Question about 2007 Suzuki GSX-R 1000

1 Answer

Oil in water

K well i bought 2007 gsxr and rode it all summer had a small radator leak so durring summer i put water in it from time to time then stored it for winter and yesterday i started the bike road it around the coner and it started to over heat drove back home and there was no water in the radator so i put 2 gallons of water in it but it while it was shut off and it seems to going into the block my question is what would cause the water to run strait into the block without it being started

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 104 Answers

Ok why are you using water should be using coolant there is allways coolant in the block radiator and header tank the pump circulates the coolant around the block and back into the radiator to be cooled if the radiator is still leaking you shoul repair with rad weld dont leave it keep the haeder tank topped up check radiator and hader tank regularly

Posted on Feb 07, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My suzuki 2005 s83 boulevard oil looks like chocolate milk.Bike has only 8000 miles.Rode and checked oil the other day was fine.I only rode 1 mile, not that hard.Checked oil today...looks bad


Sounds like water / oil emulsification. Is your bike water cooled or air cooled? If it's water cooled then you may have a gasket leak. If it's air cooled then you may not be riding the bike enough to get a good temp up inside the engine which would drive off the condensation inside the crank case / sump thereby leading to the emulsification. You say you rode an easy mile - certainly that's not enough to get the temp up enough to drive off the water. Was the bike running ok? Was it accelerating and braking ok? If so then try a cautious longer run and keep an eye on your levels. If in doubt consult a bike shop.

Jul 13, 2014 | Motorcycles

1 Answer

2007 yamaha yz250f starting problems


UNDER the gas tank there is a lever, put in on.Maybe ur out of gas.

Jan 30, 2013 | 2007 Yamaha yZ 250 F

1 Answer

My harley has a small leak coming from the air filter, the mechanic at the harley dealership told me it was the air filter. So i bought a new filter put it on and checked the oil level, with the bike...


Regrettably, a small oil leak from the air cleaner assembly is "normal". This is because the EPA requires all crankcase emissions to be routed to the intake system so that it can be burned in the engine. The result is that oil mist in the crankcase vented condenses in the air cleaner and eventually drips out.

The crankcase vent for your Sporty is in the heads. If you noticed, there are two large bolts that are hollow holding the air filter backing plate on. The crankcase vents into the air cleaner assembly through these two bolts. There is an "unbrella valve" in the rocker box center section that allows the air to flow one way but not the other. There are baffles in this area to keep the oil mist to a minimum but still there is some in the air coming out of the engine.

There are a few kits available on the aftermarket for re-routing this crankcase vent. You can direct the exit anywhere you wish using one of these kits. Most people just route the hose down and exit it under the bike just in front of the rear wheel.

When adding oil to your bike, only add the oil when the engine is hot. On your dipstick, you have two marks. The upper mark represents "FULL HOT" while the lower mark represents 'FULL COLD", Do not overfill. Check the level with the bike on the side stand.

Good Luck
steve

Oct 15, 2010 | 2006 Harley Davidson XL 1200 L Sporster...

1 Answer

WHen changing oil on a 2007 GSXR 750, how much Oil do I put In


3 quarts does the trick with mine. just remember to use a good quality oil and filter.

Sep 01, 2010 | 2007 Suzuki GSX-R 750

2 Answers

I have gsxr 600 k2 the oil is contaminated with water


thats due to water getting in the oil from the head gasket or other source, you need to drain and flush all the old oil, get the cylinders compression tested, and see whats up. A low reading on 2 adjacent cyls indicates the gasket is gone, and should be replaced. If the engine has overheated, the head may need skimmed.

Jan 29, 2010 | 2002 Suzuki GSX-R 600

1 Answer

Changed the oil in a 2007 GSXR & now it wont start


if it turns over he might want to check there isnt too much oil in the case

Aug 04, 2009 | 1996 Suzuki GSX-R 750 T

1 Answer

07 GSXR 1000 F1 light


That is a factory problem with the brain box,It is a trouble code from fuel injection...Most have it.It should not affect proformance

Jul 16, 2009 | 2007 Suzuki GSX-R 1000

1 Answer

I changed the oil and filter in my 2007 kawasaki


you probably have a leak! It is possible, (depending on what type of oil you put in)
that the oil dissolved the gasket, or removed sludge from an existing hole, causing it to open. but if you dont have any oil spots..well....thats a whole nother story.
terribly sorry!!
i hope this helps in some way!

Jun 09, 2009 | 2007 kawasaki 250 TR

1 Answer

1990 suzuki gsxr


So have the shop fix the petcock or just buy a different one complete. Google " motorcycle salvage suzuki " and you should be able to find one there. While you are waiting for the new petcock, go to the site below and download a free service manual for your bike.

http://www.carlsalter.com/motorcycle-manuals.asp

Top rating due on this answer :) Thanks!

Apr 25, 2009 | 1990 Suzuki GSX-R 750 L

1 Answer

Max water temp and Min oil pressure GSXR 1000


I am glad you posted on FixYa. I can help on the manuals. Everything you asked for AND a parts fitch with part numbers are on the free PDF download site shown below. The 1st screen sometimes takes up to 5 seconds to build but from there the download is extremely easy.

Ya owe me a top rating on this one! Thanks Kylie!

Apr 23, 2009 | 2001 Suzuki GSX-R 1000

Not finding what you are looking for?
2007 Suzuki GSX-R 1000 Logo

Related Topics:

203 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

64286 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4497 Answers

Ed Nelson
Ed Nelson

Level 2 Expert

149 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...