Question about 2007 Bajaj Pulsar 150

1 Answer

Pulsar's smoothness changes after few kms

I hav purchased pulsar150cc 2008 nov and it had jus did 1200 kms and the bike is smooth and silent when cold start but after it runs for 2-3kms its smotheness goes off when ever i take my bike i use minim of 15kms after 8-9 kms it starts roaring or vibrating some sort of un-comfortness i feel and rarely i go top speed of 75 normally i hang up within 55-65 in highways wats the prob in my bike? and now i have planned to give 4 second service...

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 68 Answers

Ok so its a brand new bike.. though the engine comes with proper boring nowdays but still you shold maintain low speeds  initially as  they are bits which take time to settle. did you ever meet an accident?? this may be a handling problem too..,may be the bike is disbalanced. get it checked in the service centre only.. Hope it works..:))

Posted on Mar 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a Bajaj Pulsar 150cc bought in 2007. I regularly give bike for servicing and the running is smooth and in good condition. Suddenly from last month, whenever my bike gets wet in the rain for some...


Start at you battery and work back towards your ignition inspecting each and every harness connector...disconnect, clean with electric contact cleaner, apply a small amount of dielectric grease and reconnect, even the connectors under the seat. Take your time and it will be worth the effort. Check all the grounds too.

Jul 22, 2011 | 2007 Bajaj Pulsar 150

2 Answers

I have bajaj pulsar which has run 40000 kms...and now suddenky i have a prob..my bike after travelling few KMS suddenly stops and doesnt start for next 10 -15min..and then suddenly starts again..and this...


check ur engine head and clear the head or piston and valve,then clean carburetor and air filter.and then the problem is still change ur starting coil or cdi. thank u.

Jun 28, 2011 | 2005 Bajaj Pulsar 150

1 Answer

2008 1200 custom runs rich on intial start up than has a rough idle . performance is good after warmup can i retune to smooth out the idle when warm .


check the fittings at the cold start lever on the carb,it might need ajusting,if air filter is chocked it will run rough,

Jul 01, 2010 | 2000 Harley Davidson XL 1200 C Sportster...

2 Answers

Which type of engine oil should i use in my Pulsar 150?


I have been using Castrol Active (Grade - 20 W 40) in this bike and have never faced any problems. Do not use the Castrol Power 1. Also get the engine oil changed after every 2500 kms. (get it replaced after 500 - 600 kms during the 1st service and after that change every 2500 kms)

Sep 19, 2009 | 2007 Bajaj Pulsar 180

1 Answer

My bike has a very low pick up compared to other bikes.acceleration of the bike is not at all smooth.sound of the engine is also different from other pulsars.i replaced the clutch plates,but there is no...


With respect to your discription of the problem , it would be worth to check the timing of the bike's engine. It could be ******!
Hope this helps!

Aug 08, 2009 | 2006 Bajaj Pulsar 150

1 Answer

My bike has a very low pick up compared to other bikes.acceleration of the bike is not at all smooth.sound of the engine is also different from other pulsars.i replaced the clutch plates,but there is no...


service your carb, change the plug and airfilter and check you timing and compression.These are simple things that will improve your performance ...but changing your clutch plates?Is your clutch slipping?

Aug 08, 2009 | 2005 Bajaj Pulsar 150

2 Answers

No pick up :(


Actually I too had the same problem when i bought the new pulsar in 2007 dec, For the first 4 months i struggled a lot because of this low pick up problem, I had given my bike for the Show room services 3 times in 4 months,Every time they will be Tighthing the cluth & applying greece over the grooves, but it does'nt worked up & my bike was reaching only 80 km(maximum) after giving the high throttle for long time... and the mileage would be 23 Km,,,But i went for the service out side the company few guys told it would be the Piston shaft problem,, few guys asked me to change the Clutch plate,,, One Mechanic Just lubricated my clutck plates(serviced it Just released the jam Clutch plates) Now 1 and half year gone it is giving the Mileage of 52 Kms,And the maximum speed 113(which I had tried).....Going smoothly....

Jul 13, 2009 | 2007 Bajaj Pulsar 150

2 Answers

Noisey gearchange


Hi Al,
I know you are looking for feedback and I hope I can help.
I have a FLHR Road King Harley Davidson and believe me It clunked real bad when I bought it (7,000 miles), I checked the clutch primary chain, well within tolerance, also Clutch plates too.
I know your engine is wet sump and the gearbox uses the same oil as the engine?
I changed my gearbox oil and also double checked level as the amount that came out wasn't enough?
Since then pure smooth cold & Hot, so maybe the wrong viscosity oil? Nice & Thick cold but when thinned due to warm up and at operating temp not coating the gears so bulk rings failing slightly?
There you go one to look at?
Press the Blue Button please to appraise my FREE! Effort/s, Thank You!
Paul 'W' U.K.

Feb 16, 2009 | 2000 kawasaki ZZR 600

3 Answers

Pulsar 150


Dear Pravin,

Always check for the oil level before you start for the first time during the day. If you can just shake the bike you'll know how thick or light the oil is. The more lighter, you'll have to change faster. Also check for color. Oil can be maroon/red/dark green/etc. depending on brand. If its really black, change it fast. Dont do top ups. Better drain the entire oil and fill fresh oil.

The oil also acts as a lubricant to the gearbox. If you feel gear shifting is becoming too slippery or too tough, check for the viscousity, as said earlier. Slipping gear shift can also be due to a loose chain. So check for that too.

By the time you finish 1500 kms or 2000kms, its better to change the oil.

It is better to use Castrol Power1 for Pulsar. It prevents overheating and also keeps the engine and gearbox smooth. It also maintains viscousity at high temperatures for better lubrication.

My experience:

I used to put servo and every 900-1000 kms i had to change oil. Now with Castrol, I change only between 1500-2000kms. I'm getting mileage between 50 and 55kms for a litre of unleaded petrol.

Hope this helps in solving your problem.

Have a nice time riding pulsar.

Always wear helmet and drive safely.

Jan 16, 2009 | 2007 Bajaj Pulsar 150

Not finding what you are looking for?
2007 Bajaj Pulsar 150 Logo

Related Topics:

364 people viewed this question

Ask a Question

Usually answered in minutes!

Top Bajaj Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4473 Answers

yadayada
yadayada

Level 3 Expert

60792 Answers

Are you a Bajaj Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...