Question about 1980 Honda GL 1100 Innerstate Gold Wing

1 Answer

How do i turn idel down - 1980 Honda GL 1100 Innerstate Gold Wing

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

MAKE SURE YOUR THROTTLE CABLE IS NOT TOO TIGHT FIRST.
IF THATS NOT THE PROB, THERE ARE IDLE ADJ SCREWS ON THE CARB TURN COUNTER CLOCKWISE TILL ITS WHERE YA WANT IT

Posted on Jan 15, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Truck starts but died when i hit the gas


in my 03 1500hd had real rough idel clean the throttle body my truck idels perfectly now dosent take 30min and throttle body cleaners 8$ at autozone theres how to videos on youtube thats what i did

Jul 07, 2012 | 2002 Chevrolet Silverado 1500HD

1 Answer

High idel


check if all vacuum air OK . check the idel air Beside idel control .check the agr . or you have bad voltage regulator .

Nov 20, 2011 | 1999 Dodge Ram 2500 4WD

1 Answer

How do u turn the idel down ideling to high


the idle is computer controled and is not adjustable, if the idle is not correct then you must have a computer problem most likely a bad idle control motor....have some oneretreve the trouble codes and that should lead you to the cause of your problem....good luck

Aug 18, 2011 | 2004 Dodge Grand Caravan

1 Answer

Idels high shifts hard and that is like every other time started put in new ecm and still have the issue


Your describing a vacume leak or a mis adjusted throttle body. Does it ever idel down? What engine is in it Desiel? If it's gas the AIS motor might be sticking or is bad. Does it run and is the check engine light on? are all the fluilds correct level? coolant level low can make the coolant senser lie about the temperture of the motor to the ecm and it'll command a high idel. Once the idel motor goes as high as it can it might be shicking and you can remove it and wash it off with carb spray and while it's out with the wire connected turn the key on and off with it in your hand and spray it with cleaner till it moves smoothly. With it retracted install it and try again, any vacume leak will make it idel fast. The trans mission will shift hard if the vacume line to it is off and it's on the back of the intake manifold and it goes to a modulater on the side of the trans. it can be off there too.

Dec 19, 2010 | 1995 Chevrolet Suburban

2 Answers

When startn car engine cold idels high to low ,up


sounds like the throttle position sensor, I think that is the one that makes it idel rough

Apr 10, 2010 | 1987 Lincoln Town Car

1 Answer

Does the pilot screw alter the air intake on the Carburetor of a gsxr 750 slingshot 1988 model


Certainly you best adjust these screws with a vacume gauge set connected and set them all the same as the gauges dictate as the number of turns out is just where you start. The sync needs to be set first with the idel turned up too high when it's right turn the isel back down and check again as the idel is low nows the time to correct differences with the idel mixture screws. As the idel mixture is always on they effect the total mixture at all enf=gine speeds but lesser so at high speeds only noticeable at the gas pump carefully cheaking

Dec 04, 2009 | 1988 Suzuki GSX-R 750 J

1 Answer

I want to turn carby ae 92 down it is ideling to high as


on your carb you will find 2 screws 1 is a thritle stop screw the outher is the mixture screw the ajustment y need is the throttle screw hope this helps

Nov 15, 2009 | 1989 Toyota Corolla 2 Door

1 Answer

Hard starting first time and ideling rough RPM jump up and down about 500 sometimes when it's put in reverse to exit the garage it stalls. It also smells of gas when started. I have replaced all the...


i have a 1986 chevy corvette, when you fist start the motor it idel fine, when it wormes up, it ideling rough and RPM jumps up and down, and you can smell gas when you fist statrt it but there is no leaks,also when your driving about 45mph it puags down until you push it and then runs fine. please help me with this issue.

Sep 08, 2009 | 1990 Chevrolet Corvette

3 Answers

Need info on rough idel 5.9 cummins


bad injector?
easy to test with vom, just check from terminal on injector to ground if one reads different thats the problem, you do need to disconnect wire to check, my help is free and will be glad to help further just vote fixa..LOL my rating is all I care about. Hope yu can help me too.

Dec 19, 2008 | 2004 Dodge Ram 2500

Not finding what you are looking for?
1980 Honda GL 1100 Innerstate Gold Wing Logo

93 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...