Question about 2007 Bajaj Pulsar 150

1 Answer

I have a prob with my pulsar 150 2003(sorry to ask)

It is running awefully bad.as i slow down the engine starts struggling giv dhak dahk type voice mat be because of tappets.it struugles a lot when sum one sits at back.it does not go over 80(dat to i have to struggle a lot).what shuld i do.I plan to change the filter K&N (which one),change the spark plug,its wire,free flow exhaust.the tyres and allows .its sprocket chain of the new fz 16.can u suggest anyhting whichis excess or left or any thing which is being getting over?

Posted by on

  • safzal71 Apr 27, 2009

    i have a problem with my pulsar
    when i start my bike and go on the road then my bike was off
    then start again off
    this is the reason i get so what will i do

  • Sikander Shaikh Feb 14, 2013

    set ur tappets first by good mech....

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 153 Answers

Thew engine head valves must be changed according to reconditioning

Posted on Feb 11, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ticking sounds engine


run fault codes and look for knock sensors or other sensor problems.

Oct 28, 2013 | Cars & Trucks

1 Answer

I am getting the noise like tok tok tok / dhak dhak dhak some thing like that. i change my shaft still same noise what can i do


Is your car throwing any CEL? (Check Engine Light)
It is hard to determine your question's adjective as it is only text. Could you expound on your question further?

Sep 18, 2012 | 2001 Subaru Impreza 2.0

1 Answer

My x-type diesel has been struggling for a few months running poorly and struggles to start (more so when warm). Jag told me the EGR and inlet manifold was coked up - which I have now cleaned. runs much...


COULD HAVE BAD FUEL WRONG TYPE FUEL COULD NEED NEW AIR FILTER. DIESEL ENGINE NEEDS AIR TO OPERATE.IF AIR FILTER RESTRICTED.DIESEL ENGINE WONT RUN AND CLOGGED FUEL FILTER CAUSE STARTING PROBLEMS PROBLEMS WITH TURBOCHARGER OR TURBOCHARGER ACTUATOR WOULD CAUSE ENGINE RUN VERY SLOW NO POWER ON TAKE OFF.I SAY PROBLEM IN FUEL SYSTEM OR AIR INTAKE SYSTEM.IF YOU HAD ANY OTHER PROBLEMS THE CHECK ENGINE LIGHT WILL FLASH ON.

Sep 19, 2011 | 2005 Jaguar X-Type

2 Answers

I have bajaj pulsar which has run 40000 kms...and now suddenky i have a prob..my bike after travelling few KMS suddenly stops and doesnt start for next 10 -15min..and then suddenly starts again..and this...


check ur engine head and clear the head or piston and valve,then clean carburetor and air filter.and then the problem is still change ur starting coil or cdi. thank u.

Jun 28, 2011 | 2005 Bajaj Pulsar 150

2 Answers

Knocking sound from engine ever since i ran out of OIL ....


Hi, the sound is as a result of low or no oil and a loose piston skirt...

May 12, 2011 | 2005 Bajaj Pulsar 180

1 Answer

Wont stay running. it idles kinda high. stays running with the choke on. pull the trigger 2 giv it gas it dies.


Check the fuel filter, air cleaner, and muffler for plugging. Check the fuel lines for decay or other problems. The idle speed screw (turned CCW) will slow the engine down. Hope this helps!

Nov 08, 2010 | Poulan Pro Chain Saw 46cc 20"

1 Answer

My bikes engine is running fast how to slow it down bajaj pulsar 150 cc from last few months local mechanic is unable to fix the problem


this sounds like you may need to clean out the carbourator with carbflux, you then should be able to adjust the idol which will overall lower your engine speed.

good luck and safe riding

Sep 07, 2010 | 2005 Bajaj Pulsar 150

Not finding what you are looking for?
2007 Bajaj Pulsar 150 Logo

249 people viewed this question

Ask a Question

Usually answered in minutes!

Top Bajaj Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4509 Answers

Joseph Gallucci

Level 2 Expert

120 Answers

Are you a Bajaj Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...