Question about 2011 TVS Scooty Pep Plus

1 Answer

The back wheel is bobling always in uneven road

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Expert
  • 314 Answers

What is the name please rate these

Posted on Jan 16, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What does it mean when your front wheels are not parallel? Driver side points straight forward and the front left points a little to the right.


It means that your front end is out of alignment. The front wheels should be adjusted so that both point slightly inwards at the front of the car when the steering wheel is straight. This is referred to as "toe-in." The reason why cars and trucks are aligned with toe-in is because the wheels go to a straight position when traveling on a highway due to the road resistance pushing the tires back. What you have is a "toe-out" condition which will cause the tires to wear faster at the side adjacent to the back of the wheels. Have your car aligned to avoid such uneven wear.

Feb 22, 2015 | 2002 Chevrolet Impala

1 Answer

What caises the steering wheel to shake


1# One or both front wheels out of balance
2# Uneven wear on front tires
3# Buckled/ out of round wheel rims
4# Lose wheel nuts
5# Lose front wheel bearings
6# Warn or lose front end components

Feb 17, 2015 | 2007 Chevrolet Chevrolet Impala LT

1 Answer

Burning smell, very hot and all 5 lug nuts loose on same wheel


Your brake caliper and/or brake hose is hanging up not allowing fluid pressure to release. Most likely your brake rotor is already warped from excessive heat also. Replace caliper(loaded or unloaded) and hose ,bleed brake system and you're good to go.

Apr 23, 2014 | 2003 Toyota Celica

2 Answers

Vibrations in top bar as you cycle


Bicycle noises in bicycles can come from anywhere. Cables, loose parts, or debris from the road itself could cause those noises. I would bring the bicycle to your local bicycle shop to have it diagnosed.

Apr 05, 2014 | Merida Cycling

1 Answer

4wd troubleshooting


Binding up the gears while in 4wd is prevalent when operating on hard surface roads where the wheels are not allowed to slip to relieve the pressure from the uneven road surface. 4WD is mainly for use on dirt roads -snow- ice- bogs-sand etc where the wheels can equalise out the loads . To prevent the problem only use 4wd in those situations.

Jan 09, 2014 | Ford Cars & Trucks

1 Answer

My Yukon ABS brakes keep me from stopping on uneven roads and in turns


if this issue is at low speed roughly five to ten mph it is a sign of a bad wheel bearing as the abs speed sensor reads off of a tone ring attached to the front bearings, when the bearing gets too much play it causes the sensor to receive an eratic signal making the on board computer activate the abs thinking the vehicle is sliding

Aug 03, 2012 | 2001 GMC Yukon

1 Answer

When going round a sweeping right hand bend the back end tries to swing out.also on uneven roads thre is excesive bounce and roll.


You didn't say what model and year the vehicle is. Check the rear sway bar end links. They connect the two rear wheels together and act to push the wheel down towards the ground in a turn. If either of the links are broken, then the whole system is compromised.

Jun 05, 2011 | Ford Focus Cars & Trucks

2 Answers

SERVICE TRACTION SYSTEM LIGHT KEEP COMING ON AND WHAT WILL IT TAKE TO FIX IT. WHEN MAKING A HARD RIGHT TURN, AND WHEN BACKING UP ,ALSO HITTING BUMPS IN THE ROAD.


one of your front wheel bearings has a bad abs wheel sensor and will have to be replaced use an ohms meter to find out which compare readings to the back sensor all should read the same, which ever is off is bad.it is part of the wheel bearing.

Nov 16, 2010 | 2004 Chevrolet Impala

2 Answers

Uneven tire wearing in rear. new shocks or springs?


There are a multitude of ways a tire will wear unevenly and they all have unique causes. You can take it to a good tire shop and they will be able to diagnose what your specific problem and solution are.

Regards,
matt

Sep 15, 2009 | 2004 Mazda 3

Not finding what you are looking for?
2011 TVS Scooty Pep Plus Logo

Related Topics:

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top TVS Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

David Payne
David Payne

Level 3 Expert

14161 Answers

Milton Scott

Level 1 Expert

23 Answers

Are you a TVS Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...