Question about 2002 KTM LC4 640 Adventure

1 Answer

IVE GOT A ktm lc4 640 2000. starts ok runs ok, when riding come to a stop bike stalls,stars back up ok drives off i come to another stop bike stalls again.also starter moto work spins thr gear but wont turn bike over please can you help thanx from kevin

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

Haw is your idiol speed is it low . it sounds like the starer cluch is sliping you need to remove it and check it out for were

Posted on Jun 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Will not shift into first gear


Sounds like your clutch is out of adjustment, or needs to be bled. Most of the ktm's use a Magura hydraulic clutch which can be bled using Mineral Oil. DO NOT USE BRAKE FLUID.

Jul 30, 2013 | KTM Motorcycles

1 Answer

2011 ktm250 sxf wont start


i have a 2009 ktm 450 sxf and was riding yesterday and it stalled out when i switched to fourth gear and wont start back. battery is good and when i hit the e start it just clicks once, and it wont roll start either. any suggestions? could it be the switch under the tank? PLEASE HELP!

Sep 24, 2012 | 2008 KTM 250 SX-F

1 Answer

Ktm 250 xf 2006, riding fine then i slowed down, there was a bang and engine stopped and wont start. Can push bike, took heaqd off and pistons seem fine and no debris lying about. Any ideas?


ya very similar thing happened to me at a trials meet started my vintage kawasaki kt and it warmed up fine then took it for a run heard a bang and it wouldnt re start turned out i broke the crank shaft right in half there for the bike would push but it wouldnt start easy fix just found a crankshaft and it worked great probably was a clean break wich explains why there is no debris

Feb 26, 2012 | KTM Motorcycles

2 Answers

Engine stalls when put into first.No slack on clutch cable. Bike not used regularly.


check your idle speed.you should have about 1 cm of free play in the lever.also does it start up agian and are you able to drive it if not check your side stand switch

Oct 18, 2009 | 1994 Yamaha XV 535 Virago DX

1 Answer

I have an 04 yamaha v star silverado classic cruiser with a stalling no start issue! here is what happens i recently installed new battery connections cleaned and tighten and took bike for a drive while...


It's your stator failing, these bikes are notorious for bad stators. A failing stator means the bike can't produce the electricity it needs to run, and the bike is running on the battery only. Replace the stator and make sure your battery is fully charged and you will be good to go.

Sep 01, 2009 | 2004 Yamaha V Star Silverado

2 Answers

I just bought a 2009 ktm 450exc new from dealer ran bike 8th of throttle bike has no power runs poor. sent bike back twicethen they gave me a new bike perfect runs great now. it overheats at lights i see...


Take the bike back to the dealer. The problem with KTM bikes is that they are so highly engineered that most riders, ( and most dealers ), have a problem getting them tuned properly. Since the bike is new, the carb should not be the problem. Don't mess with it. Have the dealer check the radiator for proper coolent level and coolent flow. If the bike has a fan, check the sensor and fan operation.

Can I get a “very helpful” rating on this answer?

Aug 09, 2009 | 2008 KTM 450 EXC-R

Not finding what you are looking for?
2002 KTM LC4 640 Adventure Logo

Related Topics:

457 people viewed this question

Ask a Question

Usually answered in minutes!

Top KTM Experts

kevmx2003

Level 2 Expert

86 Answers

yadayada
yadayada

Level 3 Expert

60667 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Are you a KTM Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...