Question about 2008 Moto Morini Corsaro 1200 Veloce

1 Answer

Starting Bike starts then stops. Second time a clicking noise is herd and start button won't start the bike

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

GET YOUR BATTERY LOAD TESTED ,SOUNDS LIKE ITS BAD

Posted on Jan 20, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 Goldwing won't start...just one click when start button pushed


you may have blown the starter solenoid or even worst the starter motor
i cannot diagnose without seeing the bike properly
i strongly suggest you put in a workshop and get it diagnosed properly

Apr 12, 2013 | 2003 Honda GL 1800 Gold Wing

1 Answer

1980 Suzuki Gs450L won't start. I stalled out pretty bad in 4th gear and it won't start back up after. Bike won't even crank over, just makes a clicking noise. Any ideas?


pull the plugs then crank motor you may find one cylinder full of gas and that will keep it from cranking, if it cranks without the plugs allow it to dry for a bit , make sure plugs are dry then install and hopefully GO!

Jul 04, 2012 | Suzuki Motorcycles

1 Answer

When riding in 5th gear starting losing cylinders. and bike dies? then bike won't start electrical start. can' roll bump start bike if i let sit for an hour. thn bike dies quickly. is my m


More likely to be your ignition coils. They heat up and expand this can cause an open circuit which will close up again when it has cooled down. Although, a bad charging system may cause this problem. Check the battery voltage with engine switched off ( approx 12 volts) and with the engine running (approx 14 volts) If you are getting 14 volts then your battery is dead, if you aren't, then your charging system has a fault.

May 06, 2012 | Honda CB 750 Motorcycles

1 Answer

Buell blast won't start


You have a bad switch somewhere - either the clutch switch in the clutch lever or the kickstand switch is bad. Of course I had a blast that had a sloppy connector at the back of the key switch that did all of the above too.

Apr 03, 2012 | 2001 Buell Blast

1 Answer

CONNECTED BATTERY CABLES WRONG ON MY dUCATI S4R


Most likely is a fuse does your lights come on does your gages light up do you hear your cilinoid click when you engage clutch or starting safety if none of the ebove are happening check your starter relay your battery and fuses

Dec 27, 2011 | 2007 Ducati Monster S4R Testastretta

1 Answer

Bike won't start, new Harley battery, and starter bike 2006 FLHX Street Glide, all I get is a clicking noise from solenoid under seat


I'm not too familiar with the later model bikes but if I were getting a clicking noise under the seat and the bike was not starting, I'd investigate the source of the noise. It's possible that it is a starter relay that engages the solenoid that is an integral part of the starter. Look at the starter from the right hand side of your bike. You'll see a single small wire that connects to the end of the starter just above the end plate of the solenoid. Disconnect this wire and connect a test light or volt meter to the wire. Turn on your ignition switch and press the start button. You should hear the click under the seat and see voltage at the end of that wire. If not, replace the relay, a plastic cube about an inch in dimension.

Good Luck
Steve

Jul 02, 2011 | Harley Davidson Storm 50 Motorcycles

1 Answer

I have a 2007 road king that was starting and running perfrectly. I stopped and it would not start. Acted like the battery was low.i checked with a vlot /ohm meter. It was good. I tried to jump it and it...


I have the same problem with my 2008 King. Have you run the on board diagnostics to see if there are fault codes stored? I am starting with the air filter. I took it off and started the bike and as usual it started Ok then I let it run and stopped the engine. Normally at this point it won't start first time but with the filter off it did, so I am changing that. If this doesn't work I will be looking at the Oxygen sensor in the exhaust system as this might be faulty. I had a 05 King before this one and the sensor moved when the throttle was moved but on this 08 model it doesn't and as it sits in the hot air of the exhaust and my starting problems only occur when the bike is hot, it might be that. I'll try the simple first in accordance with Ochims razer principle.

Jun 29, 2010 | 2008 Harley Davidson FLHRC Road King...

Not finding what you are looking for?
2008 Moto Morini Corsaro 1200 Veloce Logo

Related Topics:

592 people viewed this question

Ask a Question

Usually answered in minutes!

Top Moto Morini Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75005 Answers

kakima

Level 3 Expert

102366 Answers

Are you a Moto Morini Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...