Question about Harley Davidson FXDBI Street Bob Motorcycles

1 Answer

Does streetbob 2008 have an oxygen sensor - FXDBI Street Bob Harley Davidson Motorcycles

Posted by Anonymous on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    One Above All:

    The expert with highest point at the last day of the past 12 weeks.

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.

  • Harley Davidson Master
  • 48,460 Answers

Hi Anonymous, if you see any electrical wires coming off your head pipes then yes. Have nice day.

Btw, I’m available to help over the phone in case u need at

Posted on May 30, 2015


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

On a 07 jeep patriot where is the down stream 02 sensor fuse located?

Hi Daniel,here's a video showing you how to replace your oxygen sensors. 2008 Jeep Patriot O2 Sensor Replacement Here's a link to your sensors. Bosch Oxygen Sensor 15124 Read 1 Reviews on Bosch 15124 They are both the same.Here's a link to the other one which is the same part number. Bosch Oxygen Sensor 15124 Read 1 Reviews on Bosch 15124

Jul 28, 2017 | Jeep Cars & Trucks

1 Answer

Location of oxygen sensor bank 1 in acura mdx 2008

its on the side of the motor that cylinder #1 is on in that exhaust pipe that comes off that head. its the first exhaust sensor that you come to when you follow the exhaust pipe.

Jun 24, 2015 | 2008 Acura Mdx

1 Answer


code p0159 refers to heated oxygen sensor(HO2S) 2 bank 2 --slow response Same for the oxygen sensor (O2S) ==causes --heating inoperative -wiring--HO2S sensor for the HO2S sensor and for the O2S sensor --wiring and sensor fault.

the HO2s sensors are before the cat convertor and the O2 sensors are after the cat converter.

Aug 14, 2014 | 2008 Ford F-250 Super Duty

1 Answer

How to change upstream o2 sensor on 2008 chevy uplander 3.9l ?

  • 1 Warm up the engine for about four minutes to bring it to operating temperature. Then turn off the engine. This will avoid damage to the exhaust pipe threads if that sensor has seized to the pipe.
  • 2 Find the oxygen sensor or sensors you need to replace. The upstream sensor is located near the exhaust manifold and the downstream sensor on the back exhaust pipe, close to the catalytic converter.
  • 3 Disconnect the oxygen sensor electrical connector. Depending on your particular Chevy model, both sensors may be disconnected from the engine compartment.
  • 4 Lift the front of your Chevy model to reach the sensor you need to change, if necessary. Use a floor jack and two jack stands to support it.
  • 5 Remove the oxygen sensor using a box-end wrench or a ratchet and oxygen-sensor socket.

  • Read more :

    Jul 23, 2014 | Chevrolet Chevy Cars & Trucks

    1 Answer

    Where is the oxygen sensor 2008 hyundai tucson v6

    O2 sensors are usually mounted before and after the catalytic converters.

    Jul 10, 2012 | Hyundai Cars & Trucks

    1 Answer

    I have "Subaru Outback" 2008. "Check Engine"is on

    P0420 Usually indicates a bad catalytic converter or a bad oxygen sensor. Since you car is 2008 my money is on the oxygen sensor. Or it could be something as simple as an exhaust leak. The cruise control will keep flashing until you get the CEL fixed

    Oct 25, 2011 | 2008 Subaru Outback

    2 Answers

    Scanning codes

    Oxygen sensor response not as expected.Oxygen sensor response slower than minimum required switching frequency,code P0139 may mean that one or more of the following has happened:
    • The oxygen sensor is faulty
    • The wiring to the sensor is broken / frayed
    • There is an exhaust leak
      • Check and fix any exhaust leaks
      • Check for wiring problems (shorted, frayed wires)
      • Check the frequency and amplitude of the oxygen sensor (advanced)
      • Check for a deteriorating / contaminated oxygen sensor, replace if necessary
      • Check for inlet air leaks
      • Check the MAF sensor for proper operation ,I hope this helps

    Oct 18, 2009 | 2008 Jeep Compass

    2 Answers

    Oxygen sensors, knock sensor

    it under intake goood luck

    Aug 11, 2008 | 2008 Infiniti FX35

    Not finding what you are looking for?
    Motorcycles Logo

    Related Topics:

    21 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Harley Davidson Experts

    Arnie Burke
    Arnie Burke

    Level 3 Expert

    4974 Answers


    Level 3 Expert

    4350 Answers


    Level 3 Expert

    80263 Answers

    Are you a Harley Davidson Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides