Question about 1992 Honda XR 250 R

1 Answer

Blinkers don't blink ,where is the relay switch on 1992 honda xr

Blikers come on but don't blink

Posted by on

  • fury1975 Apr 05, 2009

    how about the flasher unit...where about is that any idea's...I would also like to put a keyed ignition in too but i have put my keyed switch into all combinations of kill switch wires i can think of to no avail...any help would be appreciated

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 99 Answers

Usually found under the seat. It will have either 2 or 3 wires going to it.
Trick is to turn blinkers on, and disconnect relays until lights go out.
Then you have found correct relay.
It does sound like a faulty relay

TL

Posted on Feb 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1982 honda ascot blinkers just light up but wont blink


Sounds like your indicator relay is dying. You'll need to change it!

Jul 14, 2014 | Honda vt 500 ft ascot Motorcycles

1 Answer

Push starter button, headlight dims, no starter motor, etc.


Yes, LED turn signal lights require a flasher rated for LED's. They are available in auto parts stores.
As far as the now start goes, double check all wiring, making sure all the positives and all the negatives are correct. Check the ground wire from the battery. Make sure the connections are tight.

May 07, 2014 | 1995 Honda CB 750 Nighthawk

1 Answer

Blikers only work with running lights off


You have the tail light you just installed wired wrong or if the new tail light is a LED tail light your looking at the LED's possibly not drawing enough power to make the flasher work. change the flasher to a LED specific one.

Nov 14, 2012 | 2001 Yamaha YZF-R6

1 Answer

BLINKERS DON'T WORK ON 1983 HONDA MOTORCYCLE


Its most likely your flasher unit take out the old one and get a new one auto parts store have them you front tirn signal are dual filament so they are on all the time the rear are single filament.

Oct 12, 2012 | Motorcycles

1 Answer

92 nighthawk LED blinker problems.


Honda always grounds the turn signals separately (usually a green wire)not directly to the frame.Not hooking up the running light should not effect anything except forward visibility to other motorists. If you have a two prong flasher relay, go get a cheap flasher relay ($5-$10) and replace it. The only problem I have ever heard of when switching to LED turn signals is a flicker / fast flash instead of a normal slow flash. This is remedied by adding diodes to the wires.

Jun 30, 2010 | 1985 Honda CB 700 SC Nighthawk

1 Answer

Installing turn signals


I would assume this is to make bike road legal
To add turn signals You can add some signal relays and wire up to battery and a switch so each time you turn for left or right it triggers relay which triggers the light ..

Jun 22, 2010 | 2002 Honda XR 200

1 Answer

My xr 600 has spark but will not crank


check kill/sidestand switch for working proper with tester

if all good the starter relay needs to check next with tester

tester lights on relay then the starter motor failed

Nov 16, 2009 | 1990 Honda XR 600 R

1 Answer

Blinkers stay on but dont blink and horn does not work


If the blinker stays on it may be a bad bulb, if both sides do it, look at the flasher unit. Try the horn while running it, sometimes they need that extra "charge" to operate. If this doesn't work, look into the switches that operate these, as maybe you have corrosion, seeing how the switches are very close to each other.

Oct 08, 2009 | 2001 Honda XR 400R

1 Answer

4 ways will not work and left and right blikers will work


There are 2 flasher relays on these bikes, one for 4 ways and one for blinkers. First the simple things, 1. Have you checked the fuses? 2. Do you have power to the switch? 3. Do you have power to the relay/flasher from the switch? 4. Do you have power out of the relay/flasher. 5. Do you have power to your individual lights? Using this logic #5 is no so that takes us to the next thing backward in line and that would be flasher...

Jul 15, 2009 | 1982 kawasaki Z 550 F

1 Answer

Have put led blinkers on bike what flasher relay to run


Just make sure the resistors are securely attached to the bike. Just supporting them with the connecting wires isn't enough.

May 05, 2009 | 1987 Honda XR 250 R

Not finding what you are looking for?
1992 Honda XR 250 R Logo

Related Topics:

237 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4481 Answers

yadayada
yadayada

Level 3 Expert

61168 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...