Question about 2005 Bajaj Pulsar 150

1 Answer

Pulsar 135 ls is causing auto choke problem ,in traffic after starting the bike it again increases to 4000 rpm,,,,,every start it occurs ,,how to deal with it????/

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    One Above All:

    The expert with highest point at the last day of the past 12 weeks.

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

  • Bajaj Master
  • 44,623 Answers

Hi, Anonymous you may need to overhaul your carburetor for this situation I would call my local dealer or reputable shop's service/parts department and inquire about any possible quick fix or parts inquiry. If necessary transport your vehicle to the dealer or shop and have a professional technician take it for a test drive, if it is in running condition, and give you a written estimate of repairs and answer any specific questions you may have about your issue. For more information about your issue please visit the website below. Good luck and have a nice day.
4 stroke motor Parts 50cc 70cc 90cc 100cc 110cc 125cc horizontal motor
DOWNLOAD Bajaj Pulsar Ls 135

Posted on Nov 19, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
mr_mahindra
  • 2 Answers

SOURCE: I have bajaj pulsar 150cc

This problem might b due to some block in your bik's carburetor better suggest ur mechanic to clean it up thoroughly and this may fix ur prob. Even then if ur having the same problem then change to a new carburetor...try 2 fix this problem as soon as possible else you ll get very low milage......

Posted on Dec 08, 2008

  • 6 Answers

SOURCE: Pulsar RPM or idling problem.

try getting the timing checked.

Posted on Dec 12, 2008

joboo1
  • 257 Answers

SOURCE: 97 cbr f3 choke and starting out problems

Hi, The mixture is too rich. Was the bike sitting for awhile? The carbs should be cleaned and adjusted. Good Luck!

Posted on Feb 19, 2009

  • 3567 Answers

SOURCE: cbr 125 choke problem

It sounds like the choke line may not have been routed correctly when the new one was installed. Remove the gas tank and check to see that the line is not being stretched anywhere along the way AND that the gas tank when re-installed is not stretching the line. The line may have been kinked when installed. Look at the mechanical movement of the choke at the carb. Does it operate freely? Remove the air filter and look inside the center of the carb, (you may need to use a small mirror for this), does it look like the choke is opening and closing properly when the choke is moved on and off?

Posted on Mar 14, 2009

dtci80
  • 125 Answers

SOURCE: In pulsar200 2009 model, How to increase the pickup,power,Speed?

Hi,

Check your gasoline filter if there's one, check the air filter, also check or just replace your spark plug(s)...

Most other things that should be done by a mecanic are like maybe cleaning the carburator(s), checking the ignition, see wether there is damage inside the cilinder...

I hope this is helpful, and greetings,

Olivier.

Posted on Oct 22, 2009

Testimonial: "thank you sir"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2011 Bajaj Pulsar 135 DTSI engine stalls & loses compression completely when accelerated hard in morning.


Hi, James and the usual suspects are:
1. Improper valve adjustment.
2. Broken or loose cam chain.
3. Loose or broken cam sprocket.
4. Bent, burnt or stuck valve.
5. Blown head gasket.
6. Piston failure.
7. Broken connecting rod.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Got the motorcycle engine overhauled
How to Break in New Top End EnduroNut Method
Bajaj Pulsar 180 DTSi Workshop Manual
Shop At Bajaj PULSAR 135 Bike Parts And Accessories Online Store...
http://shahriary.staffcms.um.ac.ir/imagesm/1064/My_Pic/pulsar_135_ls.pdf

Jun 05, 2017 | 2011 Bajaj Pulsar 150

2 Answers

Bajaj pulsar 135 ls n light stay on after the key is removed from ignition,and how to adjust headlight


you have a faulty ignition switch which needs replacing hEADLIGHT IS ADJUSTED BEHIND the light

Jul 29, 2014 | 2011 Bajaj Pulsar 150

1 Answer

150 cc pulsar bike have a problem of start in 10-15 min the bike goes to start off where is the problem


Check your carburator and the Rpm gaugae increase your rpm guage its present under the fuel tank its like a nut try to tie it and then start it . If you are able to start well and good other wise consult me again

Feb 28, 2014 | Bajaj Pulsar 150 Motorcycles

1 Answer

My bajaj pulsar 135 cc over flow from carbs pipe ocassionally while running. Same problem occur 6 months ago i changed the needle valve which is fitted in carbs. should i change it again or not .


Hi, Mayur and the usual suspects are:
1. Damaged or restricted fuel tank venting system.
2. Loose float bowl screws.
3. Damaged float bowl o-ring.
4. improper fuel level in the float bowl.
5. Worn or dirty inlet valve or seat.
6. Damaged or leaking float assembly.
7. Particle contamination in inlet fitting cavity.
For more information about your issue please visit the websites below. Good luck and have nice a day.
How to rebuild your Chinese scooter carburetor
GY6 Carburetor Removal Inspection Adjustment START TO FINI DOWNLOAD Bajaj Pulsar 135
http://www.marutibajaj.com/pdf/PULSAR%20135%20LS%20SPC%20.pdf
http://shahriary.staffcms.um.ac.ir/imagesm/1064/My_Pic/pulsar_135_ls.pdf

May 22, 2012 | 2010 Bajaj Pulsar 135 DTSi

1 Answer

Pulsar 135ls parts catalog


Hi, Anonymous I am sorry you can't find the first and best tool you ever bought for your Bajaj but despair not for a mere $0 you can download another one. For more information about your issue, please visit the websites below. Good luck and have a nice day.
http://autos.maxabout.com/bikes/bajaj/pulsar/pulsar-135
http://overdrive.in/bike-overview/bajaj-pulsar-135-ls-2013-std
DOWNLOAD Bajaj Pulsar 135
http://www.marutibajaj.com/pdf/PULSAR%20135%20LS%20SPC%20.pdf
http://shahriary.staffcms.um.ac.ir/imagesm/1064/My_Pic/pulsar_135_ls.pdf

Apr 16, 2012 | 2010 Bajaj Pulsar 135 DTSi

1 Answer

Sir, i own a 2010 model pulsar135, my problem is that once the engine get hot(after riding 2-3km)its rpm suddenly increases while i pull the clutch or put it in nutral...engine idle at 1000rpm while ...


Hi, Sarath13 you may have an intake leak or binding throttle cable for this situation I would call my local dealer or reputable shop's service/parts department and inquire about any possible quick fix, answers, or parts inquiry. If necessary transport your vehicle to the dealer or shop and have a professional technician take it for a test drive, if it is in running condition, and give you a written estimate of repairs and answer any specific questions you may have about your issue. For more information about your issue please visit the website below. Good luck and have a nice day.
How to diagnose carburetor vacuum leaks on your motorcycle
How to lube your motorcycle throttle and clutch cable the cheapway
DOWNLOAD Bajaj Pulsar 135
http://www.marutibajaj.com/pdf/PULSAR%20135%20LS%20SPC%20.pdf
http://shahriary.staffcms.um.ac.ir/imagesm/1064/My_Pic/pulsar_135_ls.pdf

Sep 13, 2011 | 2010 Bajaj Pulsar 135 DTSi

3 Answers

I am using pulsar 135LS. Now i am facing auto choke problem. because the showroom assistant also dont konw how to solve. Kindly explain how to solve the problem


a choke system has a spring inside it which keeps on or off the system like a switch .u can bind that with a wire or something to avoid autochoke during jumps or ride.try out it will work.

Jun 09, 2011 | Bajaj VL50C Motorcycles

3 Answers

Pulsar RPM or idling problem.


sounds like when you say cold you mean very cold. If your choke has variable control on it try using more choke until the motor gets warm. Often times the cold weather causes a leaner condition because the air ppm is so much greater leaving you with a leaner running condition.

Dec 06, 2008 | 2007 Bajaj Pulsar 150

Not finding what you are looking for?
2005 Bajaj Pulsar 150 Logo

Related Topics:

87 people viewed this question

Ask a Question

Usually answered in minutes!

Top Bajaj Experts

sachin sharma
sachin sharma

Level 2 Expert

171 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

Are you a Bajaj Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...