Re: battery removel for a 2004 suzuki 800 intruder
The battery is under the bike, bottom of box hinges down, just in front of rear wheel.
pain in the ***
some recomend parking bike wheels and kickstand on board for better access.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The rectifier on a 2001 Suzuki Intruder 800 is typically located near the battery, under the seat. It is usually attached to a bracket or secured with screws to the motorcycle's frame.
To locate the rectifier, you may need to remove the seat and possibly the side panels. Once you have access to the battery, follow the wires that are connected to it. The rectifier should be mounted nearby and have wires connected to it as well.
If you're having trouble locating the rectifier or need further assistance, I would recommend referring to the motorcycle's owner's manual or consulting with a qualified motorcycle mechanic.
there are 2 bolts under the front area of the forward seat each side remove the 2 bolts lift the seat and forward to remove,then you will see 2 more bolts for the rear seat remove them slide the seat forward and remove it.
It is not under the seat! It is under the engine,and it is kinda a pain in the *** to get to..altho,most batteries on bikes are located under the seat,the suzuki intruder is not!
I know for the models till 2002 where the battery is located in front of the rear wheel.
Place the bike on her side stand
remove the negative battery lead at the left side, just below the transmission tube ( cone ) 10mm socket wrench
On the right side remove the security cap on the positive lead ( cross screwdriver ), then remove the positive lead.
The battery is hold in place with a 'floor plate'. remove both bolts of the floorplate ( on each side ) while holding the palte into place.
gently lower the plate and the battery.
Hi ...... Find where the battery is, under the seat or behind a side panel. Disconnect the black (negative lead usually with a 10mm spanner then disconect the red (positive) lead. The battery will be held in place with a 'rubber' strap or a bracket and depending on type of battery there may be a vent hose from the battery to the lower half of the bike, this just pulls off and remains in place until you replace the battery. Installation is reverse except you connect red (positive) first.
Let us know how you get on.
×