Question about 2003 Harley Davidson FLHRCI Road King Classic

1 Answer

Which fuse goes to the brake lights on 2003 road king

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Harley Davidson Master
  • 42,887 Answers

Hi Anonymous, the that says lights. Have nice day.

Posted on May 20, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
RALilja
  • 384 Answers

SOURCE: 2004 FLHRI ROAD KING BRAKE LIGHT IS STUCK ON.

Hello,
There is 2 switches on your bike (like most motorcycles) and one of them is stuck on, broken, or the linkage to it is damaged!

The Front switch is actually part of the master cylinder /lever, and the rear switch is actuated when the right side brake pedal is depressed.

You will need to take a multimeter and check them both for a short with no power on using an ohmmeter. Another way is to disconnect the plug going to the switches & check the brake lite to see if it goes off & if it does that particular switch is in trouble and may need to be replaced.

Posted on Dec 28, 2008

  • 1 Answer

SOURCE: brake light stays on

hand break switch was broken (inside the wire housing) not allowing the hand break lever to deactive, therefore causing the brake system to stay on.

Posted on May 18, 2009

  • 16 Answers

SOURCE: lower a 2003 harley road king standard

if you lower the front of the bike the same as you lower the back of the bike the only thing is dragging the pegs when you corner i have slammed one to about 2 ins off the ground

Posted on May 27, 2009

  • 1 Answer

SOURCE: Oil change directions, 2003 Road King

The drain plug is on the left side of the oil reservoir pointing towards the front of the bike. The motor should be warm when you dump the oil and the o-ring should be replaced as an extra precaution (don't want to waste that new oil if you have a drip). When replacing the oil filter use a piece of tin foil to divert the oil to your waste pan.

Posted on Jul 23, 2009

wd4ity
  • 4565 Answers

SOURCE: Rear brake light not workiing

There are two brake light switches. One is in the right handlebar switch housing. This is front brake light switch and is a simple push button type switch actuated by the front brake lever.

The other switch is a pressure switch and it is located in a Tee usually somewhere under the bike near the rear of the transmission. Follow the metal tube coming out of the rear of the master cylinder. It will go back towards the rear brake. Somewhere in that line there will be a tee with the pressure switch in it. If you jumper across this switch, the brake light should work. If it does work when you do this but not work when you depress the rear brake signal, replace the rear brake light switch.

Good luck
Steve

Posted on May 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do you repair leaking transmission oil on 2003 road king?


Take out the screws, drain the oil, remove the gasket and use brake cleaner to clean the thread holes and screws. Then put sealer like permatex on the gasket and the screws and put in back together.

Jul 26, 2014 | 2003 Harley Davidson FLHR Road king

1 Answer

Harley problems


the brake is damaged or the engine is old

May 22, 2014 | 2003 Harley Davidson FLHR Road king

1 Answer

Stuck rear caliper on my 2003 road king classic


Did u try bleeding the brake lines and flushing them? It just might me some dirt in there if that doesn't work you might have to replace it?

Apr 22, 2014 | 2003 Harley Davidson FLHR Road king

1 Answer

2003 Harley Road King Brake light stays on


Hi Anonymous, try checking your brake light switches for continuity. Good luck

Jan 01, 2014 | 2003 Harley Davidson FLHR Road king

1 Answer

Brake light don't work replaced all fuses, what do i do? 2005 Road King FLHR


If neither the front brake nor the rear brake will make the light come on, I would suspect the bulb if the fuses are not blown.

Steve

Jul 23, 2010 | 2006 Harley Davidson FLHR Road king

1 Answer

2001 Road King Classic. Brake light stays on. Have to push front brake lever forward after braking.


you may need to check the switch that the lever presses to...it has a small wiring connection to it and you cannot miss it.Now I assume that you mean you have to push the lever back then the light goes off...If this is the case then you caliper or braking needs to be looked as the spring mechanism that brings the lever back into rest position is not working..

Jan 10, 2010 | 2001 Harley Davidson FLHRCI Road King...

2 Answers

I have a 2003 road king that the break lights don't work when I press the breaks either on the break pedal or on the handle bars.


Check your brake selenoid, which should have a electric connection. This connection sends a signal to the brake light selenoid that the brakes are being applied there by turning the brakes lights on.

Jan 23, 2009 | 2006 Harley Davidson FLHR Road king

1 Answer

2004 FLHRI ROAD KING BRAKE LIGHT IS STUCK ON.


Hello,
There is 2 switches on your bike (like most motorcycles) and one of them is stuck on, broken, or the linkage to it is damaged!

The Front switch is actually part of the master cylinder /lever, and the rear switch is actuated when the right side brake pedal is depressed.

You will need to take a multimeter and check them both for a short with no power on using an ohmmeter. Another way is to disconnect the plug going to the switches & check the brake lite to see if it goes off & if it does that particular switch is in trouble and may need to be replaced.

Dec 28, 2008 | 2006 Harley Davidson FLHR Road king

2 Answers

Wiring diagram for tourpak on 2003 Harley Road King Ultra Classic


hey first off harley has a harness that will plug in the accessory outlet under the seat, now to the speakers you didnt say if you had a stero or what, now you would run speaker wire from the source to the speakers you can get the male portion (i believe)of the plug at the hd shop or just go to radio shack and get plugs(male-female) there and just soilder them shrink tube the connection hope this helps

Nov 30, 2008 | 2003 Harley Davidson FLHRCI Road King...

Not finding what you are looking for?
2003 Harley Davidson FLHRCI Road King Classic Logo

Related Topics:

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4533 Answers

Mike

Level 3 Expert

4340 Answers

yadayada
yadayada

Level 3 Expert

76630 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...