Question about Motorcycles
2" lowering kit
Posted by Anonymous on
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Either the seals were not installed correctly or your tubes and sliders are excessively worn. Not changing the fork oil at recommended intervals will cause excessive wear. Overfilling the forks will cause leaks too.
Posted on Jun 04, 2009
SOURCE: I need a price for Front forks
You might be best servered by taking your list to your local HD dealer, or calling say a Dennis Kirk, ot J&P Cycles. As they can give you best prices on the package for the parts you need.
Posted on Oct 19, 2009
The fork oil is a very specific job needing a manual and a special tool, I don't want to insult anyones mechanical knowledge but if you have never done it before, best to take somewhere else. Engine oil on the other hand is easy, the drain tube to any softail is on the right side by where the frame meets the swing arm, has somekind of plug in it. Start and run bike for a little while, long enough to get it warm but not hot. Remove fill plug and then remove plug in drain line. Using a peice of cardboard or something put in between filter and frame , directing the oil to your drain pan instead of where ever it goes. Put 1 qt oil back in (after everything is reinstalled) start the bike and make sure the oil light goes out, when it does shut bike off and fill to the point that when it is standing upright you get a little oil on the tip of your finger, over filling may result in loss of oil cap from pressure (been there)
Posted on Feb 16, 2010
SOURCE: how do I replace lower
Hi, i would advise you to get a service manual, but seeingas you don't have one.
First take off the dust cover, then the dust shield under it.
Below that there should be a retaining ring that needs to be compressed to take it out of its groove in the lower section.
Then you should be able to slide the parts apart.
Just be aware that there are another four parts in there that will come out.
So don't forget how they go together.
And get a service manual, its all in there.
Posted on Feb 04, 2011
Tips for a great answer:
Nov 21, 2017 | 2011 Harley Davidson FLHTCU Ultra Classic...
May 26, 2016 | Harley Davidson FLHTCUI Electra Glide...
May 25, 2016 | Harley Davidson FLHTCUI Electra Glide...
Mar 08, 2014 | Harley Davidson FLSTF Fat boy Motorcycles
Apr 03, 2013 | Harley Davidson FXD Dyna Super Glide...
Jan 19, 2013 | 1983 Yamaha XJ 650
Jun 11, 2012 | 2004 Harley Davidson FLHRCI Road King...
Jun 29, 2011 | Harley Davidson FXR Super Glide...
Feb 19, 2011 | 2005 Harley Davidson FLHTC - FLHTCI...
Feb 21, 2018 | Eton Motorcycles
57 people viewed this question
Usually answered in minutes!