Question about 2003 Yamaha WR 450 F

2 Answers

2001 raptor cabs not getting gas

My 2001 raptor 660 will start by starting spray but carbs r not getting any gas lines r clear to carbrators atv did sit for a year got new plug new gas help

Posted by on

  • josh frail
    josh frail Feb 08, 2009

    i pulled the hose off carbs and turned gas on it flowed good i pulled the carbs off and blew air where the hose gose and got nothing it wouldnt take any air needels move well

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Ihad this problem, I let gas sit in the motorcyle over winter. Bad mistake,The whole carb needs cleaned. I took my carb to the yamaha shop and they charged me $146.00 to fix it. Or you can take the jets and needle seat out and soak it in carb cleaner for a couple of days. Yamaha soak the carb in carb cleaner for 2 or 3 days, remember to remove any plastic, gaskets, rubber.

Posted on Feb 12, 2009

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 36 Answers

MAke sure your tank vent is clear.If so you need to pull the carbs and clean the passages and jets.You may have a stuck float or needle

Posted on Feb 08, 2009

  • Brad Hurt
    Brad Hurt Feb 08, 2009

    Take the carbs apart and clean them with carb cleaner.you dont do any good blowing air in the inlet.THe needle could be stuck.Plus if it has sat you will need to pull both jets out of each carb and clean all the holes out

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Yamaha raptor 660


clutch burned up...sounds like it. pull the clutch cover off and inspect it.

Apr 29, 2014 | ATVs

1 Answer

Starts with spraying gas into the carb then quits


You have spark, so problem with fuel. Maybe old gas. Determine if getting fuel to carburetor - if so you need to clean carburetor. If not, clean fuel lines or replace fuel pump.

Dec 28, 2013 | McCulloch Garden

2 Answers

2001 raptor 660 won't idle, only runs with choke on, an won't take throttle???


need your carb rebuilt or your carb readjusted. sounds like you might have some mud in it. do you take it in the mud? if so check the top where the throttle cable comes through.

Sep 22, 2012 | K and N Filters Powerlid 2001-2005 Yamaha...

1 Answer

05 raptor 660 will not start. new coil,timing chain, valves,carbs clean. it is getting gas and fire and all it will do is turn over and backfire and still in time


My 2001 raptor 660 starts when it's cold and runs great but if I shut it off when it gets hot it does'nt start back up until it cools down

May 28, 2012 | 2003 Yamaha YZ 125

1 Answer

My 05 Yamaha Grizzly 660 will not start. In my limited troublshooting practice I looked at FUEL, FIRE and AIR. Here is the fault, the engine will not start. I checked wires/fuses, plugs, fuel lines and air...


Sounds like you have a stuck float needle in the carbs (2). Usually after a few days with gas in the carb they will free up, you could 'knock' on the carbs with the plastic end of a screwdriver to help free them up. If not, turn off fuel, drain the carbs and fill them with carb cleaner for 24 hours. Redrain, attach fuel lines and turn the gas back on. If still no start it's time for a rebuild...

Mar 05, 2017 | Yamaha 2005 Grizzly 660 Auto 4x4

1 Answer

My 2003 660 raptor will not start


You have probably checked spark by now. if you haven't do so. also check your ignition box.

May 17, 2010 | 2003 Yamaha YZ 125

1 Answer

My 660 raptor quad is making like a humming/deep whistling sound when I try to start and won't start. It has good spark and new fuel. I noticed that the oil tank has built up pressure as I opened it the...


Sounds like the carb has over flowed and filled the crankcase with gas.
You will need to drain the oil, and re-fill it with new oil at the proper amount. Also replace the oil filter.
Clean the air filter and replace the spark plug.
Clean the carb, making sure the float and float needle are functioning properly.
That should fix you up!
RSRBOB

Jul 16, 2009 | 2001 Yamaha XTZ 660

2 Answers

Yamaha 2001 Raptor 660, need to clean my carb


Drain and replace the gas with fresh.
Remove the air cleaner and spray carb cleaner into the inlet. Work your throttle a little then put everything back together and try to start it.

Jun 02, 2009 | 2001 Yamaha YZ 426 F

Not finding what you are looking for?
2003 Yamaha WR 450 F Logo

412 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

276 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers

D. E. Hev

Level 3 Expert

1167 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...