Question about Znen Motorcycles

Open Question

Were is the restrictor on a znen Q retro 50cc scooter please

I recently bought a znen Q retro 50cc scooter and im trying to find out were the speed restrictor is on this bike if anybody had this problem and solved it please E- MAIL me at freechalky@yahoo.co.uk thanks

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 34 Answers

SOURCE: repairing a sym euro jet x 50cc scooter all aspects

Hello
Is it a GY6 Motor?
Go to www.scootdawg.com this forum should have wat you need also www.scooterrebels.com as well
Best Reguards

Larry

Posted on Jan 11, 2010

Ad
  • 1 Answer

SOURCE: Direct bikes scooter wont start

have dafier qt 50 starts first time on kick start,do a run about 10 miles runs ok, turn of motor, then it is very hard start.

Posted on Jan 25, 2010

  • 141 Answers

SOURCE: 50cc scooter lack of power from 0 to 10mph

Fuel mixture is too rich. The easiest way I adjust those is to have a friend stand in front of the scooter, holding the wheel and handlebars still while I lightly hit the throttle and at the same time, adjusting the fuel mixture screw on the carburetor slightly. applying the throttle harder while adjusting, you should feel the scooter gain or lose power.

Posted on Mar 01, 2010

nedkelly900
  • 345 Answers

SOURCE: Znen Scooter Headlight keeps burning out!!!!

sounds like you have too much voltage coming out from your battery, mabey a faulty regulator. The easiest way to test this, is to get a multi - meter, and check the volage output at the battery, with the engine running, at idle should read about 12.5 - 13 volts. Then rev the bike up, and seeif the reading changes, it should not go more than 13.8 or 14 volts max. If it does, then i say you have a faulty regulator/ rectifier.

Posted on May 03, 2010

  • 3567 Answers

SOURCE: I just bought my 50cc

You don't " get a cylinder cleaned ". Who ever says that doesn't know what he is talking about. I assume the engine is a two stroke. The gas/oil mixture should be 32 to1. That means 4 ounces of two stroke engine oil to one gallon of gas. If the scooter has an automatic oil pump be sure there is oil in the oil tank. It should automaticly pump the engine oil at the proper rate. If this is an older scooter, you could remove the cylinder head and de-carbon it and then check the exhaust port to be sure the port has not been made smaller due to carbon build up. The port should be about 1/2" tall and 1" wide. Also check and clean the air filter. If it is a new scooter is it still under warranty?

Posted on Aug 13, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2014 TaoTao ATM 50 fuel and vacuum line routing


Hi, Tammy for this scenario you will need your service, parts fiche, and owners manual if you can't find the best tool you ever bought for your Honda, despair not, for a mere zero $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need for viewing and printing please click on the blue links below. Good luck and have a wonderful day.
Fuel and Vac Line Tutorial
How to simplify vacuum hoses on scooter
http://www.family-motorsports.net/GY6-50cc-150cc.pdf
Dirt Bike Dirt Bikes ATV ATVs Moped Mopeds Dirt Bike Part ATV Part Parts...
TaoTao ATM50 A1 Owner Manual

Jul 25, 2017 | Motorcycles

1 Answer

Where can I get a Znen scooter manual for a 2008 250cc scooter


Hi type in Google search. ::::: (PDF) Znen es150 manual in PDF.,..,,,.there r a few pages that might help ... Cheers

Nov 12, 2016 | Health & Beauty

1 Answer

Chinese scooter yy50ccqt-6 cutting in and out at high throttle


Hi, Michael for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Johnway, despair not, for a mere $0 you can download another one I could only find one similar but has the same engine. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
scooter bogs down when throttle it Scooter Doc Forum
Bike cutting out at Full Throttle 50cc Scooter
http://www.extremescooters.biz/manuals/gy6_service_manual.pdf
http://www.carlsalter.com/pdfs/Jonway%20YY50QT-6.pdf

Jun 30, 2016 | Motorcycles

1 Answer

2008 150cc Znen scooter. What causes it to bog down at 55-60 mph?


Hi, Ty and the usual suspects are:
1. Spark plugs in bad condition or partially fouled.
2. Spark plug cables in bad condition or leaking.
3. Spark plug gap too close or too wide.
4. Faulty ignition coil, module and or sensor.
5. Battery nearly discharged.
6. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
7. Intermittent short circuit due to damaged wire insulation.
8. Water or dirt in the fuel system, carburetor or filter.
9. Fuel tank vent system plugged or carburetor vent line closed off.
10. Carburetor controls misadjusted.
11. Damaged carburetor or intake seals.
12. Loose or dirty ignition module connector at crankcase.
13. Faulty MAP, CKP, O2, and or CMP sensors.
14. Incorrect valve timing.
15. Weak or broken valve springs.
16. Damage intake or exhaust valve.
For more information about your issue and valuable "FREE" downloads that you will need please visit the websites below. Good luck and have a nice day.
Headlights melting Engine bogging down
Yahoo Groups
SportiqueScooters com Scooter Buyers Primer http://www.carlsalter.com/pdfs/Znen_ZN250T_D.pdf
Gy6 50cc 150cc Scooter Repair service Manual Download Manuals Technical

Mar 06, 2016 | Znen Motorcycles

1 Answer

Hi, anyone know what the factory carb settings are for an aeon mini kolt 50cc. Having problems with getting it started, changed spark plug and battery


Two-Stroke Scooter / ATV Carburetor Settings And ...

? 4:37
https://www.youtube.com/watch?v=A1vRMERs4RQ
Jun 2, 2012 - Uploaded by 90GTVert
Part 2 of a 4 part video detailing all of the basic settings and ... Two-Stroke Scooter / ATV Carburetor Settings ...

Fix your Mini bike Carb - bogging, cutting out etc - YouTube

? 4:51
https://www.youtube.com/watch?v=lbtDMFUiD0k
Aug 15, 2011 - Uploaded by Cpt MishMash VonRandom
If you are having trouble with your mini bike/quad whereby its difficult to ... Two-Stroke Scooter / ATV ...

quad 50cc carb Questions & Answers - Fixya

www.fixya.com > Forum > Tags
50cc carb wondering what the factory setting is for a 2002 50cc Kawasaki kid's ...aeon mini kolt 50cc quad will rev a little then cuts out no power Likely a lean ...

Aeon mini kolt 50cc quad will rev a little then cuts out no ...




Jan 05, 2016 | Factory Motorcycles

2 Answers

Direct bikes scooter wont start


you need to have some fuel in the system over night as when it is shipped it is completly dry when this is done it should start with out any problems if it still has the same problem then you will need to charge the battrie

Nov 02, 2009 | 2004 Factory bike Chrono SM 250

1 Answer

Engines dies when going up hill


It isn't a fuel problem, it is a power problem. Any bike will slow down on a hill. The bigger the engine, the more power is available to maintain speed. 50cc just isn't much power to pull a 150 pound man up a hill.

I am assuming the scooter has a two stroke engine. If it is a four stroke the valves may be needing attention. But even with good valves, 50cc just isn't a powerhouse of an engine. If you want to be happy, trade the scooter in on something 125cc to 200cc. You will feel better about your ride and be more respected on the roadway.

May 02, 2009 | Peugeot 405 Cars & Trucks

1 Answer

Speed limiter! TAZ


Yes it does work..its about a 20c solution from Dick Smith. Shame on you for wanting to go that fast. Email me at yourbusted2@hotmail.com for the personĀ“s details who has done this successfully. Im intending to buy one myself and will do the same. Im told a new can, mod air intake and speed restrictor out changes the bikes power quite effectively to start with.

Nov 10, 2008 | 2001 Suzuki GS 1200 SS

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

123 people viewed this question

Ask a Question

Usually answered in minutes!

Top Znen Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4525 Answers

yadayada
yadayada

Level 3 Expert

76164 Answers

kakima

Level 3 Expert

102366 Answers

Are you a Znen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...