Question about 2004 Skyteam ST 125 Y

1 Answer

Clutch sticking - 2004 Skyteam ST 125 Y

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 157 Answers

I am assuming that the cable is adjusted properly. It should have +-5mm of freeplay at the lever when pulled. If the unit has been sitting this is not uncommon due to the plates sticking together from rust from condensation moisture inside the engine. especially in a humid enviornment. You can try riding the bike in first gear with the clutch pulled in snap the throttle open and closed quickly and repeatedly to attempt to break the plates free. Be care full and attempt in an open area where there is plenty of room. It can be a wild ride. If this does not work the clutch will need to be dissassembled, cleaned and reassembled as necessary. Also will need an oil change.

Posted on Jan 05, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Zundapp bella scooter clutch problem


If it is a cable operated clutch, maybe the inner cable is sticking to the outer cable so replace or oil down it. If a hydraulic clutch, maybe the rod that is pushed in by the slave cylinder is sticking as these get covered in road grime being low down on the bike.

Oct 01, 2014 | Motorcycles

1 Answer

Clutch pedal sticks and trouble shifting


It happen twice to me ,spring come out from clutch disk and jam the pressure plate, check transmission shift very well with engine stopped, When you push the pedal you push the spring and put pressure on the disk

Mar 30, 2014 | 1999 Chevrolet Camaro

1 Answer

My clutch in my 95' mitsubishi mirage is sticking suddenly. do i need a new clutch or could it be my fluid?


could be the fluid. if the clutch was worn out it would be doing the opposite of sticking. is the clutch pedal easier to push than normally?

Dec 04, 2010 | 1995 Mitsubishi Mirage

1 Answer

1998 Saturn SC1 manuel stick is hard to shift into 1st & 2nd gear


Try to double clutch the clutch pedal. How to double clutch; push the clutch in moving the stick to neutral, then release the clutch and then push it back in and shift into first or second gear. If it works then it is not the shift linkage and could be a clutch adjustment. First how far do you have to release the clutch pedal until the clutch plate starts to engage? If only an inch or so the clutch pedal needs to be adjusted, which is an easy fix (this is more common). The other possible problems could be the clutch plate, throwout bearing of syncros could be bad. If it is one of the previous problems double clutching should buy you some time.

Jul 01, 2010 | 1998 Saturn SC

1 Answer

Clutch is sticking


is it hydraulic.? or cable.. the clutch , if it is cable replace it

Apr 26, 2010 | 1996 Saab 900

1 Answer

Clutch sticking/not releasing/engaging


Is it sticking to the floor? releasing/engaging?

If its not releasing the clutch...[Car will try to move when starting with car in gear]
If so check the fluid. this is a hydraulic clutch,
If fluid is gone check for a leak or a bad Clutch Master Cylinder

If its not engaging then the Clutch maybe bad.

Nov 26, 2009 | 1999 Kia Sportage

1 Answer

Clutch sticks when pushed to floor


a clutch pedal that doesn't return back to you is sometimes a symptom of a failing clutch slave or general fluid leak. This is of course referring to a hydraulic clutch. If your fluid gets too low or there is an air leak your pedal will stick to the floor and not return.

Oct 26, 2009 | 1994 BMW 3 Series

1 Answer

Manual clutch


If it is a brand new clutch, it's not broken in yet, which is why it "sticks". Give it some time, though, and it will stop "sticking". It took a half mile of stop and go traffic for mine to stop doing that with my new performance clutch.

Jun 21, 2008 | 1991 Toyota Previa

Not finding what you are looking for?
2004 Skyteam ST 125 Y Logo

86 people viewed this question

Ask a Question

Usually answered in minutes!

Top Skyteam Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Gregg Mahin
Gregg Mahin

Level 3 Expert

40859 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Are you a Skyteam Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...