Question about Motorcycles

Open Question

My suzuki quad master 50 won't run with fuel spark and compression

Posted by Anonymous on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
oldmanewtoys
  • 414 Answers

SOURCE: 1995 suzuki sepia 50cc 2stroke doesnt run

Two strokes are bad with fuel/oil mixure. If this is premix theres a problem,if injected you may not be getting oil injected. Topends will heat up fast without oil. Fouled plugs and the wrong gap will also cause these problems. Check carb boot for cracks as air leaks will also starvel fuel out. Spray WD40 into carb throat with out tank hooked up, if it fires up, clean carb and reset float. Make sure the spark gap is correct. Check to be sure you have not slipped a keyway on flywheel which would throw timing off and it will only start by accident once every so often.

Posted on Feb 25, 2010

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I've got a 2006 Suzuki eiger 400 4wd. I've been rideing it all day, and now it will not start. Even pull start.what could be the issue?


Repair and Maintenance [Archive] - Page 4 - Suzuki ATV Forum

www.suzukiatvforums.com/forums/archive/index.php/f-23-p-4.html
1992 King Quad High Idle Issue · kill switch · quad master 500 wont run · Spark ...2006 suzuki vinson fuel gauge shows empty · 87 LT-4WD L.H cover removal: ... 07 Kingquad 700 Starting and electrical issues · 2002 Eiger 400 won't go into ...

Nov 23, 2015 | Suzuki Motorcycles

1 Answer

2005 suzuki 700 king quad manuals


determine if you have spark and are getting fuel

May 04, 2013 | Suzuki 2005 KingQuad 700 4X4

1 Answer

1996 Suzuki DT30C outboard- won`t start. I installed a starter last week. It ran great. Now it won`t even cough, nothing. I pulled out the kill switch & cheked, it has connectivity.


Check for compression. If it has fuel and spark and compression it should fire. If the compression is low it will not run.

Apr 17, 2012 | Motorcycles

1 Answer

Engine wont start it is getting spark and fuel any other reason why it won't start


You need 3 things for an engine to run; spark, fuel and compression. How is the compression? Is the spark plug new? If the plug is old, it could give a nice spark when you check it but have no spark under compression. Make sure the fuel you're using is fresh. If you give it a small shot of starting fluid and it fires up, your fuel delivery is suspect. In that case, you will need to remove the carb an THOROUGHLY clean it paying close attention to jets and passages. I always give people this warning: when cleaning jets and passages, NEVER use steel instruments. Use wood, copper wire or other materials that are softer than the material you're working on or you run the risk of ruining jets or even the entire carburetor.

Jun 27, 2011 | Suzuki SV 650 Motorcycles

1 Answer

Quad wont start got spark got fuel and got compression


If it's a 2 stroke you have a crank seal out. It can have compression but won't have vacuum, and it won't run. Sometimes the seal can be replaced on the magneto side without splitting the cases, but I'd rebuild the entire motor and replace the crank bearings along with the seals. Good luck!

Jun 07, 2011 | Cobra Snake Furious Motorcycles

1 Answer

I have a 1981 suzuki gs 750 engine on a quad. i finally got it running but it runs poorly. i cleaned the carbs twice and put new spark plugs in it. its running on the two cyclinders that farthest away from...


Is the fuel tank located above the carburetors at about the same level as the original bike? If not, you may have to install an electric fuel pump to get the pressure at the carburetors about the same as the original bike (guessing about 1-1/2 to 3 PSI). I assume that you have checked things like firing order, timing, throttle slide balance, compression, and equivalent exhaust system. Did you see and hear the engine run before you installed it into the quad chassis? Hope some of this helps!

Jul 09, 2010 | 1981 Suzuki GS 750 L

1 Answer

My suzuki lt 50 wont run under load... rings new... good compression, carb clean... what else to look for?


9/10 time it is fuel related not enough fuel. Check the screws on the fuel valve if it is too tight it squish the rubber and whola no fuel.

Also try to run it with a bit of choke on, if it runs better then it is fuel starvation.

Nov 08, 2009 | RTO Mini Quads

4 Answers

I have a new 50 cc mini quad for my kids and its bogging so bad it wont move my 4 year old? {2 stroke}


Try changing the spark plug making sure the gap on the new plug is at recommended specs.If the plug is black when you pull it out mix gas with a little less oil but not much as if it is to lean it can burn up motor make sure gas mixtured isn't to rich if you have to mix the gas and oil together yourself.

Sep 02, 2009 | RTO Mini Quads

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4525 Answers

yadayada
yadayada

Level 3 Expert

76164 Answers

kakima

Level 3 Expert

102366 Answers

Are you a Motorcycle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...