Question about 2007 Harley Davidson FLHX Street Glide

1 Answer

2007 flhx starts,but cuts off on take off.

Bike starts up and idles like normal,but when i release the clutch it stalls.start up,stalls when i take off.if i ease the clutch out i can roll slowly,but as soon as i try to accelerate it stalls.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Does the bike run if you give it throttle past idle? The motor should accelerate and gain RPM's when doing so. If it does and gains RPM's but is sluggish in response, I would check to make sure it has good gas flow. Check flow off the petcock, if good, check gas filter on the motor side. If still not running correctly, I would check the air cleaner inside to make sure some critter didn't get in there and make a nest or something. Beyond those ideas, I would bring it to a profession shop or a friend in the know.

Posted on Jan 16, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 5 Answers

SOURCE: Oil pressure gauge shows a sudden drop to zero,

Here is some info on a sensor hope it works39b5b60.jpg

Posted on Aug 10, 2010

SOURCE: changed handle bars on 2009 flhx street glide -will not start

I would be inspecting the kill switch. Only thing on the bar that could be it other than the start button.

Posted on Nov 19, 2009

stephensaon_
  • 284 Answers

SOURCE: How to remove idle jet?

The idle jet is located in the bottom of the car. it's the recessed one in the bottom of the body. Remove your air cleaner assembly. remove the four screws. Be careful because it will be full of gas. ( well vented area.) You'll have one jet sticking out. That's your main. right next to it is a recessed jet . That is your idle. you'll have to use a small flathead screw driver to get it out. Make sure you have god pressure on the jet to break it loose. The jet itself is brass, and you don't want to mess it up. You should probably have a 45 jet with your combo. if you've been messing with the mixture screw it should be set around 1 & 1/2 turns out from lightly seated.

Posted on Jun 27, 2009

  • 1 Answer

SOURCE: 2007 sporster turn signals flasher , bike wont start

He's right! The key fob for the security system needs a clear signal to the module to disarm the bike. That's why the flashers turn on. If the fob is at the bike, the security module has lost it's memory, or the antenna for the key fob reception is not connected. You also need to squeeze the clutch lever to allow the engine to engage also...new safety feature i think for 07. Hope this helps.
david

Posted on Aug 08, 2009

wd4ity
  • 4565 Answers

SOURCE: It will stall out when

If your bike is stalling out when the engine is cold, this is typical of a carburetor equipped engine. You need to run a little longer with your enricher on. After it warms up, if it's still stalling out, remove the outer air filter cover and look at the upper right of your carb. There is a screw there. This is the throttle stop screw. Turn it clockwise to increase the idle speed. Set the idle speed when the engine is at full operating temp.

Good Luck
Steve

Posted on Feb 26, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2007 cbr600rr, and I have noticed lately my bike idles around 1900-2000rpm, normal is around 1400-1500rpm(this is when the bike is warm), also when using the engine for braking it feels a little...


Hi, Anonymous and the usual suspects are:
1. Throttle cables improperly adjusted, pinched or need lubrication.
2. Idle adjusting screw needs to be backed off.
4. Air fuel mixture adjusted too lean start with 2 full turns.
5. Intake system air leak.
6. Fast idle choke ramp is not releasing.
7. Broken throttle return spring.
8. Damaged diaphragm or slide.
9. Faulty MAP, TPS, ATS, O2, sensors or wiring/connector
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
2007 Idle Issues
How to Adjust the idle on 04 06 cbr600RR
2007 2009 Honda CBR600RR Service Manual Moto Data Project
http://www.partsfish.com/page/oem-parts-for-honda
Honda CBR600RR 2007 Owner Manual

Jun 01, 2017 | 2007 Honda CBR 600 RR

1 Answer

Kawasaki 450r


I had a similar problem on one of my bikes. Turned out a "Test Port" had rattled loose between the carb and the intake. I threaded a screw in the hole to prevent the leak and problem was resolved.

Apr 02, 2014 | K and N Kawasaki Kfx450 Kfx450r K and n...

1 Answer

Starts stalls


contaminated or water in the fuel is most likely the culprit here.
drain the tank and carb (small screw at bottom of carb float bowl)
Add fresh fuel from a CLEAN fuel source. Best to completely drain your fuel can and fill it up with fresh fuel. That way if the fuel can is the culprit you eliminated doing this twice.
What happened was fuel sits on top of water, this is why the bike would still idle. The idle circuit in the carb pulls fuel from a higher point than the main jet. This is also why when you hit the throttle it would just die, it was sucking most like something other than fuel.

Apr 02, 2014 | kawasaki KX 450 F Motorcycles

1 Answer

Fuel injection


My 2007 FLHX has had problems starting and today it died as I was going thought the gears hard, the same thing I found from the starting problem, if you push up on the what used to be called the pet cock you can here the fuel pressure release and my bike starts right up. I think I have fuel regulator problem.

Jul 17, 2013 | 2007 Harley Davidson FLHX Street Glide

Not finding what you are looking for?
2007 Harley Davidson FLHX Street Glide Logo

242 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

Mike

Level 3 Expert

4339 Answers

yadayada
yadayada

Level 3 Expert

76070 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...