Question about 2004 kawasaki ZX-6R

1 Answer

2004 kawasaki zx6r was dropped now wont start

Check all wires getting power but no spark

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Tip it over a game then try to start

Posted on Jan 23, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 20 Answers

SOURCE: my 05 zx6r wont start

try changing your coil(s)

Posted on Jul 27, 2009

Benimur
  • 6966 Answers

SOURCE: 00 kawasaki ninja zx6r my bike don have no power,

Hi and welcome to FixYa,

I understand that you have checked the:

  • battery - that it is fully charged and that the cables & terminals / connectors are clean and tight;
  • fuses - including the 30 Amp main fuse;
  • starter relay - there is +12 on the white wire.
Should the above hold true, then the only remaining components to suspect / check would be the always on +12 connectors and/or the ignition switch.

Good luck and thank you for asking FixYa.

Posted on Nov 18, 2009

  • 124 Answers

SOURCE: help channging the front wheel on a kawasaki ninga

By "changing the front wheel" do you mean how do you remove the wheel from the bike? If so, Start by securing the motorcycle in a upright position and place a jack under the engine with a wood protector between the jack and engine. Raise the motorcycle until the front tire is just touching the ground. Remove both brake calipers then loosen and remove the axle nut. Now remove the axle clamp and slide the axle out of the wheel. Note how the speedometer gear is mounted before pulling the axle. Now raise the motorcycle until the tire assembly will clear the fender. Reassembly is exact reverse of removal with the exception of when you install the axle you will tighten the axle nut before you tighten the axle clamp.

Posted on Nov 20, 2009

Adrian762
  • 425 Answers

SOURCE: wiring diagram 2001 zx6r

Try this manual, it should cover all your needs. Are you sure you have the correct rating fuse in the box, the manual will solve the problem any way. Good luck:

http://vitek.vellum.cz/manualy/Kawasaki%20Ninja%20ZX-6R%2000-02%20Service%20manual.pdf

Posted on Jan 29, 2010

jmurtagh617
  • 11 Answers

SOURCE: 2007 kawasaki zx6r ninja cranks but no start, not

check ground

Posted on Feb 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have Kawasaki zxr 636 it will not start when cold it trys to fire but won't 20 mins with jump lead it starts and is ok leave it a month it will not go


Hi, Wayne you may want to consider a motorcycle battery tender and the usual suspects are:
1. Fuel tank empty.
2. Fuel supply valve/petcock turned off.
3. Fouled spark plugs.
4. Engine flooded as a result of overuse of the enricher.
5. Vacuum hose to the fuel supply valve/petcock disconnected, broken, cracked, or pinched.
6. Fuel valve/petcock or filter clogged.
7. Fuel line to the carburetor or throttle body pinched or kinked.
8. Carburetor float stuck.
9. Fuel injectors clogged.
10. Severely discharged or damaged battery you need 12.5 volts or better and be able to pass a load test if necessary.
11. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
12. Loose or corroded wire connection at the coil, battery or plug between ignition sensor and CDI box.
Spark plug cables in bad condition and shorting check for leakage in the dark, cable connections loose, or connected to the wrong cylinders.
13. Ignition timing incorrect due to a faulty MAP, CKP, O2, TPS, sensors.
14. Faulty neutral, clutch lever, or kickstand safety switch.
15. Faulty fuel pump or fuse or relay.
16. Faulty CDI box.
17. A stuck bent or burnt valve.
18. Tip over sensor needs a reset.
19. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
http://zx6r.com/zx6r/32773-636-won-t-start-what-haven-t-i-tried.html
05 zx6r suddenly wont start need help
Kawasaki Ninja ZX 6R Service Manual
OEM Parts for Kawasaki
Kawasaki Ninja ZX 6R Owner Manual

Feb 18, 2017 | kawasaki ZX-6R Ninja Motorcycles

1 Answer

Zx6r 2004. Bike ran great for two months. Went out to dinner last night and came out to my bike not starting. Trailered it home, started when taking off trailer. Went for a 15 minute ride and parked it....


Hi, Matt it saddens me to inform you that you have to put on your Battery Priest Robe and prepare yourself for the Ceremonial "LOAD TEST" but before you begin, maintenance type batteries must be topped off with distilled Holy Water and all batteries must present their terminals to the battery charging altar to receive the electrical infusion of Holy Ions until they have reached a 100% full charge of 12.5 volts or better.
Below is a quick and easy test to see if your battery is in good condition or needs Last Rites and must be replaced.
1. Start by disconnecting the spark plug cables.
2. Adjust voltmeter to DC volts 20-volt range
3. Place the voltmeter leads to the battery terminals.
4. Turn the run/off switch to run.
5. Turn the ignition switch on and press the starter button.
6. Watch the voltmeter as your engine turns over for 15 seconds.
7. If the voltage drops below 9.5 volts, the battery is faulty and must be replaced.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
ZX6R 636 Bike won start
Kawasaki NINJA ZX6R My bike won start Starter problem or discharged battery
Kawasaki Ninja ZX6R Service Manual
OEM Parts for Kawasaki
Kawasaki Ninja ZX 6R Owner Manual
How to Tell if Your Battery is Bad in 3 Easy Steps

May 18, 2017 | 2007 kawasaki Ninja ZX6R

1 Answer

Kawasaki zx6r wont fire


I'm doing the same thing with a 09 zx6r motor and ran into the same problem came to find out the factory ignition switch has a 100 ohm resistor built in on the hot in wire for anti theft

May 16, 2012 | 2007 kawasaki ZX-6R

1 Answer

I have zx6r that wont start changed battery for new but all i get is a clicking sound. any ideas


Follow the large wire from the positive pole on the battery to a small relay with two large wires on it.
That is the starter solenoid, jump from one off the post to the other big post on the solenoid and see if the
starter works. IT WILL SPARK when you jump it use a big wire.
If starter works then 99% sure solenoid is bad.

Feb 06, 2011 | 1996 kawasaki ZX-6R Ninja

1 Answer

My 01 zx6r ninja wont start


Make sure you are getting a solid spark to the plugs - Take out the plugs and leave them sitting on the head, turn over the engine and see if you are getting a strong blue spark. If not, I'd say your CDI unit needs replacing (Capisator Discharge Ignision)

Aug 11, 2010 | 2001 kawasaki ZX-6R Ninja

2 Answers

Wiring diagram 2001 zx6r


Try this manual, it should cover all your needs. Are you sure you have the correct rating fuse in the box, the manual will solve the problem any way. Good luck:

http://vitek.vellum.cz/manualy/Kawasaki%20Ninja%20ZX-6R%2000-02%20Service%20manual.pdf

Jan 29, 2010 | 2001 kawasaki ZX-6R Ninja

1 Answer

My 2002 zx6r will not start, i change the spark plugs, checked all the fuel lines, yet i still can't start the bike, what could it be?


There are many items the first three are fuel, air, and spark. If you are getting fuel, check spark. If you are getting spark check your kill switch, ignition switch, and relays. After this you are getting into more complicated areas that you could come out cheaper by dropping it off at a shop.
Did anything happen to the bike since it last started or was anything done to it at all since it last started?
Please post and let us know.

Dec 01, 2009 | 2002 kawasaki ZX-6R

1 Answer

My 05 zx6r wont start


try changing your coil(s)

Jul 27, 2009 | 2001 kawasaki ZX-6R Ninja

Not finding what you are looking for?
2004 kawasaki ZX-6R Logo

Related Topics:

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...