An expert who has achieved level 2 by getting 100 points
An expert that got 5 achievements.
An expert whose answer got voted for 20 times.
An expert who has written 20 answers of more than 400 characters.
Re: battery removel for a 2004 suzuki 800 intruder
I know for the models till 2002 where the battery is located in front of the rear wheel.
Place the bike on her side stand
remove the negative battery lead at the left side, just below the transmission tube ( cone ) 10mm socket wrench
On the right side remove the security cap on the positive lead ( cross screwdriver ), then remove the positive lead.
The battery is hold in place with a 'floor plate'. remove both bolts of the floorplate ( on each side ) while holding the palte into place.
gently lower the plate and the battery.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
there are 2 bolts under the front area of the forward seat each side remove the 2 bolts lift the seat and forward to remove,then you will see 2 more bolts for the rear seat remove them slide the seat forward and remove it.
I take it you have removed the rear bolt holing the rear of the rear seat to the body of the bike. The rear seat is then pulled rearwards and out of the rear hold on strap The rear passenger hold on strap is then unbolted from the body of the bike. This will let the front seat by pulled rearward and then upwards to remove it as well. hope this helps.
Hi ...... Find where the battery is, under the seat or behind a side panel. Disconnect the black (negative lead usually with a 10mm spanner then disconect the red (positive) lead. The battery will be held in place with a 'rubber' strap or a bracket and depending on type of battery there may be a vent hose from the battery to the lower half of the bike, this just pulls off and remains in place until you replace the battery. Installation is reverse except you connect red (positive) first.
Let us know how you get on.