Question about 2003 Gas Gas EC 400 FSE Supermotard

1 Answer

Electrical problem bike has not been used for a while will not start. battery fully charged. all fuses ok. completely dead . when ignition is switched on theres nothing no noise from switch\ fuel relay. any ideas please. thanks John

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 46 Answers

Check that the positive and negative terminals have not been mixed up

Posted on Feb 14, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No power to 2001 yamaha 1600 road star. battery good, fuses good, starter relay good.


Hi, David and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, needs to be 12.5 volts or better and be able to pass a load test if necessary, check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Bank angle sensor tripped and ignition/light key switch not cycled to the "OFF" position and then back to the "ON" position.
5. Faulty ignition switch.
6. Faulty starter button.
7. Faulty kickstand or clutch pull in switch/sensor.
8. Security alarm needs a reset.
9. Starter control circuit, relay, or solenoid faulty.
10. Main fuse or circuit breaker may be blown or faulty.
11. Electric starter shaft pinion gear is not engaging or over-running starter clutch slipping.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
Re Electrical Starting System Failure Road Star Forum Yamaha Road Star
ROADSTAR FUEL PUMP INTERMITTENT FAULT
http://www.electrosport.com/media/pdf/fault-finding-diagram.pdf
http://www.vsoc-eastanglia.org.uk/xv1600.pdf
http://www.starmotorcycles.com/assets/service/manuals/2006/LIT-11626-19-45_Road_Star_1266.pdf

Jun 18, 2016 | Yamaha Motorcycles

3 Answers

My bike won't start, what can I do?


Fuses need to be tested!

Aug 19, 2015 | Motorcycles

1 Answer

Injectors not shooting gas in thottle bodies


There could be many reasons for this, some simple, some not so simple, so you will need to start by eliminating simple things first.

The first thing to check is the battery. Is it fully charged and in good enough shape to supply the electrical load needed to make the bike run correctly (bikes with electronic ignition and fuel injection must have a good battery for the bike to run properly)?

Next, take a look at your owners manual and find out if there is a fuse for the fuel injection system. If there is, is it good?

When you insert the key and turn the ignition on can you hear the fuel pump? If not, you fuel pump is either dead or not getting power for one reason or another.

Many cars are equiped with a safety switch which automaticly turns off the fuel pump in the event of an accident. These can be reset by simply pushing a button. Is your bike equipped with something similar?

When was the last time the bike was running? The gas sold today is notorious for not being stable for very long. If everything else on the bike checks out ok, there is a remote chance your injectors are clogged with bad fuel.

Nov 10, 2013 | 2000 Suzuki GSX-R 750

1 Answer

2003 Fatboy Electrical Issues


Hi Dee, and the usual suspects are:
1.Ignition/Light Key Switch not in IGNITION position.
2.Engine Stop switch in the OFF position.
3.Discharged battery, loose or corroded connections check negative cable at BOTH ends. (solenoid chatters).
4. Bank Angle Sensor tripped and Ignition/Light Key Switch not cycled to Off and then back to on.
5. Starter control circuit, relay or solenoid faulty.
6. Electric starter shaft pinion gear not engaging or over-running clutch slipping.
7. Security alarm not disarming
For a prime suspect please visit website below and good Luck.
Big Twin Carb EFI DTC Intructions codes Harley Davidson Forums Harley...

Apr 10, 2013 | 2003 Harley Davidson FLSTF Fat boy

1 Answer

Motorcycle is completely dead. i already checked the battery and it has enough charge to turn on the bike, i checked the fuse and it's fine. but when i turn the ignition to the on position all of the...


Hi Sprgod, to diagnose any electrical problem you need to start with a fully charged battery, and for more information about your question please visit the website below. Good luck and have a nice day.
Suzuki VL800 Intruder Volusia 2001 2009 Repair Manual improved...

Aug 09, 2011 | 2002 Suzuki VL 800 Volusia

1 Answer

I own a 98 yzf. the battery was dead so i tried jumping it with a car i hooked the cables up with the car off. the lights on the bike went on so i tried to start it when i hit the ignition & the lights...


Yes it sounds like one. OK, find your abttery terminals, one is marked in black cable and the other has a red sleeve near the terminal. Follow the red cabel to a box that contain a 30A fuse, see if this is blwon, which most likely. Replace fuse and now use a trickle charger as car batteries has toooo much amperage to jump start a bike. If you have another bike battery it is fine to jump start, never try using a car battery as many damages can happen. Once battery is fully charged ( normally in 8 hours) try again for your bike to start. Cheers. If good give a return comment please.

Nov 07, 2010 | Yamaha SZR 660 Motorcycles

2 Answers

I have a 1978 Honda 750F motorcycle that is electrically dead.


take your battery and have it tested. just because you have voltage dosnt mean its there under a load

Sep 06, 2009 | Honda CB 750 Motorcycles

1 Answer

I have 2001 r6 and when i charge the battery on a charger it says it is fully charged but when i go to start the bike it still is dead and the cables are clean any help


Check the fuses. Check the battery with a hydrometer. Barring that, short across the battery terminals to check the level of spark. Check the ignition switch and all kill switches with a volt ohmmeter. Chances are that the battery just will no longer take a charge.

Jun 30, 2009 | 2000 Yamaha YZF-R6

2 Answers

Everything turns off when I hit the start switch.


Sounds like poor connections on the battery.

TL

Jan 23, 2009 | 2001 Ducati 748 S

Not finding what you are looking for?
2003 Gas Gas EC 400 FSE Supermotard Logo

Related Topics:

178 people viewed this question

Ask a Question

Usually answered in minutes!

Top Gas Gas Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4497 Answers

Luc Francoeur
Luc Francoeur

Level 2 Expert

102 Answers

Kim Halliwell

Level 1 Expert

32 Answers

Are you a Gas Gas Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...