Question about 2006 kawasaki KLX 110

1 Answer

Klx 110 2006 stalls when choke is pushed in

Bike sat during the winter with gas in the tank.cleaned the air filter and cleaned the carb with cleaner by removeing the bowl and liberally spraying the carb cleaner all over and in the jets. engine starts right up and idles nicely when the choke is pulled out but when its pushed in it stalls immediately. tried adjusting the air fuel mixture screw but didn't seem to help. trying to sell the bike for my son who out grew it. can you help. need an answer as soon as possible.

Posted by on

  • Anonymous Mar 19, 2014

    engine idles but stalls out when you give it throttle. If I keep the choke pulled it tries to rev up but still dies. Is it normal for the carb to spit fuel back out when I try to rev it?


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert who has written 50 answers of more than 400 characters.


    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 126 Answers

I'd say the carb is gummed up especially the pilot jet (#16158) in this pic of the USA carb. may have to remove the carb & bowl and then remove the pilot jet (w/ flat head screw driver) and clean out the tiny holes.


the carb slide is installed backwards (turned 180 degrees). its #16025 in the pic. i've done this before on my daughter's XR70 and Z50. you'll know if its this when you move the choke lever, RPMs increase and decrease.

hope this worked for you and was fast enough.

Posted on Feb 06, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Scooter has 40 original miles.New,old gas, I put innew gas. It starts,idles only, if I give it gas it stalls and won't run..

Hi, Rick if your bike has been idle for months or years and does not want to start you will have to deal with a few remedies:
1. Drain and flush fuel tank, google " how to clean a motorcycle gas tank" find a couple forums to view the different options available.
2. Remove your air cleaner and clean and re-oil per Mfg. specifications.
3. Remove the carburetor, disassemble and decontaminate with a carb dip or if you have EFI remove injectors and clean with carb spray and compressed air
4. Remove fuel valve and filter disassemble and clean as necessary, remove fuel lines and replace with new ones.
5. Replace spark plug with a new one and check for spark.
For more information about your question please visit the website below. Good luck and have a nice day.
How to clean carburetor in 15 minutes

Nov 25, 2015 | GAS Motorcycles

1 Answer

Backfire intake

dean ,carb cleaner can be used to clean the carb parts on a re build and thats all .if the bike sat over winter (with fuel in the tank ?) how does it smell ? if its bad it will smell like turpentine .and needs to be changed ,theirs a lot of questions here . was the batt in good shape from the winter ,(good charge 12.6 ?) was your choke on when you dumped the cleaner in tryin to start ?

Apr 15, 2014 | 2006 Harley Davidson FLSTF Fat Boy

1 Answer

To start and run my kawasaki klx 110 i have to pull the choke all the way out. if i push it in it stalls it was a relatives and has been sitting for a while with gas in it what can i do to fix the problem

Remove and clean the carb. disassemble the carb then soak the carb parts in denatured alcohol for a couple hours then spraying with an aerosol carb cleaner should do the trick. Drain the gas tank and put in fresh gas. Go ahead and install an in-line fuel filter to lessen problems from a rusted gas tank.

Mar 13, 2011 | kawasaki KLX 110 Motorcycles

2 Answers

Bike is sputtering when give it gas. sat for 2

Make sure battery is full,not just charged. if the sputter is still there you may need to clean air filter,fuel fillter or carbs may need to have trash removed from inside at the fuel float valve-seat and jet.

Apr 29, 2010 | 2004 Honda VTX 1300

1 Answer

My 2000 gsxr 600 ran good all summer and sat in the garage this winter went to start it and now it wont idle with out the choke on even after it got warmed up too 200 degrees what do i check for to fix it

It needs the choke which means it has too little fuel. So the first thing is to run some carb. cleaner through it. If you can remove the air cleaner and spray cleaner into the carb. directly to help it clean. Add the cleaner to the fuel tank by following the direction. Too much will not work better thenwhat is suggested. Gasoline tends to evaporate and leave a varnish like hard coating on the fuel system. Takes a while to clean back out. Store all gas powered motors using a stabilizer product, or completely remove the gas before storage.

Feb 07, 2010 | 1999 Suzuki GSX-R 600

1 Answer

2004 klx 125l bike ideling

How long has the bike been sitting? The gas may be bad or the carb might need to be cleaned out or choke may be sticking.

Feb 06, 2010 | 2004 kawasaki KLX 125

1 Answer

I have a 2005 Honda Shadow Spirit 1100 that starts with the choke out but will never warm up. If you turn the choke off it stalls, if you give it gas with the choke on it stalls, If you try to start it...

this sounds more like a fule problem to me, try striping the carbs out and clean all the jets out, also check the fule it reaching the carbs and its not a blocked fule tank or filter as this bike is just not getting any fule to the engine after cleaning the carbs it should run ok, but just to be on the safe side get some cleaner and tip it into the fule tank also

Jan 16, 2010 | 2005 Suzuki GSX 600 F (Katana)

2 Answers

Bike sat for awhile, runs but doesnt idle very good. cuts out

I would remove and clean the sparkplugs - sounds like one may be fouled.

Aug 18, 2009 | 1994 Yamaha FZR 600

1 Answer

Honda vfr 400 does not idle

gummed up carbs, faulty fuel pump, blocked fuel filter.

all of these will give you that response, fuel starvation.
you are not getting the right amount of gas thru, unles you have the choke on which cuts out some of the air making your mixture a little richer.

if it sat over winter in storage, the carbs probably could do with cleaning. you can try removing the air filter and spraying a bunch in, let it sit over night and see what happens. a good fuel system cleaner (additive) may help. if you can get Berrymans B12 ( dont know what country you in) it may be just american. but if you get some double the dose throw it in the gas tank, run bike til hot and then put it away for the night. then next day hopfully should be better. also if you have an inline fuel filter you could try changing that. does it have an electronic fuel pump.? does it run constantly?
that link will get you a free pdf service manual

Apr 05, 2009 | 1995 Honda VFR 400 R NC30

1 Answer

Starting 2007 kawasaki klx 250

• The first thing to do with ANY engine that has sat for any longer than a couple of months is to dump ALL the fuel in the tank and carb(s). ALL OF IT !! You'll want to refill with some high priced fuel that has fuel system cleaners (Like Chevron with Techron) not becasue you need high-test fuel, but because you need the cleaners. It's ether that or disassemble the carbs and clean out jets you can't find much less see. Your choice. The carb kits alone will cost you about $50 so a tank of high-test is looking pretty good, huh?

• Now the fact that you tried to crank the engine with old fuel has fouled the sparkplugs. All of them. Go buy all new sparkplugs.

• If your bike has a vacuum fuel valve, then you'll also need to set the valve to "Prime".

Mar 21, 2009 | 2007 kawasaki KLX 250

Not finding what you are looking for?
2006 kawasaki KLX 110 Logo

738 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4497 Answers

Angelo Stewart
Angelo Stewart

Level 2 Expert

224 Answers


Level 3 Expert

64052 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides