Question about 2001 Harley Davidson FXDL Dyna Low Rider

1 Answer

Where do i tie in the switches when im putting in 18" apes on a 99 dyna lowrider

Posted by on

  • jim bob Jan 06, 2013

    I need to know where to wire in the electical switches thx

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Harley Davidson Master
  • 39,945 Answers

Posted on Jun 11, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 15 Answers

SOURCE: how do i drain my 2005 dyna lowrider's brake fluid back resevoir.

Bleed the brake system adding new fluid until the new fluid comes out in to your bleeding bottle you just changed it.

Posted on Apr 09, 2010

wd4ity
  • 4565 Answers

SOURCE: 2008 dyna lowrider run switch will not activate,

"The two small hydo lines entering it seem to be loose and spring loaded turn screw is also loose"

I think you're referring to the two throttle cables and the throttle lock screw on the bottom of the throttle mechanism.

The "run/stop" switch is located inside the switch housing on the throttle side. It has three wires running to it. If the switch does not work, it may be defective.

To replace the switch, you must remove the two bolt that hold the switch halves together. Carefully seperate the two halves. the "Run/Stop" switch is in the front half of the switch housing. The switch is held in by a couple of small screws. Remove the switch and unsolder the wires taking note of which wire goes where. Resolder the wires to a new switch and install the switch in the housing. Reassemble housing keeping it positioned up firmly against the front brake master cylinder. Check the throttle for proper operation prior to starting the engine.

Posted on Apr 09, 2010

wd4ity
  • 4565 Answers

SOURCE: where is the drain plug on a 2004 dyna lowrider?

The oil tank is on the bottom of the transmission. Two drain plugs. The center one is the transmission drain, the one towards the front on the left side is engine oil drain.

Posted on May 22, 2010

wd4ity
  • 4565 Answers

SOURCE: im putting 18 inch apes on my 2000 model 883 and i

Go ahead and change out your bars. Then use stiff wire to "fabricate" the cable from your clutch lever back to the derby cover. Do the same with the cables for your carb. Then go to this site to order your cables. http://www.barnettclutches.com/products/custom_measuring_guide.aspx While you're waiting on your custom cables to arrive, you can lenghten your brake line and wiring harnesses.

Ride Safe.
Steve

Posted on Jan 03, 2011

wd4ity
  • 4565 Answers

SOURCE: i put ape hangers

I can send you a schematic if you'll contact me directly at wd4ity@bellsouth.net . Please remind me of what you need.

Steve

Posted on Jun 12, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does my 2001 harley dyna lowrider have no power to the ignition side of the switch?


it could be a fuse or a break in the cable ,check with a multi meter from battery to the switch and all the connecters cheers

May 21, 2014 | 2002 Harley Davidson FXDL Dyna Low Rider

1 Answer

Will a sound system work on a 2002 lowrider


I don't have a schematic in front of me, but you can determine which terminal is hot on the switch when in the "ON" position by using a DVOM multimeter. In addition to the sound system needing to be hooked up to the accessory, it must also be hooked to the hot side of the switch when the ignition is on. If all else fails you should contact the manufacturer.

Mar 23, 2012 | 2002 Harley Davidson FXDL Dyna Low Rider

1 Answer

"1997 dyna lowrider 80cubic inch


Check for air leaks around intake w/ wd-40 spray if leak rpms increase..or also check accelerator pump is shooting work throttle should see a stream of gas in venturi..

Sep 18, 2011 | Harley Davidson FXDL Dyna Low Rider...

1 Answer

Where is the drain plug on a 2004 dyna lowrider?


The oil tank is on the bottom of the transmission. Two drain plugs. The center one is the transmission drain, the one towards the front on the left side is engine oil drain.

May 22, 2010 | 2004 Harley Davidson FXDL - FXDLI Dyna Low...

1 Answer

2008 dyna lowrider run switch will not activate,


"The two small hydo lines entering it seem to be loose and spring loaded turn screw is also loose"

I think you're referring to the two throttle cables and the throttle lock screw on the bottom of the throttle mechanism.

The "run/stop" switch is located inside the switch housing on the throttle side. It has three wires running to it. If the switch does not work, it may be defective.

To replace the switch, you must remove the two bolt that hold the switch halves together. Carefully seperate the two halves. the "Run/Stop" switch is in the front half of the switch housing. The switch is held in by a couple of small screws. Remove the switch and unsolder the wires taking note of which wire goes where. Resolder the wires to a new switch and install the switch in the housing. Reassemble housing keeping it positioned up firmly against the front brake master cylinder. Check the throttle for proper operation prior to starting the engine.

Apr 09, 2010 | 2003 Harley Davidson FXDL Dyna Low Rider

1 Answer

How do i drain my 2005 dyna lowrider's brake fluid back resevoir.


Bleed the brake system adding new fluid until the new fluid comes out in to your bleeding bottle you just changed it.

Apr 09, 2010 | 2005 Harley Davidson FXDL - FXDLI Dyna Low...

1 Answer

Is it possible to switch out the handlebars on my Dyna FXD w/o having to deal w/ wiring?


Depends.u have about 3 or 4 inches of play......if your gonna switch to ape hangers ,there will be alot of wiring to do ....... if the dimensions are close to what u got .......then it wont be required

Aug 06, 2009 | 2003 Harley Davidson FXD Dyna Super Glide

Not finding what you are looking for?
2001 Harley Davidson FXDL Dyna Low Rider Logo

Related Topics:

140 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Gills Lango

Level 2 Expert

195 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...