Question about 2006 kawasaki Vulcan 900 Classic LT
Check battery connections to see if they are tight and clean. also check to see if it is proper battery for it. if it is a older battery it might be getting weak and need replaced. some auto parts stores will check them for free for you.
Posted on Jan 09, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Check continuity at the kill switch? sidestand switch? Either could be malfunctioning. What does your manual tell you about the starter relay circuit?
Posted on Jul 20, 2009
SOURCE: 1999 Vulcan 800 overheating
it sounds like a head gasket has blowen out on you or its running very week on fule that would cause it to run hot but to boile up like you sead it did that bothers me a bit?
did you fit a new thermostat as soon as you found out it was over heating? if you have cooked the engine you may have damaged the pistom rings as well,, get a compreshion test done on it to find out,
dont ride the bike till you have sorted it out
Posted on Nov 05, 2009
Using a lighter viscosity engine oil can make all the difference. Try something on the order of a 5W-30 for ambient temperatures of 60F or below. Of course, it could also be that your starter solenoid is in the early stages of failure. You can easily check it by using a large screwdriver to bridge the two large cable connections on the top of the solenoid. If the starter spins when you do this, then the solenoid is bad.
Posted on Dec 07, 2009
possible reg/rec issue or the stator....if you have a multi meter you can check the stator by unplugging and hooking up to the stator (component side), set multi meter to volts a/c and connect each plug for voltage. then do a residence test on the stator.
reg/rec issue, make sure you have proper ground, do a diode test to make sure that it is d/c and not a/c
Posted on Dec 27, 2009
under the seat there is a reset button that taked a metal prong thingie (dont know whent it's called) you can use a paper clip - just jump the two terminals and try to start it,, doesnt happen all the time but it does happen.
Posted on Jul 23, 2010
Tips for a great answer:
Nov 22, 2016 | 1998 kawasaki VN 1500 Vulcan Classic
Feb 03, 2012 | 2007 kawasaki Vulcan 900 Classic
May 28, 2011 | 2001 Honda CBR 929 RR Fireblade
Jan 29, 2011 | 2006 Honda VFR 800 ABS
Jun 16, 2010 | 2005 kawasaki VN 750 Vulcan
Dec 07, 2009 | 2001 Buick Regal
Apr 28, 2009 | 2006 kawasaki ZX-6R
Jan 25, 2009 | 2003 Chevrolet Blazer
115 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: