Answer

At low speed about 30-40mph my bike has heavy front woble , only if i take my hands of the bars

first check front tyer is not worn out,,ie have bumps in tred,, and wheel bearings and head race bearings then fork bushes,, then balance road wheel, ,,,if all are in good order,, get a long straight bit of wood and check that it tuches all parts of the road wheels frount and back by holding it on the road wheels this is to check that both road wheels are in a straight line and not pointing in different directions,,,
some bikes dont like some tires,, have you just had new ones fitted,,
a bmw will throw you all over the road if you fit the wrong tires on it,,and it will still play up if there over half worn down too,,

Feb 23, 2010 | 1999 Triumph Trophy 1200

2 Answers

I own a 1991 gsf400 bandit..I have to replace the stock tires with new ones and have a very good deal on the Michelin Power ct2's..the stock tire size is front-110/70/17...and rear-150/70/17....can i...

I suggest you stick with the stock tire size. If you don't, the speedometer will not read correctly. With a smaller tire if the speedo says 65 you will really be doing 55 or so. The actual mileage driven will be off as well. The lower profile tires also do not cushion the rim as well. The spokes are more likely to get out of whack. It is also harder on the brakes since the brake disk is spinning faster to go the same distance as a stock tire would be turning.

Apr 24, 2009 | 1991 Suzuki GSF 400 Bandit

3 Answers

What is the rear tyre size on a zx6r manufactured in1998

The correct tyre size for your 1998 zx6r g model is 170/60/17 the earlyer f model was 160/60/17 and the later j models were 180/60/17

Apr 13, 2009 | 1998 kawasaki ZX-6R Ninja

2 Answers

Diferent size tyres front and back is this normal?

That is normal, most motorcycles run different size front and rear tyres. My BMW has a 21" in the front and a 17" in the rear. The tyre you buy should match your riding style. Don't get a race tyre if all you do is communting, the tyre will wear out too quickly. Expect to pay $150 or so for a rear tyre, perhaps a little less for the front. Mounting & balancing is normally $20-$50 per tyre. Many shops will not mount a tyre you bought somewhere else, keep that in mind if you order tyres from the internet.

Apr 04, 2009 | 1997 Honda CBR 900 RR Fireblade

1 Answer


If you are considering racing in F4 or Buckets on your motoFXR you have a choice of running street tyres (BT39 are great) in the production class or you can fit slicks and run in the Super Bucket class (these are South Island Classes) if you fit slicks on stock FXR rims you need to run tubes inside , the slicks are 95/70-17 fronts and 115/70-17 Rears, same as RS125 GP bikes use, this is not a perfect solution as the rims are slightly narrow and the contact patch on the ground is not optimum. To get a really nice profile on the tyres you can fit some other rims, my bike has RG200 rims and the tyres fit great, GSXR250 rims are good also they have a 2.5” front and 3.0” rear, there is a wee bit of machining to be done at each end as the front bearings don’t fit the fxr axle and the rear disk has to be moved inwards aprox 10mm. Usually the slicks we run on F4 or Buckets are used RS125 tyres which are relatively cheap but sometimes hard to find. A 15hp bike doesn’t exactly eat tyres like a 50hp bike so they last for ages, if they are a bit hard you can borrow a grooving tool and cut some groves in the tyre, this makes them heat up more, also it makes you feel better about riding with slicks in the rain

Nov 10, 2008 | 2001 Suzuki FXR 150

2 Answers

Tyre choice

I found the OEM tyres awful on the road in the wet, and changed them for Metzeler Tourances at around 1000 miles from new. I got Laguna's Maidstone to fit them and they cost @ £130 for the pair. I got standard sizes fitted, ie. 130 rear and 100 front, but the rims will accept a 140 rear and a 110 front so may try that next time. The tourances are excellent on the road, and are more road orientated - but lets be frank here, at 205 kg dry this is basically a Bonneville with frillier knickers - not really an off road tool. I ride in kent and Sussex too, so will keep my eyes open.
All the best

Nov 10, 2008 | 2007 Triumph Triumph Scrambler

1 Answer


Not heard of using one from a different make bike. An option to get you by for now would be a pushbike digital speedo a few on here have used them.,

Nov 10, 2008 | 2003 CCM 604 RS Roadster

Not finding what you are looking for?
2004 Beta Motard 4.0 Logo

Related Topics:

131 people viewed this question

Ask a Question

Usually answered in minutes!

Top Beta Experts

Mark Schmit
Mark Schmit

Level 3 Expert

1915 Answers

Gregg Mahin
Gregg Mahin

Level 3 Expert

34488 Answers

Damian Appert
Damian Appert

Level 2 Expert

112 Answers

Are you a Beta Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides