Question about kawasaki Motorcycles

Open Question

Er5 fuel tap repair - kawasaki Motorcycles

Posted by Anonymous on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: fuel tap leaks on ER5

Time for overhaul of the petcock (FUEL TAP).
you will have to get the petcock kit and replace it.

Posted on Apr 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What does the error code ER5 for a EDW154E Eurotech D/W mean?


e5 error is drain error. need to check all drain related items.
drain pump, drain hose, and of course garbage disposal knock out.

Jun 06, 2014 | EuroTech 24 in. EDW154E Built-in...

2 Answers

ER5 runs fine for 1 minutes, then mis-fires, revs drop and eventually stops. Have changed reg/rec. I have read of a resistor under the ignition switch, but find no mention of it in the manuals. Have...


Does the unit stay running with the choke on all the way? If it does, check the fuel filter for being clogged. You can use a spark checker and check for spark, but it sounds like to me you have plenty of spark expecially if it runs for 1 min or so. Sounds like to me, more of a fuel issue then spark problem. But anything is posible. Good luck and i hope this helps you out some.. HDTV GURU JAY

Mar 30, 2011 | 1997 kawasaki ER-5

1 Answer

Fuel tap leaks on ER5


Time for overhaul of the petcock (FUEL TAP).
you will have to get the petcock kit and replace it.

Apr 06, 2010 | 1998 kawasaki ER-5

1 Answer

How do I derestrict my 2006 Kawasaki ER5 please?


I assume it has been restricted to 33bhp for use on an A1 license?

If so it will either have been done through the ECU if your bike is fuel injected. Or (more likely) it is carbs then there will be large washers inside the inlet rubbers restricting the bore of the carbs. If you take the carbs off and pull these out you'll have access to your bikes full potential.

Regards

Chris

Nov 06, 2009 | 2006 kawasaki ER-5

1 Answer

I have just bought an 03 Kawasaki 500 ER5 it has a noise from thn


Best would be to examine tht noise, put your bike on the center stand and get an assistant to sit on it so tht the front wheel is thn free to rotate.
Rotate the wheel and try to locate the noise...not bad if you start at the brake pads!
Hope this helps!

Oct 31, 2009 | 2006 kawasaki ER-5

1 Answer

Tapping noice when the truck is running its sounds like tap,tap,tap,tap,tap,tap


It could be a bent valve, push-rod/s, piston slap, connecting rod bearings,bad fuel, timing, could need a tune-up,knock sensor, bad fuel, or water in fuel. You can start by looking at the vehicles repair/maintenance history, preform a dry and wet compression test,and take it from there. If I can be any more help let me know, thank you.

May 31, 2009 | 1992 GMC Sonoma

2 Answers

Can't remove rear brake panel and shoes from brake drum on ER5.


if the rear shoes have jammed the way i normally fix this problem is to undo and remove the arm so you are left with the spline sticking out. then knock this in carefully and it should release the shoes and you should be able to remove the hub.

May 05, 2009 | 1997 kawasaki ER-5

2 Answers

My rev counter does not work on my kawasaki er5 1999


The ER5 has got an electronic rev-counter, no cable.

Like the oval rear brake-drums this is another ER5 bugbear, the rec/rec fails, the battery boils and the rev-counter is usually a victim too.
Often on ER5 specific forums there will be someone who repairs the circuit board and sells the repaired units much cheaper than a new one. it's usually a tiny zener-diode that is killed.

May 04, 2009 | 1999 kawasaki ER-5

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

81 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...