Question about 1996 Honda CBR 600 F(3)T

2 Answers

I need to remove the seat

I am trying to accsess the battery on my 1996 cbr 600f2 But i cannot figure out how to get my seat off can you please help

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

The first thing you have to do is to remove the fairings on both sides. The ones I am referring to are from the fuel **** to the back tail light. Do this very carefully as the part of the fairing close to the fuel on off reserve is very easily broken, so use a screw driver and gently pry it off, there is also a turn screw that has to be turned with a screw driver that holds this fairing in place it is below the fuel on off knob, turn it to loosen the fairing gently pry off the other parts toward the back of the tail light and this whole section can be removed. Once this side is off do the other side using the same gentle technique. Once these two are off there are two screw bolts holding the seat in place. Once they are removed then pull the seat up gently and back as there is a part that slides under an opening that part of the seat underside fits into. Once off you can access the battery which is under a covering which must be removed. This is all an example of some poor engineering from Honda. I would have expected better but this is what you get. Good luck, putting those fairings back on have to be done with equal gentle techniques to insure you do not break those fairing sections that hold the fairing in place. More bad engineering from Honda.

Posted on Apr 10, 2009

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 126 Answers

Here is a pic for a 96 F3. it shows 2 bolts on either side of the seat. guessing if you remove them it will remove the seat.

http://partsfinder.onlinemicrofiche.com/atlanticcycleandpower/Honda_OEM/HondaMC.asp?Type=18&A=162&B=45&Action=O

Posted on Jan 28, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the air filter located on a1994 Honda CBR 600f2


remove the seat and you should see the airbox which is connected to the carbs , its in there , possibly need to remove the fuel tank also ! ?

Dec 11, 2013 | Motorcycles

1 Answer

Honda CBR 125 replace headlight bulb


Hi, Anonymous for this scenario you will need your service/owners manual if you can't find the best tool you ever bought for your Honda, despair not, for a mere zero $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
https://cbrforum.com/forum/cbr-600f2-16/how-change-headlight-bulb-84794
Honda CBF 125 Front Lights Replacement
Honda CBR125R Owner Manual service
http://www.partsfish.com/page/oem-parts-for-honda
Honda CBR125RW Owner Manual

Sep 04, 2013 | Honda CBR 125 R Motorcycles

1 Answer

1994 honda cbr 1000 30a fuse box


The main fuse is located under the seat near the battery just follow the positive cable on the battery it leads to the main fuse.

Mar 23, 2013 | 1994 Honda CBR 1000 F

1 Answer

How do I remove the seat from a 2003 Honda Blackbird@


Hi, Anonymous for this scenario you will need your service, parts fiche, and owners manual if you can't find the best tool you ever bought for your Honda, despair not, for a mere $7 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Help with seat removal
seat removal 03 cbr honda CBR Forum Enthusiast forums for Honda CBR Owners
Honda Motor Manuals Download $7 cheap
https://www.partsfish.com/page/oem-parts-for-honda
Honda 2006 CBR1100XX Owner Manual

Feb 24, 2013 | 2003 Honda CBR 1100 XX Super blackbird

1 Answer

1996 Honda CBR 600 F(3)T quit running while riding


Hi, Paul and the usual suspects are:
1. Severely discharged or a damaged battery should have 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a preliminary reading of 12.5 volts or more but little or zero amperage the battery is faulty and must be replaced, AGM batteries fail in this scenario more so than lead-acid batteries.
2. Failed alternator/generator and or voltage regulator.
3. Loose or corroded battery terminals and or cables especially the "NEGATIVE" cable, look for loose, corroded, or broken connectors inside the cable harness at "BOTH" ends.
4. Failed main circuit breaker or ignition switch, check for loose connections and continuity.
5. Failed system and or ignition relay, check for continuity.
6. Failed ignition coil, stator, magneto, ignition/electronic module.
7. Failed CKP, CPS, CMP, MAP, TPS, or BAS sensor, corroded, loose or broken wire connector pins/sockets.
8. Throttle cables and or idle speed improperly adjusted hot idle speed should be 950 RPM to 1000 RPM.
9. Faulty neutral, side stand or clutch lever safety switch.
10. Faulty or corroded kill switch.
11. Accelerator pump damaged or not working.
12. Water or dirt in the fuel system, carburetor or filter.
13. Restricted, blocked or kinked fuel line.
14. Fuel tank empty.
15. The gas cap is not venting properly or fuel tank venting system blocked, loosen gas cap and go for a test ride.
16. A failed fuel pump, pressure regulator and or fuel injectors.
17. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
18. Needle and seat stuck closed in the float bowl.
19. Petcock clogged or damaged.
20. Lean angle switch is faulty or needs adjustment.
21. Catastrophic engine failure, perform a compression test.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
96 cbr600 f3 dies while riding on highway CBR Forum Enthusiast forums for...
http://www.fireblades.org/forums/honda-cbr-600/85825-1996-cbr600f3-runs-then-quits-running-2.html
1995 1996 Honda CBR600 F3 Service Repair Manual Download 1995 1996... $15
https://www.partsfish.com/page/oem-parts-for-honda
Honda CBR600F Owner Manual

May 07, 2012 | 1996 Honda CBR 600 F(3)T

1 Answer

1999 Honda CBR 600 F(4)X seat removal


Hi, Scottln21 for this scenario you will need your service manual, parts fiche, and owners manual if you can't find the best tool you ever bought for your Honda, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
CBR 600 Removing Seat
4 Honda CBR600FL 1990 Seat fairing removal fuel tap operation
Honda CBR600F4I 2001 Service Manual
https://www.partsfish.com/page/oem-parts-for-honda
Honda CBR600F4i Owner Manual

Feb 03, 2011 | 1999 Honda CBR 600 F(4)X

1 Answer

How to remove the seat on my 1990 cbr 1000f4


Hi
Remove side panels under the seat to reveal seat bolts

Ride Safe
Bike-Doc

Jul 17, 2010 | 1990 Honda CBR 1000 F

2 Answers

Can't remove seat from a 97 model cbr 600


I think this is the model that you first need to remove the side panels from under the seat. With these removed you will see the 2 bolts (1 each side) that hold the seat to the frame.

Jan 17, 2010 | 1997 Honda CBR 600 F(3)V

1 Answer

Getting to the battery on a 2007 cbr 1000rr


The back corners of the riders seat are soft and can be bent up to expose the screws that hold it to the frame.

Jan 17, 2010 | 2007 Honda CBR 1000 RR Fireblade

Not finding what you are looking for?
1996 Honda CBR 600 F(3)T Logo

Related Topics:

376 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4821 Answers

yadayada
yadayada

Level 3 Expert

79077 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...