-
Chevrolet Master
981 Answers
- Posted on Jan 30, 2013
Re: Need torque scecs for control arm
1) Install or connect the following:- Lower control arm
- Control arm bolts and nuts
- Ball stud to the knuckle
- Ball stud castle nut, tighten the ball stud castle nut to 22 ft. lbs. (30 Nm), plus 135 degrees
Note: Do NOT loosen the ball stud nut in order to align the ball
stud nut slots to the ball stud cotter pin hole. If necessary, tighten
the ball stud castle nut in order to align the ball stud castle nut slot
to the ball stud cotter pin hole. Ensure that the cotter pin ends do
NOT contact the ABS wheel speed sensor, the ABS sensor connector or the
drive axle.
- NEW cotter pin and bend the ends
- Stabilizer shaft link
- ABS wheel speed sensor jumper harness to the harness retainer clips
- ABS wheel speed sensor connector
- Lower control arm nuts, tighten the lower control arm nuts to 71 ft. lbs. (96 Nm)
- From Chevrolet web site.
×