Question about 2008 kawasaki Ninja 250R

1 Answer

2007 kawasaki ninja 250 my 2 exhaust pipes get red

This bike has only 800 hundred miles i clean the carburetor . its runs good but the exhaust pipes get red

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,669 Answers

That's why sensible people put exhaust pipe shields over their pipes. Buy some soon or burn yourself!

Posted on Jan 05, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2006 Kawasaki Ninja 250 will not start

check the kill switch and side stand interlocks betcha one is sticking

Posted on Mar 10, 2009

Benimur
  • 6966 Answers

SOURCE: 2002 kawasaki ninja ex 250,engine dies after clutch is released

Hi and welcome to FixYa,

For some reason, the problem is incomplete...

  • "2002 kawasaki ninja ex 250,engine dies after..."
If the problem is, idle and revs good while in neutral but shuts down when gear is engaged, then it would most likely be the sidestand switch. Try to check, clean, bypass or replace.

Otherwise, postback to clarify and/or describe fully.

Good luck and thank you for using FixYa.

Posted on Apr 25, 2009

zeild01
  • 2 Answers

SOURCE: 89 kawasaki ninja 250 crank no start

ok i have one and i just fixed mine you need to drain the fuel from bottom of carbs and drain the tank also. then replace the spark plugs once you do that add new fuel in tank and drain the carbs again unitil good fule start runing out then shut them off. aftre that make sure there are two line connected to the petcock from the carb. spray soem starting fluid in the air box and chock it boom it will start. if it has spark.

chris

Posted on Jul 15, 2009

  • 149 Answers

SOURCE: how to remove front fairing 250 kawasaki ninja

there are small allen bolts or lock screws.. take them out and it should just come off

Posted on Aug 30, 2009

  • 47 Answers

SOURCE: I have a 2010 Kawasaki Ninja 250 and looking at

The exhaust is about all you can do and a K&N air filter. Those 250's are tweek pretty much to the limit from the factory.

Posted on Mar 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Oil leak on kawasaki 250 stockman cant seam to find it


Hi, Bob due to the magnitude of yesterday's solar flare my night and x-ray vision optical devices have become inoperable so you will have to be my eyes, to find the source of your oil leak, start at the point where you see oil and trace its path going up and forward, if there is too much oil present then buy a spray can of engine degreaser apply it to the affected area then rinse off with a pressure wand or garden hose, use compressed air to blow off excess water or just let it drip dry, take your bike for a 5 mile ride and check for the leaks. For more information about your issue please click on the blue links below. Good luck and have a wonderful day.
ninja 250 oil leak
Oil Leak Kawasaki Ninja 250r Kick Stand Front Sprocket
2000 2001 2002 2008 Kawasaki KL250 KL 250 STOCKMAN Shop Service Repair...
OEM Parts for Kawasaki
Owner Service Manual Kawasaki Vehicle Manuals

Jan 31, 2017 | kawasaki Motorcycles

1 Answer

On my 2003 ninja 250 the only way it starts most of the time is full choke, after the bike is warm I lower the choke and it does....the I have to let it set for a few minutes to restart it,


Hi, Pirate and the usual suspects are:

1. Fuel cap or fuel tank is not venting properly.

2. Fuel filter clogged.

3. Fuel line pinched or kinked.

4. Float needle and seat sticking.

5. Float level too low.

6. Carburetor bowl vent line clogged/blocked/pinched.

7. Idle adjusting screw set too low.

8. Air/fuel mixture screw set too lean.

9. Idle port, transfer ports, slow air jet clogged.

10. Slow fuel jet clogged.

For more information about your issue and valuable free downloads that you will need please visit the websites below. Good luck and have a nice day.

05 250 only runs with choke fully engaged

Ninja 250r Wont Rev or run without choke ninjette org

http://mototh.com/files/kawasaki/Ninja_250R/Kawasaki_Ninja_250R_FI-English.pdf

OEM Parts for Kawasaki

Mar 01, 2016 | Motorcycles

1 Answer

2005 Kawasaki Ninja 250 I bought it as a project So the guy who had it drop it at a construction zone and broke all the plastices He had the bike sitting in the backYard for 5 years it only has 2,423 miles...


If you over filled the motor that much and you got it into all the components you say, then it's probably going to smoke for a while longer. You probably have motor oil in the exhaust. That's probably what you're seeing. If it doesn't stop after running it a couple of times maybe a couple of test rides then I would do a compression check just to make sure. Then a leak down test to make sure the rings are ok. I would run it for a while first. That amount of oil will take a bit to burn off.

Nov 01, 2013 | Motorcycles

1 Answer

2002 ninja 250 idels good runs bad with no power band and sounds like its running on two cylinders but both exhaust pipes get hot,it just doesnt sound like a ninja should,i put new plugs with no change


The power band on a 2002 Ninja 250 does not kick in till you hit about 5000 RPM. The newer 2008 and up 250's kick in about 3000 RPM. There is a website devoted to the Ninja 250 that might give your more background into the motorcycle: ninjette.org You may want to replace your spark plug caps they may be robbing of the spark you need at take off. They simply unscrew off of the end of the wires. They should read 5000 OHM's no higher , no lower. If you purchase new NGK brand plug caps they will only cost about $5 each.

Jun 05, 2011 | 2008 kawasaki Ninja 250R

2 Answers

1995 Kawasaki Ninja 250 will only run with the choke on


you have blocked jets in the carbs,,the carbs need to be removed and cleaned.

Mar 20, 2011 | 1995 kawasaki ZX-9R Ninja

1 Answer

I just bought a ninja 250 2007. it is leaking fuel out the tube. is the choke stuck open. or what Thanks


<P>The fuel seems to be leaking from the over flow pipe.</P><P>Time for resetting the float level and inspecting and attending to the float pin too and the inflow barrel.</P><P>Please go thro this site it will give you&nbsp;some&nbsp;idea to the float chamber and all tho the site is not for a kawasaki carburator but the basics are kinda the same.</P><P><A href="http://ezinearticles.com/?How-to-Clean-a-Motorcycle-Carburetor,-The-Right-Way&amp;id=1460030">http://ezinearticles.com/?How-to-Clean-a-Motorcycle-Carburetor,-The-Right-Way&amp;id=1460030</A></P><P>&nbsp;</P><P>Hope this helps!</P>

Aug 28, 2010 | kawasaki Ninja 250R Motorcycles

1 Answer

03 GSXR wont rev past 6200...


cyclepedia.com/kawasaki-ex250-ninja-250-online-service-guide/
ebookoo.net/the-kawasaki-ninja-250-faq.html

i feel the above links may be useful for you

Jul 22, 2009 | 1998 Suzuki GSX-R 750 W

Not finding what you are looking for?
2008 kawasaki Ninja 250R Logo

181 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75005 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...