Question about 2003 Suzuki UH 125 Burgman

Open Question

Fuel guage not working on uh125 2008

Showing full all the time. could it be the sender? I dont have a wiring diagram

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Proton satria neo 007,fuel guage problem,it will show gas level and then suddelnly the guage will go down and stay there showing no gas and the petrol light dont even work


You need to determine if the sender is bad or the gauge is. If you can get to the signal wire at the fuel tank for the gauge (this goes inside tank to sender that provides a variable ground circuit) ground that wire briefly to see if dash gauge rises. If so, part inside tank is bad. If not, gauge or some part of its wiring circuit is bad.

Oct 18, 2016 | Proton Cars & Trucks

1 Answer

GAS GAUGE STUCK ON FULL


well its not connected>? or you forgot to ground the ground wire?
if you had a DMM meter , this would be easy,
you can measure the sensor ohms, at any time with tank in car.
and id have never put back any tank with out checking it first.
not me, pulling tanks is no fun.
and empty tank the gauge sender is at max ohms, (lever down)
so is about 100 ohms and 10 ohms full (ball park) RTM
read the FSM read alldata.com
heck the FSM has a flow chart for these tests. amazing huh?
i dont use it, i use my meter and ohms law.
ill now look online at alldata.
the only think complex is which of 2 systems it is,
in the late 90s most cars changed. to indirect way.
ok , i looked, your car is direct way, (cave man)
its just 2 parts, a gauge and a sender. (sure wires)
the sender is grounded at G751
if the dash temp guage works , then the fuse is not blown , fuse 1.

the tests are cave man simple , all FSM show this.

1: unplug the Yellow/Blue sender wire, at any point
from front (gauge) to sender, any place, there are many.(4 junctions)
now, on the upstream side, key on, and ground this pin for 1min
max, if guage moves pull the ground. (i use $#194 lamp for tests )
i connect my lamp to ground and the other side to the guage,wire.
then key on and see guage move. bingo gauge is 100% good.
cave man easy. (

now the sender.
i measure the ohm.
DMM on 200 ohm scale if manual meter.
i connect black meter to body ground (shiny steel not plastic)
i connect red lead to down stream wire above..Yellow/Blue
it must read 100 ohms empty
not 0 ohms.
not infinity.
if read infinity? the wire is cut, or gound it open or the sender is bad.
if reads 0, the wire is grounded to the body or the the sender is bad (shorted)
do not take my facts on ohms as verbatim,
read the FSM and get the facts.

but i think your tank sender wire is shorted to ground.
some gauges work backwards, and my poor online version
dont cover this. well.
unplug the sensor does guage go full or empty?
most go empty, but not all.
use the lamp to test the gage, get to swing both ways
with lamp to ground and with lamp and wire disconnected.
cheers.

















Dec 02, 2013 | 1997 Acura CL

1 Answer

Fuel guage


the guage gets a earth signal from the sender ,, depending on the amount the guage rises accordingly ,, if the wire is touching earth any where the guage will go up to full,,,, disconnect the fuel sender and see does the guage drop,, it should if there is no short in the wiring ,,,,if it does drop you then have to recheck the sender ,,, if the guage stays full you have to check wiring for a short ,,,,, if you are able you could strip out the guage and disconnect the plug at the rear of it to make sure that the guage itself is not faulty,,,,

Feb 11, 2012 | 1999 Toyota 4Runner

1 Answer

Fuel guage shows full all the time


It sounds as if your guage is grounded out. Check the electrical lines from your guage to the tank sender to see if one of them is cut or damaged and is grounding out to the frame of the bike.

Apr 07, 2010 | 2003 Harley Davidson FLSTC Heritage...

1 Answer

Not working


take the wire off the fuel sender and ground it, the fuel gauge should read full. if it does, the sender or the float on the sender is bad. if it does not read full, there is a bad wire or connection between the fuel tank and gauge. if you take the sender out, and the float is bad, these are easily available, you can hook up the wire and another wire to ground the body of the sender and you should be able to work the arm up and down and the gauge should read.

Oct 02, 2009 | Ford F-100 Cars & Trucks

1 Answer

My gas gauge is always reading full why 1999 cavalier


Hi

The most likely cause is that the fuel sender in the tank is faulty or that the wiring to the sender is bad.

Less common causes are a faulty fuel guage or circuit in the instrument panel.

Test the sender as it is the most likely cause and easiest to eliminate.

First inspect all connections that are readily visible to insure that they are secure & free from dirt or corrosion.

Disconnect the fuel tank sender wire at the tank. The guage should continue to show full (ignition on). Ground the wire from the sending unit at the fuel tank to any good grounding point on the car. The gauge should go to "Empty". If it does this is a strong indicator that the sending unit is at fault.

Hope this helps. Please do rate my answer. Thanks

Sep 02, 2009 | 1999 Chevrolet Cavalier

3 Answers

2001 HYUNDAI FUEL GAUGE


well its either the wire between the tank and guage in dash or it is the gauge in the dash

Aug 15, 2009 | 2001 Hyundai Accent

1 Answer

Fuel guage on a 1998 honda accord


This is not a calibration issue, the sender in the fuel tank is the problem, this is a common symtom for senders when they fail

Nov 07, 2008 | 1999 Honda Passport

1 Answer

Pajero NK87 petrol guage not working, shows empty even when tank is full


Sounds like the Fuel sender unit in the fuel tank needs replacing however you may want to check that the electrical plugs are contacting properly,Check that the gauge is working by putting a piece of wire from the sender unit wire to the chassis,at the fuel tank sender unit plug,Turn ignition on while watching gauge if it moves toward fill turn ignition off and remove wire to chassis.If gauge moves it means from the fuel tank to fuel gauge is intact and not your problem.

Oct 24, 2008 | Mitsubishi Montero Cars & Trucks

Not finding what you are looking for?
2003 Suzuki UH 125 Burgman Logo

Related Topics:

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Ed Nelson
Ed Nelson

Level 2 Expert

149 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...