Question about 1989 kawasaki ZXR 750

1 Answer

1989 ZXR 750 H1

My bike runs fine until i go and put it in gear and let the clutch out it cuts out ,I have just had the head off to lap valves ,I'm wondering if i have put the cam timing wrong , I have also just put new chain and sprockets on it could i have disrupted the neutral switch on the clutch . need help .

Posted by on

  •  shaun  mills
    shaun mills Jan 22, 2013

    it was not the side stand switch ,so i went on a hunt and found out it was the neutral switch on the clutch ,so i removed it and away it went.
    Thanks for all your help most appreciated.

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 409 Answers

Not a cam timing problem...sidestand lockout switch is stopping you from riding away...

Posted on Jan 19, 2013

  •  shaun  mills
    shaun mills Jan 19, 2013

    thank ill have a look ,side stand swicth was disconnected from previous owner and i found some other wires loose in there i might have bumped something . thanks for your help

×

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 409 Answers

SOURCE: zxr 750 fuel seeping into sump when fuel tap not switched off

Sticking float valves...

Posted on May 29, 2012

Testimonial: "cleaned carbs all seems fine thanks"

  • 3567 Answers

SOURCE: Where do I find the netural start switch on my 89 zxr250?

The neutral switch is mounted in the left end of the shift drum. It is part number 13151-1080. There is an associated part, "PIN-neutral position" #92043-076 The pin is under a bolt screwed into the top case. Bad switch or loose wire connection.

Please rate this answer. Thanks!

Posted on Apr 19, 2009

ckoira57
  • 267 Answers

SOURCE: timing problem zxr750h1

Hi Darren, it's Chris. I'm tipping you'd like to have exploded view diagrams of every part of the motor then......

http://www.cmsnl.com/kawasaki-1989-h1-zx750_model12897/partslist/ Brilliant site this!

Otherwise do a search for manuals thru these Fixya links about manuals, or search "ur model name" forums for links about tuning etc......that's why I have a laptop in the bike shed!
Cheers.

Posted on May 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Change alternator belt


ZXR 750 alternator belt change - ZX Forums

www.zxforums.com/.../zx-7r.../37625-zxr-750-alternator-belt-change.ht...Jun 3, 2010 - Hey there is no belt the bike just had a seperate alternator like the early zx9's and it fits the engine and is driven by a gear off the crankshaft so ... Alternator belt adjustment on 1989 zx7 - ZX Forums
Apr 28, 2015
H-model alternator belt adjusting. - ZX Forums
Sep 21, 2012
89 zx-7 Engine Options - ZX Forums
Feb 29, 2012
1990 zx750r - ZX Forums
Oct 11, 2011
More results from www.zxforums.com

kawasaki diagram replacing alternator belt Questions ...

www.fixya.com/tags/diagram_replacing_alternator_belt/browse/kawasaki
kawasaki diagram replacing alternator belt related problems. ... ZXR750 H1/H2 - need above to find if bike has rectifier/regulator, to run continuity test on it, ..

Sep 06, 2015 | kawasaki ZXR 750 Motorcycles

1 Answer

What is the right order from left to right for spark plug leads for 1989 kawasai zxr 750 h1 they r number 1to 4 is it the sameorder as the ignition coil


if they are numberd they should be put on 1234 sat on the bike left to right ....left being cylinder1

Mar 04, 2015 | Motorcycles

1 Answer

Kawasaki ZXR 750 H1, clutch lever goes hard and then cluch starts slipping. If I allow air in to the master cylinder on the motor the clutch would be finr for a few day and slowly start hardening. What...


Bleed clutch. Left hand side where gear shifter is (zx7r) you may see your clutch set up (Fluid set up that is??). Be a nipplpe just like calipers. Pump clutch / slacken - tighten etc etc. Replace fluid totally - I found it goes clloudy and like rat p**s, hence no pressure?

Sep 19, 2012 | 1989 kawasaki ZXR 750

1 Answer

1897 Yamaha Fzx 750 runs but stalls when put in first gear. Was working yesterday...


Saftey circuit issue! check clutch switch, side stand switch and wiring these are connect to the neutral light switch and the 3 are part of the saftey circuit,
circuit is designed to cut the bike out if the stand is down and you kick it in gear also to stop the bike turning over & jumping forward when you hit the starter and its in gear and the clutch isnt pulled in.

weak stand spring my not be pulling stand onto the stand switch correctly there fore no making the curcuit, switches just make and break the curcuit.

Aug 30, 2011 | 1989 Yamaha FZX 750

1 Answer

Timing problem zxr750h1


Hi Darren, it's Chris. I'm tipping you'd like to have exploded view diagrams of every part of the motor then......

http://www.cmsnl.com/kawasaki-1989-h1-zx750_model12897/partslist/ Brilliant site this!

Otherwise do a search for manuals thru these Fixya links about manuals, or search "ur model name" forums for links about tuning etc......that's why I have a laptop in the bike shed!
Cheers.

May 02, 2010 | 1990 kawasaki ZXR 750

2 Answers

What kind of spark plug does my 1989 zx 7 h1 use


C8E(NGK) and the C9E(NGK) will fit US or Canada bikes. CR8E and CR9E (NGK) Canada only.

Mar 23, 2010 | 1990 kawasaki ZXR 750

1 Answer

Kawasaki zxr750h 89 model: Yesterday I road my bike with no problems, Today morning I decided on using her to work, started her up with no problems, put the bike into 1st gear released the clutch to take...


u sound smart n thanks for goin oldschool-1st buy a manual-thats how the pros work--in bike yrs its in its 50's-parts wear out-try ajustin cable n then do clutch itself-that does not help-rebuild is probable

Sep 01, 2009 | 1989 kawasaki ZXR 750

1 Answer

Where do I find the netural start switch on my 89 zxr250?


The neutral switch is mounted in the left end of the shift drum. It is part number 13151-1080. There is an associated part, "PIN-neutral position" #92043-076 The pin is under a bolt screwed into the top case. Bad switch or loose wire connection.

Please rate this answer. Thanks!

Apr 19, 2009 | 1989 kawasaki ZXR 250

1 Answer

Clutch lever sudenly becomes hard to compress after short run????


I would not trust that clutch cable. Chances are it is pretty old. It could leave you stranded in traffic. Get a new, worry free, clutch cable. Also, change the gearbox oil, 10w40, and install a new oil filter. The gearbox oil could be dirty and gritty and impeding the operation of the clutch.

Please rate this solution. Thanks!

Apr 07, 2009 | 1989 kawasaki ZXR 750

Not finding what you are looking for?
1989 kawasaki ZXR 750 Logo

194 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4535 Answers

yadayada
yadayada

Level 3 Expert

76630 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...