Question about Lifan Knight 125 Motorcycles

Open Question

Lifan 125 starts then cuts out - Knight 125 Lifan Motorcycles

Posted by Anonymous on


2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 224 Answers

SOURCE: iv just changed the throttle cable on my lifan 125...

throttle cable is either routed wrong or just hanging up or pinched somewhere when installed.

Posted on May 23, 2010


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How can I lower my Lifan 250 street and trail without buying a kit

Hi, Connie you can cut off 1 inch from the bottom of the front fork springs and fabricate rear shock lowering brackets finally you could remove some seat padding for more information about your question and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
ATV Connection
Lifan LF250 Owner Manual pdf
Lifan Motorcycle Owners Unite
Give me the dirt on the Chinese made Lifan bikes

Feb 13, 2017 | Lifan Motorcycles

1 Answer

My lifan 125cc losses power when I engage the gears

Hi, Cleopas and the usual suspects are:
1. Severely drained or faulty battery.
2. Faulty regulator/rectifier or high output coil.
3. Faulty power valve, solenoid or installation.
4. Clogged air filter or exhaust.
5. Cracked or incorrect float level.
6. Float needle is not seating.
7. Faulty reed valve.
For more information about your question please visit the website below. Good luck and have a nice day.

Nov 05, 2015 | Lifan Motorcycles

1 Answer

I have found 2 wires, white and yellow!!! Which wire do I connect to the coil pin to make it start ?

Hi, Leon for this situation I would call my local dealer or reputable shop's service/parts department and inquire about any possible quick fix or parts inquiry. If necessary transport your vehicle to the dealer or shop and have a professional technician take it for a test drive, if it is in running condition, and give you a written estimate of repairs and answer any specific questions you may have about your issue. For more information about your issue please visit the website below. Good luck and have a nice day.

Aug 23, 2015 | Lifan Motorcycles

1 Answer

Lifan 125 cc 4 stroke spark plug. Keeps fouling could the inner rotor kit cdi cause this

Not likely, sounds more like the wrong heat range plug, if the engine is not worn and pumping oil or you are running too rich a A/F ratio,

Sep 13, 2014 | Motorcycles

1 Answer

Sym shark 125 sc scooter petrol pouring out of the overflow pipe

Take bowl off carb,free float if stuck and check fuel inlet needle to see if it closing fuel when bowl full.blow into fuel inlet on carb opening and closing the float at the same time if it stops you blowing then it is working if not then you have found the will be one or the other. 50cc lifan aero on the road 999 pounds inclusive 3year warranty

Nov 13, 2013 | 2004 Sym Husky 125

1 Answer

Lifan 50cc scooter not starting. I replaced choke solenoid and cleaned the carb. Am getting spark and putting sight vacuum on on hose leading to gas tank valve does produce gas flow in hose attached to...

It requires three main things to start the scooter:--- 1)Gas. 2) Spark. 3) Cylinder compression.---------- Any of the one is not functioning right so scooter is not starting.------------ Its possible that gas is not flowing till the carb and that is causing the problem.Either gas valve is clogged or faulty.Or gas line is clogged or carb itself is dirty and gunked up inside and needs to be cleaned.--------- Click this link below and follow the troubleshooting :--- ----------- This will help.Thanks.Helpmech.

Aug 18, 2011 | Lifan Knight 125 Motorcycles

1 Answer

Iv just changed the throttle cable on my lifan 125 but now it redlines when i start it up what have i done wrong help plz

throttle cable is either routed wrong or just hanging up or pinched somewhere when installed.

May 20, 2010 | 2003 Suzuki RM 125

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lifan Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

guy dubeau

Level 2 Expert

299 Answers

Steve Luck
Steve Luck

Level 3 Expert

817 Answers

Are you a Lifan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides