Question about 2001 Suzuki VL 125 Intruder LC

1 Answer

How do you remove petrol tank from suzuki 125 v twin i am trying to free the choke cable from carburetta end as it is siezed { won;t budge]

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Had the same problem, had to cut the cable and use WD40 and tweezers to free it BUT i'm sure there's a better way.

The Tank is attached to the frame via one bolt under the tank nearest the seat and after you remove the fuel lines the tank lifts up and off, lift seat end up first.

Hope that helped.

Posted on Sep 07, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need to get to the battery on my marauder gz 125 I have unscrewed the side panel but it won't budge


Hi, Enid for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Suzuki, despair not, for a mere zero $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Suzuki GZ125 marauder that won power on at all
2005 Suzuki GZ250 Battery Change am not bike mechanic
Suzuki GZ250 Marauder Service Manual
OEM parts for Suzuki
Suzuki GZ250 Marauder Owner Manual

Feb 15, 2017 | 2003 Suzuki GZ 125 Marauder

1 Answer

How do I replace a choke cable on my suzuki intruder 125 the lever moves fractionally but has no affect on the engine


have you tried adjusting it first where it connects to the handle should be a screw with a round nut on it pull back on this screw nut towards handle to remove is opposite

Sep 07, 2013 | 2001 Suzuki VL 125 Intruder LC

1 Answer

My 2004 gs500 been sitting for 3yrs with fuel in it , run only when the choke is on


When petrol is left for too long, part of the fuel evaporates. Even through a tank. it leaves a sticky residue behind that not only won't burn, but will block up the jets in the carb. First try with new fuel mixed with a fuel additive such as Redex. if the problem is still there, you will need to get the carbs cleaned.

May 06, 2012 | 2004 Suzuki GS 500 E

1 Answer

I have just bought a 1988 vespa px 125 under the seat there is 2 holes one for the petrol and one that says oil ive put 2 stroke oil in the oil tank and petrol in the petrol tank today i hit 50 and the...


older Vespas without separate Oil-tanks need a premix of 1:50 oil in the gasoline - but yours is an automatic oil-mixer type.
check the oil-level-glass under the seat near the choke.
it must be full of oil - the oil tank can hold about 1 liter of 2-stroke oil. How much oil did you fill in?
Probably the previous owner removed the oil supply tube and filled always an oil-gasoline premix. You better ask him about it. If the tube was removed then there was no oil supplied to your engine and it got stuck and the engine bearings are blown.
just-bought-1988-vespa-px-125-under-izfz13drzoohgdeabm1v24gu-3-0.jpg

just-bought-1988-vespa-px-125-under-izfz13drzoohgdeabm1v24gu-3-2.jpg

just-bought-1988-vespa-px-125-under-izfz13drzoohgdeabm1v24gu-3-5.jpg

Apr 07, 2012 | 2011 Vespa GTS 125

1 Answer

I have a suzuki gz 125 marauder 07 model couple of weeks ago it started to sound rough like it was struggling to get petrol or air it then started to hesitate and **** in 3rd or 4th gear doing...


Hi, Kayclarke198 and the usual suspects are:
1. Severely discharged or a damaged battery, should have 12.5 volts or better and be able to pass a "LOAD" test if necessary, your battery may show 12.5 volts but have little or zero amps and needs to be replaced.
2. Failed alternator/generator and or voltage regulator.
3. Loose or corroded battery terminals and or cables especially the "NEGATIVE" cable, look for loose, corroded, or broken connectors inside the cable harness at "BOTH" ends.
4. Failed main circuit breaker or ignition switch, check for loose connections and continuity.
5. Failed system and or ignition relay, check for continuity.
6. Failed ignition coil, stator, magneto, points/condenser ignition/electronic module.
7. Failed CKP, CPS, CMP, MAP, TPS, or BAS sensor, corroded, loose or broken wire connector pins/sockets.
8. Throttle cables and or idle speed improperly adjusted hot idle speed should be 950 RPM to 1000 RPM.
9. Air/fuel mixture screw improperly adjusted.
10. Accelerator pump damaged or not working.
11. Water or dirt in the fuel system, carburetor or filter.
12. Restricted, blocked or kinked fuel line.
13. Fuel tank empty.
14. Fuel tank contaminated with ethanol sludge.
15. The gas cap is not venting properly or fuel tank venting system blocked.
16. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
17. Needle and seat stuck closed in the float bowl.
For more information about your issue and valuable "FREE" downloads that you need please click on the blue links below. Good luck and have a wonderful day.
Suzuki Marauder GZ125 spluttering cutting out
Marauder 125 starting running problems
43results for suzuki gz marauder 125 manual $15
Suzuki GZ250 Marauder Service Manual FREE
OEM parts for Suzuki
Suzuki GZ250 Marauder Owner Manual

Mar 28, 2017 | Suzuki GZ 125 Marauder Motorcycles

1 Answer

Chock stuck open


hi most likely the cable is corroded, remove the cable bar end first then unclip from carb end easy job if the cabe is seized the choke will return to its resting position, in this case replace cable, or free off and lubricate old cable.paul

Jan 04, 2011 | 2001 Suzuki GSX 750 F (Katana)

3 Answers

Suzuki gp 125 1981 dont want to start


Make sure you have ignition spark and just wer yhe tip of the plug with gas. Puttting gas in the cylinder is too rich and will add to you problem. Good Luck

May 28, 2010 | 2003 Suzuki RM 125

1 Answer

Motorbike will not start


before you stored it for the 3 months did you drain the carbs and petrol tank... if you havent then your probably right to think that fuel isnt flowing to the engine.. overtime petrol additives eveporate leaving a gunky residue in the float bowls of the carbs and clogging up the jets... so drain all the old fuel, clean the carbs and hopefully that should get you back on the road

Feb 01, 2010 | 1996 Suzuki GSX-R 750 T

1 Answer

THE CHOKE OF MY SUZUKI 2004 Z250 HAS TO BE ON IN ORDER TO USE IT. WHAT WRONG?


If choke is needed it must be starving for petrol check there are no kinks in fuel line an also check and replace petrol filter check if you have a tap on tank (properly not) there may be a filter behind tap clean it.

Jan 10, 2010 | 2004 Suzuki RM-Z 250

1 Answer

How to change throttle cable on 2005 rm 125


The carburator end...you will need to remove the seat and gas tank.The top of the carb will turn off counter clockwise, then you can pull the "slide" up out of the carburator. Note which is the front for re-assemble. There is a spring between the slide and cap, and look into the slide to see if your cable clips in, or may have a phillips screw and plate to remove to get the cable free. I use needle nose pliers to hold the spring back to remove and replace the cable.
The throttle end is easier. Remove the plastic cap and unthread the adjusting worm nut. The cable end "ball" will come out with the help of needle nose pliers also. Pull the cable slack up to rotate the "ball" out of the throttle tube.
Hope this helps!

Jul 19, 2009 | 2003 Suzuki RM 125

Not finding what you are looking for?
2001 Suzuki VL 125 Intruder LC Logo

270 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

Richard
Richard

Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...