Question about 2009 Daelim Roadwin R 125 FI
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: engine cuts out when hot
This is usally caused by one of two problems. Most often the valves are not gapped right, which can happen as bikes age and go through repeated heating and cooling.
Another fairly common issue is that the carburetor mixture valve could be set wrong, and either running too rich or too lean, which makes the stalling "less noticeable" (read: doesn't happen) until the bike gets warmed up.
Hope that helps. Best of luck! :-D
Posted on Jul 15, 2009
Sounds like the starter silanoid went bad. Take a screw driver and find the starter silanoid witch is uselly by the battery. It has the + cable coming from the battery to it and is bolted to it and then the other bolt has a cable going to the starter. Take the screw driver and touch the 2 bolts at the same time and the starter should turn the motor over. Make shure the bike is not in gear before you do this. Good Luck
Posted on Sep 28, 2009
<CLEANING BATTERY TERMINALS>
??If you remove two screws from battery
box cover after putting floor panel met
forward, you will find battery assembled.
??If the battery terminal is polluted, or in
rust, separate battery and clean it.
??Battery terminal in rust with white
powder should be cleaned with warm
??In case of serious rust of battery terminal,
disassemble the battery cord and
grind it with wirebrush or sandpaper.
<REPLENISHING BATTERY WATER>
??This vehicle doesn’t need either
replenishing or checking battery water
because of the equipment of enclosed
??In case battery needs a checking, it
should be cared of by service center.
??Turn the ignition switch OFF
before disconnecting the terminal
from the battery. Remove the
negative pole ?? side cord first and
the positive pole ?? side cord next.
Make sure, at this time, that ??
side cord is connected first,
followed by ?? side cord.
??When handling the battery stay
away from flammable materials.
??Make sure that terminals do not
contact with other adjacent parts
when handling ??/?? terminal.
Contact with other parts may cause
spark resulting in electrical equipment
malfunction, fire and electric
??Frequent cell starting can shorten
the battery lifetime. Please use a
kick to start the engine after the
long period storage and in case of
the initial starting and the cold
starting to improve starting
performance and extend the battery
??Be careful not to disassemble injection
part of enclosed battery.
??When not using vehicle during a
long time, take off the battery from
the vehicle to keep from selfdischarge
and electric discharge.
Put the battery in a well ventilated
place after charging fully. In case it
isn’t available to take battery off
from the vehicle, disconnect “-”
Posted on Apr 17, 2010
Tips for a great answer:
Jan 07, 2017 | 2008 Daelim Roadwin R 125 FI
Jun 08, 2016 | Daelim Motorcycles
Feb 03, 2016 | Daelim Motorcycles
Jan 06, 2016 | Daelim Motorcycles
Dec 23, 2015 | Daelim Motorcycles
Dec 03, 2013 | 2008 Daelim Roadwin R 125 FI
Feb 12, 2012 | 2009 Daelim Roadwin R 125 FI
Mar 29, 2017 | Daelim Roadwin Motorcycles
Jul 28, 2010 | 2005 Daelim Roadwin
Oct 08, 2009 | 2004 Daelim Roadwin
66 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: